EROAD CoreHub Xtreme Manuel utilisateur
Parts and Equipment
Included with the CoreHub Xtreme Install Kit:
CoreHub Xtreme (the “unit”)
Trailer and reefer Smart harness
•
•
•
•
•
•
Remote Start Stop (RSS) switch
harness (optional)
External antenna
Bracket
Zip ties, screws
Required tools
10, 12, 13, 14, and 17 mm deep well sockets
and wrenches
Diagonal flush cutters
Impact driver and 5/16ths bit for self-tapping
screws
18/20ga butt splice crimping tool
Propane torch
Platform to reach the top of the reefer safely
•
•
•
Pre-prep
Start the reefer to ensure it’s working with no
console alarms.
Ensure the reefer has its DataTrak/CarrierShot
firmware updated and operating.
Use the Safety Lockout Procedure; disconnect
any AC power source and battery NEGATIVE
terminal.
A ladder is fine for heights up to 2 m (7
ft) but should not be considered safe
for reaching the top of a reefer. Where
possible, use a scissor-lift, forklift
basket or similar stable, load-bearing
platform.
•
•
•
Mount the unit
Attach the unit to a flat surface half-way up the
inside of the reefer, such as above the APX
Control System display.
Use the holes in the mounting bracket to mark
the drilling points on the reefer, attach the
bracket accordingly, and mount the unit.
Keep the unit and the cables away from hot or
moving parts and high voltage lines (usually
colored orange).
Bracket
APX
Advance
Vector 6500
Vector 8600
Mount the antenna
Attach the antenna to the top of the reefer or the
side front of the trailer. To function properly, it
must directly see the sky.
•
•
•
Plug the unit into the DataTrak
connector
Run the CoreHub Carrier harness cables to the
DataTrak connector by the APX display,
following the reefer frame or low-voltage lines
underneath. Do not zip-tie the harness to the
high-voltage (orange) power lines.
The main harness has connectors for reefer
data (Satcomm1), fuel sensor, and the J1
jumper and/or optional RSS switch.
Use the provided zip ties to space the cables.
Reefer data to CoreHub Xtreme
harness
Autres manuels pour CoreHub Xtreme
1
Table des matières
Autres manuels EROAD Accessoires automobiles
