E-Z UP Bungalow Manuel utilisateur

TABLE OF CONTENTS

Intro.......................................................................................2

Set-up Instructions.....................................................................3

Care and Maintenance.............................................................7

ImportantInformation................................................................7

Take Down Instructions..............................................................8

Accessories.........................................................................10

Warranty and Registration.....................................................11

THANK YOU...

for your purchase of

the Bungalow by

E-Z UP®. For over

20 years, E-Z UP®

customers have been

thrilled with their

E-Z UP®experience.

To ensure your

complete satisfaction, take the time to learn how to operate the

Bungalow®by carefully reviewing these set-up and care instructions.

HOW TO SET UP

INSTRUCTIONS

STEP 1

STEP 2

Please read each step before you attempt to set up. Save these instructions

for future reference.

NOTE - First time top and frame attachment is required

Top and frames are shipped separately to avoid damage. A ﬁrst time set up

requires that the main frame and sub frame be assembled together and the top

to be attached to the frame. This ﬁrst time will take longer than future set ups.

Once top is permanently attached to frame, set up and take down can be easily

accomplished within minutes.

With a partner, gently expand the main

frame and sub-frame to approximately

half of its fully opened position. Face

open ends of trusses toward each other.

Attach the main frame to the sub-frame

at four points. The outside end of each

truss is marked with either an “A” or a

“B” label. Locate these labels as well as

the “A” “B” labels on the main frame

angle brackets. Attach “B” truss to the

adjoining “B” endcap with the bolts and

tools provided. Attach eyelet of cable as

shown. Tighten the bolts securely. Do not

over tighten bolts - ensure they can still

rotate easily. Repeat this procedure for

the “A” label.

Main

Frame Sub

Frame

STEP 3

When attaching part “A” to part

“B”, ensure the cables are attached

as shown.

STEP 4

Use the bolts and tools provided to

connect the part “B” peak assembly to

the part “A” hub in three locations.

STEP 5

Place your Bungalow® by E-Z UP®frame

in the center of area to be shaded. With

one or two partners on opposite sides,

grasp outer legs, slightly lift shelter off

the ground and step backwards stopping

at full arms’ length.

STEP 6

Unfold the fabric top and place it over the

open frame. Align the six corners of the

top over the six corners of the frame.

STEP 7

To secure the top to frame, align grommet

holes on valance with bolts in frame.

HOW TO SET UP

STEP 8

Unscrew top attachment nut from bolt. Place

grommeted fabric top over the bolt, install

top attachment nut and tighten until snug.

Top should rotate easily - Do not over

tighten. Repeat on remaining grommets.

STEP 9

With partner, grasp the bottom of the

diamond shaped area of trusses on

opposite sides of the shelter. Lift up and with

partner begin to open shelter by stepping

backwards stopping at no more than one

arms’ length each.

IMPORTANT: If shelter starts to distort,

return shelter to hexagon shape, and repeat

step 9. Complete steps 9A - 9D.

STEP 9A

Move to the next adjacent side, with partner moving to the

opposite side. Lift up and with partner A., continue to open by

stepping backwards no more then one foot each.

STEP 9B

Move to the next adjacent side with partner A., moving again

to the opposite side lift up and continue to open by stepping

backwards no more than one foot each.

STEP 9C

Move to next adjacent side. Shelter should be very close to

being open. Do not force shelter open. Smaller steps will

prevent frame distortion. When shape starts to distort,

you have gone too far.

STEP 9D

You may need to continue to repeat steps 9A or 9B until shelter

is fully open.

Distorted

Hexagon Yourself (B)

Partner (A)

(A)

(B)

(A)

(B)

(A)

Fabric Top

STEP 10

Engage the Auto Slider® at each corner

by pushing up on trusses with one hand

while holding down the top of the leg

with other hand. The quick pin will

engage the hole.

STEP 11

Use peak extension pole to push up

center hub, extending top frame structure.

Push up until two inner peak tubes lock.

Continue push up motion until all six

sides snap in place.

WARNING: Do not let go of center

hub until at least two sides are locked.

Complete peak structure must be locked

before using shelter.

STEP 12

Secure the top to the frame by pulling

the hem down and matching Quick

Attachment Straps on the top with the

Quick Attachment Strips on the frame.

Push the Quick Attachment Straps ﬁrmly

together at each corner.

HOW TO SET UP

STEP 13

Secure all inner peak tubes with quick

release pins.

STEP 14

Carefully lift up adjacent outer legs and

slide out the inner legs until snap button

locks. Repeat on opposite legs. Be sure

to adjust two legs at a time to avoid

frame damage.

STEP 15

Once the shelter is fully raised to the

desired height setting, secure all legs

with quick release pins.

NOTE: Once top is permanently

attached, only perform STEPS 1

and 9 - 15 to set up.

CARE & MAINTENANCE

For long lasting durability and the best possible protection for

your Bungalow®shelter, follow these care and maintenance

instructions:

Bungalow®Sunbrella®top features a soil-and stain-resistant ﬁnish

that makes clean-up a breeze. Spot wash by sponging briskly with a

soapy solution of natural soap in lukewarm water. Rinse thoroughly

with clean water to remove soap and air dry. For stubborn stains,

use a fabric spot remover. Follow directions on container. Rinse

thoroughly with clean water and air dry.

Let the Bungalow®top and frame dry completely before closing or

storing to avoid mildew.

Frame will operate and look better if occasionally wiped with

silicone spray, especially before and after use in damp conditions.

Remove excess silicone residue before applying top.

Use a seam sealer if top leaks or drips water. Available at most

hardware or sporting goods stores.

Slightly tighten bolts if frame becomes loose.

IMPORTANT INFORMATION

IMPORTANT: Read this information before proceeding. It is

the user’s responsibility to take the following precautions at

all times.

Use caution when handling the Bungalow®folding frame. Avoid

pinching hands or ﬁngers as frame opens or closes.

Always stake or weight down your Bungalow®. Do not

use in any potentially windy or rainy weather. Wind, rain and

snow can damage the Bungalow®and may also result in injury

to you or others. Therefore, do not rely on shelter for protection in

heavy or prolonged weather storms.

Do not use shelter in a lightning storm.

The Bungalow by E-Z UP®is designed as a seasonal shelter.

Keep all ﬂame and heat sources away from fabric top. Do not

build ﬁres within shelter enclosure.

HOW TO TAKE DOWN

TAKE DOWN INSTRUCTIONS

STEP 1

With partner, disengage quick release

pins. Depress snap button toggle on legs

and telescope inner legs into outer legs.

Repeat on other legs, making sure to do

two legs at a time.

STEP 2

Stand under shelter and locate center

hub. Disengage quick release pins.

While holding center peak pole, release

top frame inner peak beams by pushing

snap buttons one at a time on all top

frame inner peak beams to disengage.

WARNING: After all peak beam

assembly snap buttons are released

GENTLY lower center hub. Center hub

should drop down in an inverted position

and rest near the ground.

STEP 3

Release Auto Slider®at each corner by

ﬁrst lifting hem of top. With one hand,

push up on truss near slider, release

quick pin by pulling ring.

STEP 4

With one or two partners at opposite

sides of shelter make sure peak beam

assembly snap buttons are disengaged.

Lift shelter up slightly and shake while

stepping toward one another until shelter

is fully closed. Be careful not to pinch

ﬁngers. Store shelter in cover bag.

Snap Button

Quick

Release

ACCESSORIES

SUN SCREEN VENT TOP

SCREEN ROOM DELUXE STAKE KITS

CONVERTIBLE SIDEWALLS DELUXE

WEIGHT

BAGS

ACCENTED

TIE-BACKS

Table des matières

Autres manuels E-Z UP Tente

E-Z UP

E-Z UP INSTANT SHELTER Manuel utilisateur

E-Z UP

E-Z UP PATRIOT 10' X 10' INSTANT SHELTER Manuel utilisateur

E-Z UP

E-Z UP INSTANT SHELTER Manuel utilisateur

E-Z UP

E-Z UP Instant Shelter Endeavor Manuel utilisateur

E-Z UP

E-Z UP INSTANT SHELTER SPEED SHELTER II Manuel utilisateur

E-Z UP

E-Z UP Hi-Viz HV910BOR Manuel utilisateur

E-Z UP

E-Z UP Endeavor Manuel utilisateur

E-Z UP

E-Z UP Vantage Manuel utilisateur

E-Z UP

E-Z UP Instant Shelter Eclipse II Manuel utilisateur

E-Z UP

E-Z UP Instant Shelter Escort Manuel utilisateur

E-Z UP

E-Z UP INSTANT SHELTER SPRINT Manuel utilisateur

E-Z UP

E-Z UP Instant Shelter Express III Manuel utilisateur

E-Z UP

E-Z UP Instant Shelter Escort Manuel utilisateur

E-Z UP

E-Z UP Eclipse II Professional Manuel utilisateur

E-Z UP

E-Z UP Instant Shelter Pyramid II Plus Manuel utilisateur

E-Z UP

E-Z UP INSTANT SHELTER Manuel utilisateur

Manuels Tente populaires d'autres marques

OZTENT

OZTENT JV SIGNATURE EDITION Manuel utilisateur

GigaTent

GigaTent Summer Chalet Mini Tent Manuel utilisateur

Coleman

Coleman 2000007827 Manuel

ShelterLogic

ShelterLogic 107153 Manuel utilisateur

Outsunny

Outsunny 84C-230 Manuel utilisateur

Napier

Napier SPORTZ COVE 61 Series Manuel utilisateur

EuroTrail

EuroTrail ATLANTIS PRO Manuel utilisateur

Reimo

Reimo Marina Manuel utilisateur

TiiTENT

TiiTENT TB300 Manuel utilisateur

Coleman

Coleman 2000033134 Guide d'installation

Ozark Trail

Ozark Trail W784.1 Guide de démarrage rapide

SlingFin

SlingFin CrossBow 2 Manuel utilisateur

Coleman

Coleman 9600-141 Manuel utilisateur

Palram

Palram Arizona 5000 Wave - WINGS Manuel utilisateur

COVERPRO

COVERPRO 56184 Instructions de montage

Vango

Vango Zenith 100 Manuel utilisateur

Costway

Costway PATIOJOY OP70818 Manuel utilisateur

Clarke

Clarke PUC 88 Manuel utilisateur