GPS functions for wave button：
1.Short pull up:switch between driving distance&time(pls note, after enter into the
setting menu, short pull up is to increase the parameter).
2.Short pull down:switch between clock,driving distance&time(pls note, after enter
into the setting menu, short pull down is to decrease the parameter).
3.Vertical Short press:switch between speed unit Mile or KM(pls note: after enter
into the setting menu, vertical short press is to increase the menu).
4. Long pull down: turn on or off the alarm sound.
5.Vertical long Press 5 seconds: enter into setting menu(menu 0-7),after finish
adjustment,vertical long press in 5 seconds to save it and exit.
6.Long pull up:up for 5 seconds to clear the engine fault code.
Buzzer switch:
Down the wave button 5 seconds to turn off the buzzer, down the wave button 5
seconds again to turn on the buzzer mark.
Engine fault code clearance:
When HUD connected car,pls donnot start the car, put the key to "ON", waiting for
HUD shutdown,then downside the wave button for 5 second, you will hear “beep”
sound from HUD, which means clear the fault codes completed.
Reset setting:
Vertically long press 5 seconds to enter into menu setting, short press 16 times to
find menu 16, short pull down to parameter 1, long press in 5 seconds to save after
adjustment.
HUD setting:
Since HUD displays data getting from ECU,ECU data will be a little different with car
dashboard data.At that time,you can enter into menu setting to have a fine
adjustment of HUD in order to get the same data as dashboard.HUD manufacturers
make adjustments according to the general test values before HUD releases, if you
are finding there is something different with the the dashboard values,please make
an adjustment as below:
Long press in the wave button 5 seconds to enter into menu setting(3 directions here
for your choose:up,vertical,and down),vertical short press 1 time,menu value will
increase along with it,up or down the button to increase or decrease the
parameter.Vertically long press 5 seconds to save and exit after adjustment.
