All rights reserved. Reprinting, including excerpts, not permitted without the express consent of ESERA GmbH.
Subject to technical changes. ESERA GmbH, 2023
www.esera.de 12002 V2.0 R1.1 configuration ETH Page 6 from 7
Save the settings via the "Save Setting" button. This completes the configuration of the module
9 OPERATING CONDITIONS
The module may only be operated at the voltages and under the ambient conditions specified for it. The operating
position of the device is arbitrary. The device is intended for use in dry and dust-free rooms. Do not operate the
module in an environment where flammable gases, vapors or dusts are or could be present.
If condensation forms, wait for an acclimatization period of at least 2 hours.
The modules may only be commissioned by a qualified electrician.
10 ASSEMBLY
The mounting location must be protected from moisture. The device may only be used in dry indoor areas.
The device is intended for mounting inside a control cabinet as a stationary device.
11 DISPOSAL NOTICE
Do not dispose of the device in household waste! Electronic devices are to be disposed of
according to
of the Directive on Waste Electrical and Electronic Equipment on the local
Collection points for electronic waste to dispose of!
12 SAFETY INSTRUCTIONS
When handling products that come into contact with electrical voltage, the applicable VDE regulations must be observed, in
particular VDE 0100, VDE 0550/0551, VDE 0700, VDE 0711 and VDE 0860.
•All termination and wiring work may only be carried out when the device is de-energized.
•Before opening a device, always disconnect the power plug or ensure that the device is de-energized.
•Components, assemblies or devices may only be put into operation if they have previously been installed in a
housing in such a way that they are safe to touch. They must be de-energized during installation.
•Tools may only be used on devices, components or assemblies if it has been ensured that the devices are
disconnected from the supply voltage and that electrical charges stored in the components located in the device
have been discharged beforehand.
•Live cables or lines to which the device, component or assembly is connected must always be inspected for
insulation faults or breaks.
•If a fault is detected in the supply line, the device must be taken out of operation immediately until the defective line
has been replaced.
•When using components or assemblies, attention must always be drawn to strict compliance with the characteristic
data for electrical variables specified in the associated description.
•If it is not clear for the non-commercial end user from an existing description which electrical characteristic values
apply to a component or an assembly, how external wiring is to be carried out or which external components or
additional devices may be connected and which connection values these external components may have, a qualified
electrician must be consulted.
•Before commissioning a device, it must generally be checked whether this device or the assembly is fundamentally
suitable for the application for which it is to be used.
•In case of doubt, it is essential to consult specialists, experts or the manufacturer of the assemblies used.
•We do not accept any liability for operating and connection errors that are beyond our control.
•Kits should be returned with a precise description of the fault and the associated assembly instructions without the
housing in the event of malfunction. Without error description a repair is not possible. We have to charge extra for
time-consuming assembly or disassembly of housings.
•It is essential that the relevant VDE regulations are observed during installations and when handling parts that will
later carry mains voltage.
•Devices that are operated at a voltage greater than 35 VDC/12mA may only be connected and commissioned by
qualified electricians.
•Commissioning may only be carried out if the circuit is installed in a housing so that it is safe to touch.
•If measurements are unavoidable with the housing open, a safety isolating transformer must be connected upstream
for safety reasons, or a suitable power supply unit must be used.
•After installation, the required test must be performed in accordance with DGUV Regulation 3.
