Operating Your EcoForce Eliminator Elite
Unpack & inspect your EcoForce Eliminator Elite for damage – Do not use if damaged. Check all
heating elements to make sure everything works and nothing was damaged from shipping. If
damaged from shipping do not use and contact us immediately at 480-304-5649.
Your EcoForce Eliminator Elite has one (1) cord for the fan wrapped around the cord storage handle on
top of the unit. The power control plate located on the top left of the cord storage handle contains one (1)
Green switch for fan and thermostat operation, one (1) Red switch for activating the heating elements, and
one (1) digital thermostat. The heating element receptacle plate is located on the bottom left side of the
heater below the power control plate. There are four (4) 115volt 3 prong receptacles on the receptacle
plate for supplying power to the heating elements that are installed inside the heater in front of the fan.
Each heater receptacle is 1500 watts or 12.5 amps at 120 volts and can be safely connected to a 15 amp
120 volt circuit. If necessary, use a single phase 240 volt splitter box to supply power to the heater via a
240 volt electric dryer or range outlet. You can also use our hotel air conditioner splitter (Eliminator A/C
Splitter) to power two (2) of the heating elements. When using the hotel air conditioner splitter both plugs
MUST be used and MUST draw identically equal power. Do not plug A/C Splitter into anything other
than the heating element plug-ins or damage may occur.
