5
If the water is eing treated for it to e used as drinking water, wait until the ozone has completely
disappeared from the water. This takes anywhere from five minutes to one hour depending on
water temperature, iron content and other factors. Water can e consumed as soon as the smell of
Ozone cannot e detected any more.
Comments
The EOD MINI EORG Generator works est in cold or cool water (less than 20°C).
The EOD MINI forms ROS and aqueous ozone. Generator does not work in water with very low
electrical conductivity. Therefore, the device should not e used with e.g. ion exchanged attery
water or water purified y reverse osmosis.
With the EOD MINI it is not possi le to “over enrich” the water, ut it is possi le that the enriching
does not reach the desired level for the intended purpose. If this happens, repeat the treatment of
water with the EOD MINI Generator.
Correct operation of the device can e visi ly o served as soon as the device is switched on whilst
su merged in clear water. Stream(s) of micro u les with a milky appearance will start to rise from
the electrolysis plates.
The water is quickly filled with micro u les, ecoming milky in appearance. When the device is
turned off, the micro u les immediately egin to dissolve into the water. The water is ready for
disinfection once most of the micro u les have dissolved (i.e. the water resumes a clear
appearance)
Examples and notes
For the preparation of sufficiently concentrated disinfectant in a water volume of five (5) liters (at
20oC room temperature), let the device run un-interrupted for twenty (20) minutes. In a water
volume of ten (10) liters, the corresponding operation time required is forty (40) minutes.
Continuous use of the EOD MINI ROS generator for longer than one hour (60 minutes) is not
recommended. In etween uses, allow the EOD MINI ROS generator as well as the current
transformer time to cool down, should they have ecome warm during the process.
NOTE: In Highly ondu tive waters (high TDS value) the devi e might be ome noti eably warm
NOTE: In waters with low ele tri al ondu tivity (low TDS value) the rea tion might not start. By adding a
tra e amount of mineral water into the mix, the rea tion should start.
NOTE: Never add any hemi als or other additives (apart from mineral water) into the water being
treated. This may result into unpredi ted hemi al ompounds be oming airborne and EOD Europe
a epts no liability of any harm to materials or persons due to this.
Storage of the devi e
When not in use, the device must e kept in a clean, dry, area or container. The apparatus must not e
exposed to temperatures outside + 60 °C and -20 °C. Allow the device to entirely dry out efore stowing it
away.
Maintenan e of ele trodes
Water typically contains a variety of minerals such as calcium car onate. These minerals accumulate slowly
onto the surfaces of the electrodes. Accumulation of the calcium may there y slow down the electrolysis
process. When the micro u le formation appears weak, clean the electrodes as identified elow
