Eaton VoCALL 5 Manuel utilisateur

VoCALL 5

Line Exchange Unit Effective May 2019

Quick Install Guide

Retrot compatibility

If you are replacing an existing EVCS system with this unit then a test

for compatibility must be carried out on the outstations, and any units

which do not function as expected must be replaced with new units.

This advice also applies to all roaming handsets.

Installation

1. Using a Phillips head screwdriver, open the front cover by

removing the 2 screws along the bottom edge of the panel.

Then lift the cover from the bottom edge and push up in order

to disengage the latching clips on the top edge.

2. Before mounting the VoCALL 5 on the wall it is advisable to

remove the cable knockouts. Unused knockouts must be left

unopened to comply with the Low Voltage Directive (LVD),

accidentally knocked out holes should be blanked off.

3. Fix the back box to the wall using the measurements provided

below. Do not drill through the back box to the wall as this will

contaminate the circuitry.

Knockouts

Top: 9 x 20mm

CAUTION

DO NOT power up the unit on batteries as the power

supply has a large reservoir capacitor which may rupture

the battery fuse if the AC is not present when powering

up the system.

2.3.

QUICK INSTALLATION GUIDE 25-16389-B May 2019

Full User Manual and Log Book

available at: www.eaton.com/VoCALL5

4. Wire the mains connection according to the

diagram overleaf.

5. Wire the outstations according to the diagram overleaf.

6. Finally, wire the batteries according to the

diagram overleaf.

ote:N The VoCALL 5 is supplied without batteries which should

be procured separately and be of adequate capacity to

meet local regulations.

Mounting Holes

190mm

150mm

237mm

Quick Installation Guide

Effective May 2019

QUICK INSTALLATION GUIDE 25-16389-B May 2019

Eaton

EMEA Headquarters

Route de la Longeraie 7

1110 Morges, Switzerland

Eaton.eu

TEL: +44 (0) 1302 321541

FAX: +44 (0) 1302 303220

[email protected]

Firetec[email protected]

Eaton is a registered trademark.

All trademarks are property

of their respective owners.

www.Eaton.com

Eaton Electrical Systems Ltd.

Wheatley Hall Road

Doncaster

DN2 4NB

TEL: +44 (0) 1302 303303

FAX: +44 (0) 1302 367155

MASTER

HANDSET

TO MASTER

HANDSET

OUTSTATION

CONNECTIONS

VOLT-FREE

OUTPUTS

OUTSTATION 1

OUTSTATION 2

OUTSTATION 3

OUTSTATION 4

OUTSTATION 5

FAULT

IN-USE

ENABLE

FLT13

FLT14

P3 P4

3K9 3K9 3K9

P5 P6 P8 P7 P10

Main Distribution Board

230V AC +10%/-15%, 50Hz

>0.75mm2<2.5mm2

VoCALL 5

Autres manuels pour VoCALL 5

Autres manuels Eaton Panneau de contrôle

Eaton

Eaton BreakerVisu NZM-XMC-MDISP35-MOD Manuel

Eaton

Eaton DF6200 Guide de l'utilisateur

Eaton

Eaton FX6000 Manuel utilisateur

Eaton

Eaton MEMSHIELD 4 Manuel utilisateur

Eaton

Eaton DF6000 Guide de l'utilisateur

Eaton

Eaton JSB FX4200 Series Manuel utilisateur

Eaton

Eaton Greengate LiteKeeper 8 Manuel utilisateur

Eaton

Eaton E Series Manuel utilisateur

Eaton

Eaton Crouse-Hinds SynergEX EZFlex Series Guide de configuration

Eaton

Eaton EFCV8ZONE Manuel utilisateur

Eaton

Eaton COOPER POWER SERIES Manuel utilisateur

Eaton

Eaton InsulGard Mode d’emploi

Eaton

Eaton Cuttler-Hammer FDAP-M Manuel utilisateur

Eaton

Eaton 500 Manuel utilisateur

Eaton

Eaton DX-KEY-LED2 Manuel

Eaton

Eaton PanelMate 5000 Series Manuel utilisateur

Eaton

Eaton Cutler-Hammer PanelMate 3000 Series Manuel utilisateur

Eaton

Eaton Cutler-Hammer PanelMate Manuel utilisateur

Eaton

Eaton BiWire Flexi Manuel utilisateur

Eaton

Eaton BiWire Flexi Manuel utilisateur

Eaton

Eaton DALI Manuel utilisateur

Eaton

Eaton XV300 Series Manuel utilisateur

Eaton

Eaton BreakerVisu NZM-XMC-MDISP35-MOD Manuel utilisateur

Eaton

Eaton BreakerVisu NZM-XMC-MDISP35-MOD Manuel

Manuels Panneau de contrôle populaires d'autres marques

RDZ

RDZ PC-HRX Manuel utilisateur

STG-BEIKIRCH

STG-BEIKIRCH MZ3 Manuel technique

Efka

Efka Variocontrol V810 Manuel utilisateur

Cebora

Cebora 208-10 Manuel utilisateur

AMX

AMX AutoPatch CP-15 Manuel utilisateur

Satel

Satel CA-6 KLED-S Manuel utilisateur

Evolution

Evolution IQ plus 800 Manuel utilisateur

Fagor

Fagor 8040 TCO CNC Manuel utilisateur

Trane

Trane ComfortLink II XL950 Control Manuel utilisateur

AKO

AKO PROCool AKO-17635-2 Manuel utilisateur

ABB

ABB 6136/30M-101 Manuel utilisateur

Telikou

Telikou BK-603 Belt Pack Manuel utilisateur

Mapei

Mapei Mapeheat Thermo Touch Manuel utilisateur

Bosch

Bosch D9412GV4 Manuel utilisateur

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries SC-SL4-AE2/1 Manuel utilisateur

Sminn

Sminn BOX L VF1L EI Manuel utilisateur

Balboa

Balboa TP600 Manuel utilisateur

Nice

Nice HSCU1 Caractéristiques techniques