4
Installation Area
Refer to the Enel X Way Site Design Guide.
Installation
Each JuiceBox must be on its own circuit. Refer to the Wiring Design section of the Enel X
Way Site Design Guide for additional information.
1. Turn o the mains power to the hardwire connections.
2. Use a multimeter to ensure that there is no power at the hardwire connections.
3. Route the mains power hardwire connection into the pedestal from the boom, then
position the pedestal onto the ground stud anchors.
4. Secure the pedestal to the ground stud anchors (refer to Installation Area for more
information).
NOTE:
>The JuicePedestal must be installed in accordance with the National Electrical
Code (NFPA 70) and all applicable local jurisdiction requirements.
>Junction Boxes must be UL Listed or UL Ceied for outdoor-use due to local
regulations, if necessary.
>Conduit ings must be liquid-tight and UL Listed or UL Ceied for outdoor-
use.
WARNING: Do not continue with the installation until the multimeter shows
that there is no power at the hardwire connections to mains.
