04
5.The 180 degree coverage of the
motion sensor is measured side to
side. Therefore, the sensor will better
detect motion across the field of view
(side-to-side), rather than motion coming
straight at the sensor (in-and-out).
Adjust the motion sensor head so that
it detects motion moving across the
cover area. The position of the sensor
head should not exceed 45 degrees
from horizontal. Do not aim the Motion
sensor at a body of water, bushes or plants that may move in the wind,
pedestrian traffic, moving cars, Etc., as this will trigger the motion sensor.
6. When the TIMER control knob be
set at the Timer area (between “1”
and “10”, the sensor is in Auto mode
at this time), to control the light from
inside the home, activate manual
override mode by toggling the wall
light switch OFF and ON within 2
seconds. The security light will turn
on and stay on for approximately 8 hours, or until the Dusk-to-Dawn sensor
detects light in the morning. Once the Dusk-to-Dawn sensor detects light,
the manual override mode will automatically go back to its original settings
of the AUTO motion sensor.
NOTE: The higher sensitivity level increases the Likelihood of a false
activation being triggered.
NOTE: If the Sensor arm becomes loose, it will not hold the sensor head at
the joint screw on the sensor arm.
180° 45°
18,29 m/60pi
Manual Override Operating Diagram
Turn Wall switch
OFF - ON within 2 sec
Auto Mode
Turn wall switch
OFF - ON within 2sec
or
rest automatically after 8 hours
Manual
Override
Mode
