10
REMOTE CONTROLLER
CEILING-FLOOR AIR CONDITIONER
NPTC / EPTC
Press the TIMER ON button again to set the desired Auto-on time. Each time you
press the button, the time increases in 30 minutes increments up to 10 hours, then
at 1 hour increments up to 24 hours.
After setting the TIMER ON, there will be a half second delay before the remote
control transmits the signal to the indoor unit. Two seconds after that, the letter “h”
will disappear and the set temperature will re-appear on the LCD.
TO SET THE AUTO-OFF TIME:
Press the TIMER OFF button. The TIMER OFF appears, the last Auto-o setting time
and the letter “h”will show on the LCD. The new time may be entered.
Press the TIMER OFF button again to set the desired Auto-o time. Each time you
press the button, the time increases in 30 minutes increments up to 10 hours, then
at 1 hour increments up to 24 hours.
After setting the TIMER OFF, there will be a half second delay before the remote
control transmits the signal to the indoor unit. Two seconds after that, the letter “h”
will disappear and the set temperature will re-appear on the LCD.
2
3
1
2
3
The correct operation of the timer is limited to the correct placement of any of the
following parameters: 0.5, 1.0, 1.5, 2.0, 2.5, 3.0, 3.5, 4.0, 4.5, 5.0, 5.5, 6.0, 6.5, 7.0, 7.5,
8.0, 8.5, 9.0, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 20, 21, 22, 23 and 24
TIMER EXAMPLE:
Power ON (TIMER ON):
The automatic ignition is used when you want to turn on the machine after a
specied time.
If you want your machine starts in 6 hours:
Press the TIMER ON button, the last scheduled time and the letter "h" will appear on
the screen.
Press the TIMER ON button to display "6.0H" on the screen.
After 3 seconds, the display will show the temperature again. And is currently
scheduled automatic start.
POWER OFF (TIMER OFF):
Use this function when you want the machine to turn o automatically after some
time of operation.
If you want your computer to turn o after 10 hours:
Press the TIMER OFF button, the last scheduled time and the letter "h" will appear
on the screen.
Press the TIMER OFF button to display "10h" on the screen.
After 3 seconds, the display will show the temperature again. And is currently
scheduled automatic shutdown.
NOTE
1
1
2
2
3
3
