EnGenius ECB1221R Manuel utilisateur

Go Wireless NZ Ltd

Unit 6, 5 Stone Street

Kaiapoi, Canterbury

New Zealand

+64 3 741 1339

www.gowifi.co.nz

EnGenius Repeater

Setup Guide

(ECB1221R / ESR-1221EXT)

By Daniel Allin, Technician

(DipCN, MTCNA)

Go Wireless NZ Ltd

Step 1:

Locate your Network Settings and note down your IP Address, Subnet Mask, and

default-gateway:

Step 2:

Note down the wireless SSID your wish to repeat (Mine will be www.gowifi.co.nz):

Go Wireless NZ Ltd

Step 3:

Click on the Change advanced settings option (left) and select the Wireless

Networks tab. Select you network from the list and click properties.

Note down your security details (Network Authentication, Data Encryption and your

Security Key which you should already know).

Step 4:

Open your network connections and disable the wireless connection:

Step 5:

Depending on the EnGenius Router Model you have you may or may not need to

assign a static IP address to your computer to access and configure it for the first

time. If you are unsure, please read our “IP Address Basics” Guide on how to do this.

Go Wireless NZ Ltd

Step 6:

Plug your EnGenius Router into your computer and power it on. (It takes about 30sec

to boot). Connect to the EnGenius Router (Open Internet Explorer and type

192.168.1.1 into the address bar):

ESR-1221 EXT: Skip to Step 8, your router is already in AP Mode!

Step 7:

Assign the EnGenius Router an IP Address, Subnet Mask and default-gateway:

(Make sure the IP Address you enter is not being used by any other devices on your

network, the subnet mask and gateway will need to be the same as recorded in

Step 1).

Go Wireless NZ Ltd

Step 8:

Go to the Wireless basics page put your Wireless SSID that you recorded in step 2

(You will need to make sure you select the same channel that your main Wireless AP

is on:

Step 9:

Enter your Wireless Security details recorded in Step 3:

(yourpasskeyhere = your current Wireless Password you use to connect to your

Wireless Network)

Go Wireless NZ Ltd

Step 10:

Check that the EnGenius Router is connected and repeating:

Under the Wireless Repeater Interface Configuration (above) you should see the

State as Connected. This means The EnGenius router is now connected to your main

Wireless Router and Repeating!

Once finished, open your network connections again and set your “Local Area

Connection”back to Obtain IP Address Automatically.

Re-Enable your Wireless Adapter that you disabled in Step 4.

Autres manuels pour ECB1221R

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels EnGenius Répétiteur

EnGenius

EnGenius ERA150 Manuel utilisateur