CLEANING INSTRUCTIONS
1. LOCATING AND MARKING
2. BRACKET INSTALLATION
Select an appropriate location to install the accessory.
It is strongly advised to install the product on a solid base,
and the use of an electronic stud finder is recommended for
stud/nog installation. (Fig. 1)
NOTE: Refer to assembled accessory for bracket alignment and
orientation.
•For accessories with one bracket
Use a level to ensure the holes are aligned either horizontally or
vertically and that the bracket is correctly oriented with tapered
holes facing you (Fig. 2 & 3). Mark the location of the holes with a
sharpened pencil.
•For accessories with two brackets
Towel rails: A hole location template is provided. Select a location
to place the template. Use a level to ensure that the template is
horizontal. Ensure it is pressed flat and fix the template to the wall.
(Fig. 4)
Glass shelf: The bracket positions on the glass shelf are
adjusable. Choose an appropriate bracket distance (400mm
minimum). Use a level to ensure that the brackets are horizontal.
Mark the location of the holes with a sharpened pencil. (Fig. 5)
NOTE: When drilling holes make sure to do so as accurately as
possible.
Stud or a nog installation (Fig. 5)
•Pre-drill 2.5mm diameter holes at the marked locations. When
using the installation template - drill directly through the template
on marked locations.
•Align the bracket so that it is correctly oriented and secure the
bracket in place with the supplied screws using a #2 square drive.
•Ensure that the screws are firmly fastened.
Ceramic tile or concrete installation (Fig. 6)
•Drill 6mm diameter holes at the marked locations using a tungsten
carbide tipped drill bit for tiles, or a masonry bit for concrete.
•Gently tap the supplied toggles into the holes using a mallet until
they are fully inserted.
Fig. 2
Page 3
Page 2
MILANO
TM
Accessories INSTALLATION INSTRUCTIONS
MILANO
TM
Accessories INSTALLATION INSTRUCTIONS
3. ACCESSORY INSTALLATION
4. CHECK INSTALLATION
Clean accessories with mild soap and warm water. Wipe entire surface completely dry with a
clean soft cloth. Harsh cleaning products including those that contain ammonia and chlorine
may adversely affect the finish and are not recommended for cleaning.
Step 3.1
NOTE: For all accessories ensure that the grub screw hole is
oriented downwards.
• For the robe hook
Slide the accessory onto the bracket. (Fig. 7)
• For toilet roll holder, tumbler holder, soap dish holder &
toilet brush holder
Slide the accessory onto the bracket. (Fig. 8)
• Single and double towel rail & hand towel bar
Slide the assembled towel rail over the brackets. (Fig. 9)
• Glass shelf
Slide the glass shelf into the bracket slots and centre. (Fig. 10)
Step 3.2
Align and firmly press the accessory against the wall while
screwing in the grub screw/s with the provided hex key. Make sure
the grub screw/s are firmly tightened.
Fig. 5
Fig. 6
Ensure that all connections are tight. Place glass components onto appropriate accessories.
ENGLEFIELD
ENGLEFIELD
Fig. 3
!
Fig. 4
Fig. 5
Fig. 1
Fig. 7
Fig. 8
Fig. 9
Fig. 10
•Orient the bracket correctly over the wall plugs and ensure the recesses on the back of the
bracket fit over the rim of the wall plugs so that the bracket is flush with the wall.
• Secure the bracket firmly in place with the supplied screws using a #2 square drive.
Plaster board installation
Please consult your local hardware store for appropriate wall plugs for installation on plaster board.
Template
Minimum distance 400mm
