- 6 -
180 cm 135 cm
Installation
3. Installation
3.1. Wall mounting of outside unit
The ideal installation height is at
approximately 135 cm / 52 inches (upper
edge). At this height the fingerprint reader is
ergonomically positioned for better reading of
the finger surface as it is being swept.
The unit can be mounted to a standard electrical
outlet using the “in-wall mounting set”
accessory. The mounting holes are designed to
make the assemblage on a standard electrical
outlet possible. Alternatively, you can work with
pins or wooden screws or similar screws directly on the wall.
The outside unit (splash water resistant) has to be installed in a place,
where it is safe from the impact of heavy rain or snowfall as well as
from too strong an incident of solar radiation.
3.2. Wall fastening of inside unit
Mount the “fitting plate”, which can be found at the backside of the
inside unit. The “fitting plate” at the same time serves as fastener for
the casing of the inside unit. Put up the inside unit onto the fitting
plate.
Inside unit can be opened by pushing up the lock clip with a flat
screwdriver.
The inside unit has to be installed in a way that it is safe from third
party access. Security risk!
Note:
Installation of inside unit shall be exclusively executed by qualified
personnel!
