Easymount SIGN Manuel utilisateur
ASSEMBLY
INSTRUCTIONS
In your stand box you should have the below parts:
The Middle Support Beam is Slightly Longer than the Top.
Using 4 x longer bolts, attach the bottom support beam to the left and right stand frames.
Using 4 x smaller bolts, attach the middle support beam [this is the longest support bar].
Using the Last 4 x Longer bolts attach the top support beam.
Ensure all bolts are tightened fully and place the 2 x mandrels in the holders.
Place the Laminator on the stand.
The Parts left in your Machine Crate are Below [excluding the lifting handle bag and Elements].
Attach the Left and Right Mandrel Support holders to the machine using the bolts supplied and place
the mandrels in the supports as shown in the pictures below.
Remove Left and Right side covers off the laminator.
Remove the rubber sport below and Insert the Quartz Heating Element. Once Element is fitted
please return the element support back into position.
Remove the Green Rubber sleeve on the left and right and attach the wire to each end of the
element, ensuring there is a washer either side of the terminal as shown in the pictures below.
Place end caps back on to the element.
Move the laminator to where the machine will be situated, please note all 4 wheels must be on a
level floor for the roller pressure to be level.
To check the roller pressure, place a small piece of card in the centre of the roller and lower the
roller down. Once in the down position check the gap in between the rollers on the left and right,
these should be the same, if not please see the next page.
If the rollers are level, please put the side covers back onto the laminator.
Once the side covers are on please put the lifting handle and key in place and secure using the bolt
provided.
Easymount Sign: Adjustment of Roller Gap & Pressure
1).
Using a 2.5mm Allan-key undo the 6 screws to take the left side panel of the machine.
2).
Take off the emergency stop button by unscrewing the screw above.
3).
Take off the screw and large washer above.
Ce manuel convient aux modèles suivants
1
Autres manuels Easymount Plastifieuse
Easymount
Easymount Air EM-A1600SH Fiche technique
Easymount
Easymount Sign EM-720 Fiche technique
Easymount
Easymount Single Hot EM-1600SH Fiche technique
Easymount
Easymount Sign EM-S1400C Fiche technique
Easymount
Easymount EM-S880 Fiche technique
Easymount
Easymount EM-1200 Fiche technique
Easymount
Easymount EMS-650 Fiche technique
Easymount
Easymount Cold EM-1400 Manuel utilisateur
Easymount
Easymount EM-1200DH Fiche technique
