ELKHART BRASS APEX-S Instructions de montage

98607000 REV-rel

Valve Controller

Installation, Operating, & Maintenance Instructions

1-574-295-8330

www.elkhartbrass.com

CONTENTS

INTRODUCTION ......................................................................................4

Overview ...........................................................................................4

Specications .......................................................................................5

Control Module ......................................................................................5

GENERAL DESCRIPTION ..............................................................................6

Components.........................................................................................6

Controls and Indicators...............................................................................7

INSTALLATION.......................................................................................8

Install Valve Controller ...............................................................................8

ELECTRICAL CONNECTIONS ..........................................................................10

Wiring the Valve Controller ...........................................................................12

MAINTENANCE/CALIBRATION........................................................................17

Automatic Valve Position Calibration for APEX-S .......................................................17

OPERATION ..........................................................................................19

Button Functions ....................................................................................19

PROGRAMMING MODE ...............................................................................20

Customizing Default Settings .........................................................................20

List of Figures

Figure 1. Controls and Indicators .......................................................................7

Figure 2. Valve Controller Mounting Dimensions ........................................................9

Figure 3. Valve Controller Wiring.......................................................................10

Figure 4. Valve Actuator Wiring ........................................................................11

Figure 5. Wiring (Cables and Connectors) ...............................................................13

Figure 6. Wiring (Cables and Connectors) ...............................................................14

Figure 7. APEX-S 1:1 Wiring Connections ...............................................................15

Figure 8. APEX-S 2:1 Wiring Connections ...............................................................16

List of Tables

Error/Warning Codes Troubleshooting Table ............................................................22

INTRODUCTION

Overview

The APEX-S electric valve controller is designed with precision and ease of use in mind.

Rugged design withstands the demands of outdoor apparatus use. Monitor the valve position

with ultra-bright LEDs.Tactile buttons provide enhanced user experience with intuitive and

familiar operation. Use keypad buttons to open, close and adjust valve position. All controls

and indicators are located on the front of the controller. Controls are simple push button style

controls.The controller is compatible with E14X and E16X (EB6D) electric valve actuators.

Features

. 10 Green LEDs Indicate Open Valve Position

. Red LED Indicates Valve is Closed

. Keypad–rubberized, large, embossed and color-coded Tactile Buttons (glove friendly)

. Button actions–Full Open, Full Close

. Automatic valve position calibration

. Auto-travel open and close

. Programmable LED intensity

. Automatic adjusting day/night LED intensity

. Enclosure– Molded Glass-filled Polymer for Rigidity, Surface Hardness and Strength

. Sealed to IP67 Ingress Protection on All Sides

. Visor–Color-coded in 12 Colors to Match Discharges to Valve Controller

. Datalink interface simplifies wiring between controller & valve

. Connector– Sealed Connectors (Power & CAN data/bus)

. CAN communication to Unibody valve using E14X/E16X

. Power Requirements–9 to 30 VDC; Less than 1 Watt Power Consumption

Specications

APEX-S Valve Controller

Supply Voltage: 9—30VDC

Current: 0.5 A - Display Module only.

Fuse Rating: 1 A (12V) & & 0.5 AMPS (24V)

Dimensions:

Height 3 31/32"

Width 3 5/8"

Depth 2 5/16"

Datalink Interface: CAN Bus

GENERAL DESCRIPTION

Components

The Electric Valve System consists of the following components:

. Valve Controller

. Valve with Actuator

. Cables

Valve Controller

The valve control and LED is sealed to an IP67 rating, and has dimensions of 3 31/32 inches

high by 3 5/8 inches wide by 2 5/16 inches deep. All controls and indicators are located on the

front of the module. (Refer to Controls and Indicators.)

Valve with Actuator

An Elkhart Unibody valve with an E14X (E16X for EB6D) actuator must be installed in the

apparatus plumbing and connected to the valve controller.

Cables

Interconnecting cables are provided. Refer to Electrical Connections (Wiring) section.

Figure 1. Controls and Indicators

Controls and Indicators

The display and pushbuttons controls are accessible on the front of the unit.

(Refer to Figure 1.)

Valve Position Indicator LEDs

Closed Indicator will be red when the valve is fully closed. As the valve moves from the closed

to fully open position the red closed LED will go out and the green LEDs will turn on one at a

time from left to right until all 10 of the green LEDs light up indicating the valve is fully open.

Valve Control Buttons

Two buttons open and close the valve.The third button (Preset) will move the valve to a

programmed position.

Color-Coded Visor

The Visor helps prevent water and dirt from running down the display. It can also be used to

color code the valve controller to match the corresponding discharge.

Valve Closed

Indicator

Visor

Valve Open position LEDs

(10% increments)

Valve Control

Buttons

APEX-S

Light

Sensor

INSTALLATION

The APEX valve controller is compatible with unibody valves used in 1.5 to 8 inch piping.

Install Valve Controller

1.Measure and mark mounting location for controller panel cutout and mounting screw holes.

Make sure there is clearance behind the panel for the display and cables before cutting

holes. Refer to Figure 2 for layout and dimensions.

2.Cut out a mounting hole according to the cutout diagram in Figure 2, and drill three holes

(clearance or tapped) for #10 mounting screws.

3.Connect the cables and wires. (Refer to Wiring section.)

4.*Place control module into position and secure with three screws.

Use #10 size, Phillips pan head type screws with a minimum length of 1.25 inch.

*NOTE: The Visor must be placed onto the valve controller housing prior to inserting

mounting screws and attaching to your apparatus.

Figure 2. Valve Controller Mounting Dimensions

2 5/16"

29 3/32"

Recommended Panel Cutout

#10 clear

(thru-bolt with nut)

or tapped for #10

fasteners, 3x

2 3/32"

1 3/64"

2 9/16"

1 9/32"

3 1/16"

R 1/2"

1 17/32"

3 5/8"

3 31/32"

ELECTRICAL CONNECTIONS

Figure 3. Valve Controller Wiring

Valve Controller 6-Pin Connector

Pin Signal Description

1 Power 12/24 VDC

2 Ground Supply

3 NC

4 Datalink Shield

5 Datalink CAN Low

6 Datalink CAN High

Pin 1

6-Pin

Connector

Table des matières

Autres manuels ELKHART BRASS Contrôleurs

ELKHART BRASS

ELKHART BRASS APEX 100 Instructions de montage

Manuels Contrôleurs populaires d'autres marques

Digiplex

Digiplex DGP-848 Mode d'emploi

YASKAWA

YASKAWA SGM series Manuel utilisateur

Sinope

Sinope Calypso RM3500ZB Manuel utilisateur

Isimet

Isimet DLA Series Style 2 Manuel d'installation

LSIS

LSIS sv-ip5a Manuel utilisateur

Rockwell Automation

Rockwell Automation 1769-L31 Manuel utilisateur

Airflow

Airflow Uno hab Manuel utilisateur

ABB

ABB ACS580-01 drives Manuel utilisateur

Panasonic

Panasonic GM1 Series Manuel utilisateur

Emerson

Emerson SW93 Manuel utilisateur

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manuel utilisateur

Panasonic

Panasonic FP? Positioning Unit RTEX Manuel utilisateur

Samson

Samson Type 5824 Manuel de service

Alpha IP

Alpha IP MIOB 21001 Manuel utilisateur

Siemens

Siemens OpenAir GMA 1 Series Manuel utilisateur

Surecom

Surecom SR-629 Manuel utilisateur

Fishman

Fishman TriplePlay Manuel utilisateur

Regulus

Regulus SRS1 T Manuel utilisateur