1. Safety instru tions
Re ardin name plates, warnin labels and labels:
・
・・
・Never remove or defa e any name plates, warning labels or labels whi h are atta hed to
the body.
The operator should always observe them.
Re ardin installation (pa e 8):
・
・・
・Never use in ignitable or explosive atmospheres.
・
・・
・Take suffi ient are not to kno k or drop the reel when handling.
Never use the arm of the guide roller (spe ial a essories) to lift the reel.
Re ardin round connection work (pa e 9):
・
・・
・Ele tri sho k hazard.
Do the ground onne tion work.
・
・・
・Never onne t the earth line to the following:
Gas pipes, et . : Danger of ignition or an explosion.
Phone lines / lightning rods : Danger of being stru k by lightning.
Along plasti water pipes : Does not a t as an earth.
Re ardin cable connection (pa e 10):
・
・・
・Ele tri sho k hazard.
Turn off the power before arrying out any work.
・
・・
・Do not install able to drum more than 2-3 times round.
(2-3 times means winding length & initial spring turns)
Make free spa e in drum, otherwise able ould spill out from drum over.
If able spilled, it auses a idents as a able utting.
・
・・
・When used for verti al lift or horizontal stret h appli ation, in order to
prevent severing of the able and then a fall in ase of a spring breakage, prote t the able
by wrapping rubber or the like around the able portion whi h onta ts with the oblong
hole in the drum over.
・
・・
・Che k the wire onne tions are sound and there are no wiring errors.
・
・・
・Never allow the able (leads) onne ted to the slip rings to protrude over 10mm from the
terminal plate upper surfa e for slip ring apa ities of 10A, 20A and 50A, or over 30mm
from the top of the lead bolt for slip ring apa ities of 100A and 150A.
・
・・
・Leave suffi ient room for onne ting the able (leads) to the brushes so as not to apply
ex essive for e to the brushes.
・
・・
・Never obliquely atta h the terminal lugs to the brush holder. If obliquely atta hed, the
insulator length will be insuffi ient, resulting in poor insulation.
・
・・
・Se urely tighten the ross re essed head s rews to atta h the dust proof over and the
onne tor nut to prevent rain penetration.
Take suffi ient are not to damage the seal ring during any work.
Copied digital data
from http://www.endo-kogyo.co.jp/
