Entrotec ELITE Manuel utilisateur

ELITE

INSTALLATION

MANUAL

REV 3

USING ENT07101 Rev 3 VER0113

PREMAN0113/VAT/1

Recommended Installation Procedures

for Entrotec Equipment.

The recommendations give below assume the use of CW1308 type cable and are made in conjunction

with reference to IEE Wiring Regulations 17th Edition 528-01 ‘Proximity to electrical services’ and

BS EN 61000-6-3:2007 & BS EN 50133-1.

Door entry & access control equipment are in ‘Band 1’ classification.

230v mains cables are in the ‘Band 2’ classification.

Other cable types can be used but the guidelines given below may or may not be relevant and other

installation procedures may need to be adapted.

All unprotected cable runs should be kept away from mains cables as the radiation from these cables

may cause the system to be erratic in operation.

In a building where the only way to wire is via an electrical intake, riser cupboard or lift shaft then metallic

trunking or conduit should be used unless there is sufficient room within the cupboards to distance

the door entry cables from the mains cables.

Mains cables should not be run in the same trunking/conduit as the door entry cables

(although segregated metallic compartment trunking is acceptable).

We recommend that where the cabling is not protected in a metallic containment system that a distance

of 1 Metre should be adopted unless other protective measures have been taken conforming to the

relevant industry regulations.

If unprotected cables are to run across mains cables then this should be at 90 degrees.

In accordance with IEE Wiring Regulations (17th Edition) please ensure that all metalwork is bonded to the

buildings earth, this includes the main control panel, all conduit (if metallic) and most importantly THE

EXTERNAL CALL PANELS, READERS & FIRE SWITCHES. A ring connector is provided in the external panels

for termination of the earth cable but this bonding is often ignored, please ensure that this connection is made.

If you have any queries about a particular site or are in need of technical assistance please

phone, fax or email Entrotec for technical help :-

Tel: 08448586370

Fax: 01506 886233

Email:

Vaughn Turner

System Engineering Manager

Issue 6. 14/01/2013

[email protected]

Warning!!! Rogue cable is prevalent. Please ensure cables are pure copper and not copper clad imitations

as their high resistance will cause system malfunction. These cables may have CCS, CCA, CCAM in their

description/part number and are definitely to be avoided as are unmarked outer sheaths. These cables are

available in CW1308, RG59, CAT5/6 and mains supply formats. Entrotec will not accept any responsibility

for systems wired with incorrect cable (i.e. not to specification).

Tests. To test for CCS (copper clad steel) use a magnet, if it attracts Do Not Use. To test for CCA (copper

clad aluminium) heat core with a lighter, if aluminium melts (as its melting point is much lower than copper)

Do Not Use. CCAM (copper clad magnesium) is not widely available at present but will burn using the heat

test.

PREMAN0113/VAT/2

Contents

System Overview and Specification. ...................................1

Cabling Requirements. ........................................................2

Overall Schematic. ..............................................................3

Typical Controller Layout. ....................................................4

Typical Installation Layout. ..................................................5

Handset Connections. .........................................................6

Video Schematic. ................................................................7

Preset Adjustments. ............................................................7

Programming the ‘On Board’ Service/Trades Time Clock. ..8

Handset Auxiliary Equipment Connections. ....................... 9

FS4/FS5/PTE/EPTE Wiring. .............................................. 10

Typical Wiring Schematics. ............................................11-12