EdgeStar WAC Series Manuel de référence

EdgeStar, 8606 Wall St, Suite 1800, Austin, TX 78754

support.edgestarr.com

*Warranty service should be performed by an authorized service representative only.

Document Type: Service Bulletin

Step 1: Remove Front Panel

1.1 Disconnect unit from power supply.

1.2 Remove 2 (two) Phillips head screws that attach front panel to cabinet. The screws are located on the lower

left and right sides of the front panel as noted in the following images.

While rare, excessive vibration during shipment may cause the ribbon cable that connects the front control

panel to the control board to become disconnected. This can result in a unit that will not power on and/or may

appear to power on but will not perform all functions correctly. To remedy this issue, the ribbon cable

connection must be checked and re-connected if loose or disconnected.

Koldfront Window / Through The Wall Air Conditioner Ribbon Cable Connection

Please refer to the below instructions.

Models Covered: WAC and WTC Series Air Conditioners

Page 1 of 2

1.3 Gently release / remove panel far enough to

reveal ribbon cable that connects the control

panel to the control box within the interior

cabinet.

EdgeStar, 8606 Wall St, Suite 1800, Austin, TX 78754

support.edgestarr.com

*Warranty service should be performed by an authorized service representative only.

Step 2: Inspect the ribbon cable connection

2.1 If ribbon cable is fully disconnected as shown in the image below, simply re-connect rmly.

2.2 If upon initial inspection it appears that the ribbon cable is properly connected, it is still recommended that

you disconnect and reconnect in order to verify a rm connection.

Step 3: Test Unit

3.1 Place front panel in correct positioning to re-attach to cabinet.

3.2 Plug unit into properly rated power source.

3.3 Power on unit using control panel or remote control (depending on model).

3.4 Test to verify problem has been resolved and that all functions are working properly.

Step 4: Secure Panel to Cabinet Frame to complete repair

4.1 Unplug unit from power source.

4.2 Re-attach 2 (two) Phillips head screws to secure front panel to cabinet.

4.3 Plug unit back into power source - repair completed.

If you problem has not been resolved, please contact EdgeStar Support for additional assistance.

Page 2 of 2

Document Type: Service Bulletin

Models Covered: WAC and WTC Series Air Conditioners

It is important to always check the status of the LCDI plug when troubleshooting an air

conditioning appliance that will not power on.

- Check the LCDI plug to see if it has been tripped and needs to be reset.

- The LCDI plug can be tested for proper function by pressing the TEST button.

- Locate and press the RESET button on the plug. If the RESET button fails to function, the

power cord must be replaced.

Note: LCDI stands for ‘Leakage Current Detection and Interruption’ and is designed to detect damage to your appliance and home electrical system.

NOTE ON LCDI PLUGS

Disconnected Connected

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels EdgeStar Climatiseur

EdgeStar

EdgeStar AP8000W Manuel utilisateur

EdgeStar

EdgeStar AP10002BL Manuel utilisateur

EdgeStar

EdgeStar AP12000S-1 Manuel utilisateur

EdgeStar

EdgeStar AP16000G Manuel utilisateur

EdgeStar

EdgeStar Evaporative Air Cooler - Tower Design... Manuel utilisateur

EdgeStar

EdgeStar AP10002BL Manuel utilisateur

EdgeStar

EdgeStar EAC211TS Manuel utilisateur

EdgeStar

EdgeStar WAC8001W Manuel utilisateur

EdgeStar

EdgeStar AP1200S-1 Manuel utilisateur

EdgeStar

EdgeStar AP14001HS Manuel utilisateur

EdgeStar

EdgeStar EAC420 Manuel utilisateur

EdgeStar

EdgeStar AP16000G Manuel utilisateur

EdgeStar

EdgeStar AP14002HS Manuel utilisateur

EdgeStar

EdgeStar EAC430W Manuel utilisateur

EdgeStar

EdgeStar AP410W Manuel utilisateur

EdgeStar

EdgeStar AP16000G Manuel utilisateur

EdgeStar

EdgeStar Evaporative Air Cooler - Tower Design... Manuel utilisateur

EdgeStar

EdgeStar AP12000HS-1 Manuel utilisateur

EdgeStar

EdgeStar AP12000S-1 Manuel utilisateur

EdgeStar

EdgeStar MSPLIT12000W Manuel utilisateur

EdgeStar

EdgeStar AP13500HG Manuel utilisateur

EdgeStar

EdgeStar AP450Z Manuel utilisateur

EdgeStar

EdgeStar Koldfront CAC10000W Manuel utilisateur

EdgeStar

EdgeStar AP13500G Manuel utilisateur

Manuels Climatiseur populaires d'autres marques

Spheros

Spheros CC 355 Manuel utilisateur

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE Manuel utilisateur

Panasonic

Panasonic CS-E12HKEW Manuel utilisateur

nedis

nedis ACMB1WT7 Manuel utilisateur

Samsung

Samsung AR KV Series Mode d’emploi

Daikin

Daikin FCFV50A Manuel utilisateur

Fujitsu

Fujitsu Inverter ASBA30JFC Manuel utilisateur

Toshiba

Toshiba RAS-M10SMUV-E Manuel utilisateur

Daikin

Daikin FXLQ20MAVE Manuel utilisateur

Hitachi

Hitachi RAS-E24CAK Manuel utilisateur

CIAT

CIAT Magister 2 Series Mode d’emploi

Bestron

Bestron AAC6000 Manuel utilisateur

Hisense

Hisense 7K Manuel technique

Frigidaire

Frigidaire FFRE0533S1E0 Manuel utilisateur

Samsung

Samsung AS09HM3N Manuel utilisateur

Frigidaire

Frigidaire CRA073PU11 Manuel du propriétaire

Soleus Air

Soleus Air GB-PAC-08E4 Manuel utilisateur

McQuay

McQuay MCK020A Manuel utilisateur