TA4000 - USER MANUAL - 090020950
elmospa.com
2
FOREWORD
FOR THE INSTALLER:
Comply strictly with current standards governing the installation of electrical systems and security systems, and with the
manufacturer’s directions given in the manuals supplied with the products.
Provide the user with full information on using the system installed and on its limitations, pointing out that there are different levels
of security performance that will need to suit the user’s requirements within the constraints of the specific applicable standards.
See that the user looks through the warnings given herein.
FOR THE USER:
Check the system’s operation thoroughly at regular intervals, making sure the equipment can be armed and disarmed properly.
Make sure the system receives proper routine maintenance, employing the services of specialist personnel who meet the
requirements prescribed by current regulations.
Ask your installer to check that the system suits changing operating conditions (e.g. changes in the extent of the areas to be
protected, change in access methods, etc...).
-------------------------------
This device has been designed, built and tested with the utmost care and attention, adopting test and inspection procedures in
accordance with current legislation. Full compliance of the working specifications is only achieved in the event the device is used
solely for its intended purpose, namely:
The device is not intended for any use other than the above and hence its correct functioning in such cases cannot be assured.
Consequently, any use of the manual in your possession for any purpose other than those for which it was compiled - namely for
the purpose of explaining the product’s technical features and operating procedures - is strictly prohibited.
Production processes are closely monitored in order to prevent faults and malfunctions. However, the componentry adopted is
subject to an extremely modest percentage of faults, which is nonetheless the case with any electronic or mechanical product.
Given the intended use of this item (protection of property and people), we invite you to adapt the level of protection offered by the
system to suit the actual situation of risk (allowing for the possibility of impaired system operation due to faults or other problems),
while reminding you that there are specific standards for the design and production of systems intended for this kind of application.
We hereby advise you (the system’s operator) to see that the system receives regular routine maintenance, at least in
accordance with the provisions of current legislation, and also check on as regular a basis as the risk involved requires
that the system in question is operating properly, with particular reference to the control unit, sensors, sounders, dialler(s)
and any other device connected. You must let the installer know how well the system seems to be operating, based on the
results of periodic checks, without delay.
Work involved in the design, installation and maintenance of systems incorporating this product should be performed only by
personnel with suitable skills and knowledge required to work safely so as to prevent any accidents. It is vital that systems be installed
in accordance with current legislation. The internal parts of certain equipment are connected to the mains and therefore there is a risk
of electrocution when maintenance work is performed inside without first disconnecting the primary and emergency power supplies.
Certain products include batteries, rechargeable or otherwise, as an emergency backup power supply. If connected incorrectly, they
may cause damage to the product or property, and may endanger the operator (explosion and fire).
According to Directive 2012/19/EU on the Waste of Electric and Electronic Equipment (WEEE), it is here specified that
this Electrical-Electromechanic Device started to be commercialized after 13th August 2005, and it shall be disposed
of separately from ordinary waste products.
DISPOSAL INSTRUCTIONS - INFORMATION FOR THE USER
it08020000001624
CE DECLARATION OF CONFORMITY
This product needs batteries for correct functioning. Exhausted batteries have to be delivered to dumping grounds
authorized for battery collection. The materials used for this product are very harmful and polluting if dispersed in the
environment.
Fire detection and fire alarm control panel
The TA4000 control unit complies with current European EMC and LVD directives. You can log into the elmospa.com website to read
the full Declaration of Performance: registration is quick and easy.
