Endgame Gear XSTRM Manuel utilisateur
USB-MICROPHONE
Table of Contents
1. What‘s in the box...................................................................................................2
2. System requirements...........................................................................................3
3. Technical Data.........................................................................................................3
4. Hardware setup.......................................................................................................4
5. Software setup........................................................................................................7
6. How to use...............................................................................................................12
7. Safety and maintenance....................................................................................16
EN
2
1.What‘s in the box
MANUAL
Tablestand XSTRM USB-microphone
Acustic-foam
Pop-filter
USB-Cable
3
2.System requirements
• Windows Pc or Mac
• Windows 7 64-Bit®/ OS X®(or higher)
3.Technical Data
Microphone
• Power consumption: 5V, 250mA (max)
• Sampling/bit rate: 192KHz/24-bit
• Electret condenser microphone
• 20mm gold plated membrane condenser
• Polar pattern: Cardioid
• Frequency response: 20Hz -20kHz
• Sensitivity: -36dB (1V/Pa at 1kHz)
• THD+N Ratio: 0.40%
• Signal to Noise Ratio: 57dB
• Cable length: 2m
Headphone Output:
• Impedance: 32 Ohms
• Frequency response: 20Hz -20kHz
• Maximum power output: 32.5mW
Size and weight of the microphone
• Height with/without table-stand: 250mm/ 221,5mm
• Diameter: 119mm
• Weight with table-stand: 820g
EN
4
4.Hardware setup
4.1 Connect your Computer
1. To connect your Xstrm USB-microphone to your PC or Mac use the included
USB-C cable.
5
*The microphonearm is sold seperatly
4.Hardware setup
4.2 Mount to microphone arm
Unscrew the included stand to use the 3/8“ thread to mount to an arm* or a
tripod*.
EN
6
4.Hardware setup
4.3 Monitoring
Connect your Headphones to the 3.5mm jack to monitor your recording in realtime
without latency.
7
5.Software setup
5.1 Set your standard recording device
When you use the Xstrm microphone for the first time on a pc you have to
change it to your standard recording device.
5.1.1 For Windows user
1. Search for your sound-settings
2. Open sound-settings
3. Choose The Endgame Gear XSTRM from the dropdown menu for input de-
vices.
EN
8
Please note: Make sure to check if your preferred output device is selected. If
you want to use another output device than the microphone, please change this
option back to your prefered device.
5.Software setup
5.1.1 Set your standard recording device for windows user
4. Click on device properties and adjust the volume slider to set the recording
volume.
Table des matières
Langues :
