10
GAS CONNECTION FOR GAS HOB
The Cooker should be connected to the gas-supply by licensed installer. During installation of this product it is
essential to fit an approved gas tap to isolate the supply from the appliance for the convenience of any
subsequent removal or servicing. Connection of the appliance to the gas mains or liquid gas must be carried
out according to the prescribed regulation in force, and only after it is ascertained that it is adaptable to the type
of gas to be used. If not, follow the instructions indicated in the paragraph headed "Adaptation to different gas
types". In the case of connection to liquid gas, by tank, use pressure regulators that conform to the regulation
in force.
IMPORTANT: For safety, for the correct regulation of gas use and long life of the appliance, ensure that the
gas pressure conforms to the indications given in table 1 "Nozzle and burner characteristics".
ORIENTATION OF THE ELBOW
The appliance is supplied with a gas connection.The connection to the gas supply must be effected only from
the default position or in vertical position by turning the elbow downwards. To turn the elbow, follow these
operations:
√Loosen the nut √Turn the elbow √Lock the nut √Make sure there is no leakage by a soapy solution.
IMPORTANCES:
√Never attempts to turn the elbow without having first slackened off the relative lock nipple.
√ The seals are the elements that guarantees the seal in the gas connection. It is recommended that they
be replaced whenever they shows even the slightest deformation or imperfection.
√After connecting to the mains, check that the couplings are correctly sealed, using soap solution, but
never use naked flame.
√The connection with rigid metal pipes should not cause stresses to the hob ramp.
√If the rubber tube is used for the gas connection:
-Make sure the tube is snugly fit at both ends and use a standard tube clamp (not supplied) to fasten it.
-The rubber tube must be as short as possible, without contractions or kinks.
-The rubber tube must never be at any point in its length in contact with the “hot” parts.
-From time to time check to make sure that the rubber is in perfect condition.
OPERATIONS TO BE PERFORMED WHEN SUBSTITUTING THE INJECTORS
If the injectors are not supplied they can be obtained from the “Service Centre”.
√Remove the gratings and the burner covers;
√Using a wrench, substitute the nozzle injectors;“J” (Fig.14) with those most
suitable for the kind of gas for which it is to be used.
√The burners are conceived in such a way so as not to require the regulation of
the primary air.
