7.4-How to clean it?
• Do not be afraid to waste water and use more water. The more water the more clean the more
washed the more pressure the more clean (of course, do not exceed the safety pressure).
• Pre-wet the panels, that is, first rinse the panels with water, and then use the brush cleaning,
that is more efficient.
• Used of cleaning agents, which can improve the cleaning efficiency.
• Make the dirty water flow out immediately, if not, after it dry, there is a layer of thin dust
on the glass surface, which is due to dirty water is not timely flow, dry stains. How to deal with it?
you can also flush with water again and then washed again. So the wash will be very clean.
• You can adjust the angle of the brush head to fit the panel by adjusting the spring force on
the top of the brush head (add a spring).
•You can also adjust the length of the Squeegee, or replace the different materials of the
squeegee to improve the cleaning effect.
8-Maintenance Guide:
8.1-Note:
8.1.1-Regularly check the brush, especially the water supply hoses, each time you start work should be
carefully checked whether the water leakage.
8.1.2-In any situation, have to work through the pole to brush. Cannot drag the hose to move the
Brush.
8.1.3-If necessary, replace old parts to ensure operational reliability and longer service life.
8.2-Wiper replacement:
Use the Allen wrench, loosen the wiper blade screws, remove the old Wiper, replace the new
One.
www.ekt2.com
Electronics Katrangi Trading
