E2S D1*CP1-PS Series Manuel utilisateur

D1xCP1-PS SERIES

EXPLOSION PROOF MANUAL PULL STATIONS

The D1xCP1-PS Series of Explosion Proof Manual Pull Stations is UL and FM listed for use in

hazardous environments, and for Nema Type 4X weatherproof applications. The unit also complies

with ADA standards when installed at less than 48 inches above the floor for front wheelchair access,

and less than 54 inches for side wheelchair access. All Installations must comply with local codes and

regulations.

Ratings: Listed By: UL, FM, CSFM, MEA

Enclosure: Class I, Groups B, C, and D. Class II, Groups E, F, and G. Class III.

NEMA 4X (Weatherproof), MARINE.

Contacts: D.P.D.T 10 Amps, 120 VAC

1 Amp, 30 VDC

Installation:

(Please refer to assembly diagram and installation notes on the back side)

The D1xCP1-PS model station includes a front housing, a back box, a switch plate, and all the

necessary hardware to assemble the station.

•Install the back box onto its mounting surface using the 4 holes provided on the mounting tabs. The

tabs are designed to accept a screw size of up to 1/4".

•The back box is supplied with two 3/4"-14 NPT conduit entries. Threaded joints between conduit and

back box must be made with a minimum of 5 threads fully engaged. Seal unused conduit entry with a

UL listed close-up plug for use in the hazardous locations listed above in the ratings section. Joint

sealing material may be used if it is a non-drying slushing compound, petroleum jelly or soap-thickened

mineral oil.

•Connect the field wiring to the terminal blocks on the adaptor plate. Use the insulated terminal lug

supplied to ground the box properly. Each wire or terminal lug must be placed under its corresponding

clamping plate for proper connection.

•Install the switch plate onto the back box using the 4 1/4-20x7/8 pan head screws provided. Make

sure that the o-ring seals on the screws and around the edge of the switch plate are properly seated.

•Open the front housing, align its mounting plate with the pins provided on the switch plate and attach

it using the two 6-32 screws provided into the slotted holes.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels E2S Système de sécurité

E2S

E2S IS-L101L-R/Y Manuel utilisateur

E2S

E2S MBLD2 Series Manuel utilisateur

E2S

E2S SPECTRA H100 B Manuel utilisateur

E2S

E2S WP6-BG Manuel utilisateur

E2S

E2S D1xC3 Manuel utilisateur

E2S

E2S D1xS1 Series Manuel utilisateur

E2S

E2S Appello A121APPX Manuel utilisateur

E2S

E2S SPECTRA H110 T Manuel utilisateur

E2S

E2S GNExS1 Manuel utilisateur

E2S

E2S BExCS110-L2 Manuel utilisateur

E2S

E2S BExCTS110-05D-P Manuel utilisateur

E2S

E2S D2xB1XH1 Manuel utilisateur

E2S

E2S GNExCP7-BG-S Manuel utilisateur

E2S

E2S A131 Manuel utilisateur

E2S

E2S D1xB2LD2 Series Manuel utilisateur

E2S

E2S STExCP8-BG-D Manuel utilisateur

E2S

E2S D1 B2X05 Series Manuel utilisateur

E2S

E2S GNExCP6B-PT Manuel utilisateur

E2S

E2S IS-mA1M Manuel utilisateur

E2S

E2S APPELLO A121AX Manuel utilisateur

E2S

E2S D105AX Manuel utilisateur

E2S

E2S BExBG05D-P-SIL Manuel utilisateur

E2S

E2S D1xS1F Manuel utilisateur

E2S

E2S BExBG05 Series Manuel utilisateur

Manuels Système de sécurité populaires d'autres marques

Inner Range

Inner Range Concept 2000 Manuel utilisateur

Climax

Climax Mobile Lite R32 Instructions de montage

CADDX

CADDX NX-6 Manuel utilisateur

FBII

FBII XL-31 Series Manuel utilisateur

Johnson Controls

Johnson Controls PENN Connected PC10 Manuel utilisateur

Aeotec

Aeotec Siren Gen5 Manuel utilisateur

Blaupunkt

Blaupunkt SA 2700 Manuel utilisateur

IDEAL

IDEAL Accenta Manuel du propriétaire

AJAX

AJAX DoubleButton Manuel utilisateur

Swann

Swann SW-P-MC2 Manuel utilisateur

Ecolink

Ecolink Siren+Chime Manuel utilisateur

Digital Monitoring Products

Digital Monitoring Products XR150 Manuel utilisateur

EDM

EDM Solution 6+6 Wireless-AE Manuel utilisateur

Highway Safety Group

Highway Safety Group EA401 Manuel utilisateur

Siren

Siren LED GSM Manuel utilisateur

Detection Systems

Detection Systems 7090i Instructions de montage

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Manuel utilisateur

Siemens

Siemens FDM273 Manuel utilisateur