Elk ELK-1RT Manuel utilisateur
Speaker & Stainless Steel Enclosure
ELK-1RT
The ELK-1RT is a rugged 30 Watt, 8 Ohm speaker
mountedinatamperresistant,“NoRust”
enclosure.Itfeaturestwosealedreedtamper
switches,oneon the Back plate andoneon the
FrontCover.Thestainlesssteelnaturally reflects
themounting surface and blendseasilywithany
residentialorcommercial building.Alsoavailable
istheELK-150RT with Built-in Siren orthe
ELK-SL1 Strobe Light that can be added to the
enclosure.
• InstallerFriendly-Easyto Mount.
• Exterior/ Interior use.
• SealedReedTamperSwitches at single bolt
closureandat rear of cabinet.
• NoRust-NoMess.
• Compact - Less Noticeable.
• Loud- Rivals Sound ofLarger Speakers.
• HeavyDuty 1.8 lbMagnet.
• High Fidelity Voice Coil.
• StainlessSteelMounting HardwareIncluded.
• LifetimeLimitedWarranty.
• Rating: 30 Watts Nominal /50 WattsPeak.
• Impedance: 8Ohms.
• FrequencyResponse: 500 to 7000 Hz.
• Enclosure: #304StainlessSteel.
• Size: 5”H x 5”W x 4”D.
• Tamper: Sealed Reed Switches.
PO Box 100 • Hildebran, NC 28637 • 800-797-9355 • 828-397-4200
Fax828-397-4415•www.elkproducts.com•[email protected]
Features
Specifications
ELK
PRODUCTS, INC.
ELK-1RT
with optional
ELK-SL1C
Clear Strobe
Tamper-Proof Cover 30 Watt Speaker
Hardware Pak
Back Plate w/
(2) Tamper
Switches
Features and Specifications subject to change without notice.
Cut-away
view
Components of
ELK-1 RT
05/02
Tuck wires into
lower corner of
backplate away
from top inside
corners.
Install top edge of
backplate at least 1"
below any soffit or
building overhang.
Figure 4
Slide over speaker. Lower tabs into
slots. Push towards wall. Lift up to lock, then
secure with hex bolt.
Figure 3
Tamper switch is closed
by the front cover during
the final 3 to 4 turns of
the hex bolt.
Figure 2
Figure 1
Wall Mounting Holes
Electrical Box
Mounting Holes
Wire /
Conduit
Entry
TAMPER White
TAMPER White
Black
Red
SPEAKER LEADS
ELK-901G
The ELK-1RT is a rugged, quality speaker mounted in a tampered
"No Rust" stainless steel enclosure. It incorporates two sealed
reed tamper switches for enhanced reliability and ease of use.
1. Using the backplate as a template, mark and drill the 4
mounting holes and the wire or conduit entry hole (see Figure
1). Insert the (4) 1/4 x 1” wall anchors, then partially install the
top two #10 x 1” screws.
2. Route the wire or conduit through the hole provided and hang
backplate on the top screws. Then install remaining two
screws and & tighten all four.
3. Temporarily hang the speaker on the backplate by aligning
the slotted insert on the top edge of the speaker with the 1/2"
recessed tab on the bottom edge of the backplate. Press
speaker onto tab. (See Figure 2)
4. Connect the two white wires from the tamper switches to a 24
hour closed loop on the control panel (the switches are
already connected in series).
5. Connect the red and black speaker wires to an 18 gauge
(minimum) cable run back to the siren driver in the control
panel.
6. Move the speaker from its hanging position to its final mount
by aligning it's top and bottom slots with the 1/2" tabs on the
top edge of the backplate and in the bottom center above the
bolt threads. (See Figure 3) Press firmly. Tuck all loose
wires into the backplate and behind the speaker.
7. Slide the front cover over the speaker. (See Figure 4) Then lift
upward slightly to engage the two tabs inside the cover with
the two "U" shaped slots on the top left and right edges of the
backplate. Lower the cover until the tabs are resting in the
slots. Push the cover towards the wall, then lift up to lock the
tabs into their slots. Thread the 1/4-20 hex bolt into the
dimpled hole on bottom of cover and tighten until secure.
8. The front cover tamper switch is pressed closed by the front
cover during the final 3 to 4 full turns of the hex bolt. If
possible, test the operation of the tamper switch using a
continuity meter.
Instructions ELK-1RT
Autres manuels Elk Intervenants
Manuels Intervenants populaires d'autres marques
Bowers & Wilkins
Bowers & Wilkins 4 Manuel utilisateur
Sonance
Sonance SONOS OUTDOOR Series Manuel utilisateur
Electro-Voice
Electro-Voice EVID FM4.2 Manuel utilisateur
Pioneer
Pioneer XW-HTD630 Manuel utilisateur
Onn
Onn BWA16AA002 Manuel utilisateur
HP
HP GL313AA - USB Speakers PC Multimedia Manuel utilisateur