MULTIMIG 200
General regulation of use
6
If the mains able is damaged or
severed in use, do not tou h the
able but unplug the mains plug
immediately. Never use a
ma hine if the mains able is
damaged.
Keep a fire extinguisher near the
welding area.
Che k the welding area for fire af-
ter welding (see UVV
1
)).
Never try to disassemble the pres-
sure redu er. Repla e the defe -
tive one.
The ma hine must be transported
or set up only on firm, level
admissible angle of in lination for
setting up or transporting is 10°.
Servi e and repair work may only be arried
out by a trained ele tri ian.
Ensure that the ground able has good and
dire t onta t near the welding lo ation. Do
not allow welding urrent to pass through
hains, ball bearings, steel ables or
grounding equipment; this may melt them.
Se ure yourself and the welding ma hine
when working in elevated or in lined areas.
The ma hine may only be onne ted to a
properly grounded mains supply. (Three-
phase four-wire system with grounded
neutral ondu tor or single phase-three-wire
system with grounded neutral ondu tor)
so ket and extension able must have a
fun tional prote tive ondu tor.
Wear orre t prote tive lothing, leather
gloves and leather apron.
Prote t the welding area with urtains or
mobile s reens.
Do not use this ma hine to thaw frozen
water pipes or ables.
In losed ontainers, under ramped on-
ditions, and in high ele tri al risk areas, only
use ma hines with the S sign.
Swit h off the ma hine during breaks and
lose the valve of the gas ylinder.
Se ure the gas ylinder with a hain to
prevent it falling over.
Dis onne t the mains plug from the mains
before hanging the pla e of installation or
making repairs to the ma hine.
Please heed the safety regulations whi h apply
to your ountry.
Subje t to hange.
4 General regulation of use
This unit is for welding of steel, aluminium and
their alloys as well as for brazing with CuSi
wires for ommer ial as well as for industrial
use.
5 Unit rotection
This ma hine is prote ted ele troni ally
against overloading. Do not use fuses of higher
amperage than printed on the identifi ation
plate.
Close the side over before starting any
welding work.
6 Noise emission
The noise level of the unit is less than
70 dB(A), measured under standard load in a -
ordan e with EN 60974-1 in the maximum
working point.
