Emotron DSV15-35 Guide de l'utilisateur
Control unit
For Emotron DSV15-35 AC drives
Mounting instruction
4
1 General information
First read, then start
1General information
1.1 First read, then start
Information
and tools with regard to the Emotron products can be found on the Internet:
http://www.emotron.com
à File-archive
You will
find
information
on wiring and commissioning in the
mounting
and switch-on
instructions
of the inverter.
Read this
documentation
thoroughly before carrying out the
installation
and commissioning.
Please observe the safety
instructions!
5
Mounting 2
Important notes
2Mounting
2.1 Important notes
Dangerous electrical voltage
Possible consequence: death or severe injuries
▶All works on the inverter must only be carried out in the deenergised state.
▶After switching off the mains voltage, wait for at least 3 minutes before you start working.
DANGER!
6
2 Mounting
Mounting steps
2.2 Mounting steps
You need:
• Torx screwdriver TX20
1. Preparation:
1. Insert the shield sheet into the slot on the back side until it engages.
2. Mounting:
1. Hook the control unit into the upper mounting slots.
2. Turn it downwards until it engages into the lower mounting slots.
7
Mounting 2
Mounting steps
3. Fix it with a securing screw.
The control unit is mounted.
© 01/2016 | 13492598 | 1.0 / 01-6409-01R1
CG DRIVES & AUTOMATION
Mörsaregatan 12,
Box 222 25
SE- 250 24 Helsingborg,
Sweden
+46 42 16 99 00
Info: info.se@cgglobal.com
Order: order.se@cgglobal.com
Table des matières
Autres manuels Emotron Contrôleurs
Emotron
Emotron VS10 Manuel utilisateur
Emotron
Emotron VFX 2.0 Fiche technique
Emotron
Emotron MSF 2.0 Manuel utilisateur
Emotron
Emotron VS10 Manuel utilisateur
Emotron
Emotron TSA 1 Manuel utilisateur
Emotron
Emotron TSA Softstarter Manuel utilisateur
Emotron
Emotron FLD48-058-20 Manuel utilisateur
Emotron
Emotron VSB Series Manuel utilisateur
