M132
3
Assembly of Motor-to-Motor Plates
Install snap bushing (B297) into one motor plate (P086). Place a washer (W009) on each rear motor stud and slide motor plate, with
bent section toward motor, over the motor studs. Wires must exit motor on bottom toward bent section and through the bushing in the
motor plate. Secure using external tooth washer (W017) and nut (N019) on left stud and wire clamp (C073), external tooth washer
(W017) and nut (N019) on right stud. Feed wires through the wire clamp.
Place washer (W009) on each stud on shaft side of motor slide motor plate (P086) over studs with bent section towards rear of motor.
Secure with external tooth washer (W017) and nuts (N019). Make sure both bent sections fit flat on base before tightening last two
nuts.
Line up threaded holes in motor brackets with the four longitudinal slots in base and install serrated washer (W084) and hex screw
(S063) into each threaded hole and secure finger tight.
Insert the power lead from the cord set (black/brown in color) through the wire clamp (C073) and install insulated terminal according
to wiring diagram.
Take one motor lead that is through clamp and cut to same length as power lead and install insulated terminal according to appropriate
wiring diagram
If motor is 115 volt, then cut other motor lead to length of 5 inches from snap bushing and secure to the neutral white wire along with
a 6-inch long jumper wire with solder less connector (C092). Crimp together using proper crimping pliers.
Insert the jumper wire through the wire clamp (C073) and cut to same length as other two leads. Install terminal shown on 115-volt
wiring diagram (Fig. 3).
If motor is 230 volt, then thread other motor lead through the wire clamp (C073) and install terminal shown on wiring diagram along
with shrink tube shown. Insert neutral wire (white/blue in color) through the wire clamp, cut to same length as other three leads and
install terminal and shrink tube according to wiring diagram
PARTS LIST
ASEMBLY, #395 GRINDING WHEEL
ASSEMBLY, #395 PLASTIC KNIFE GUIDE
BUSHING, ½” SNAP, 3/8” ID HEYCO #SB 500-6
CLAMP, #201 CABLE HEYCO #3324
CONNECTOR, #390/395/CH-5000 LEAD
CORD SET, REGULAR 7’, 18/3, GRAY
MOTOR, #395 115V SPARE PART
MOTOR, #395 230V SPARE PART
SCREW, ¼-20 X 3 FL 40 S/S
SCREW, ¼-20 X ½ S/S HEX HEAD
SCREW, 10-32 X 3/8 PLTD HH CAP SCREW
SCREW, 10-32 X 5/16 PLATED RHM
SWITCH, CH-5000/350 USA LIGHTED ROCKER
TERMINAL, ECO ROUND TONGUE
WASHER, #10 EXT. TOOTH LOCK, PTD
WASHER, #10 3/16 PLATED LOCK
WASHER, #10 SERRATED PLATED
