Instructions for use
Texts marked with this symbol indicate special dangers or mark work which requires
special caution.
This manual contains a general description of the system, as well as instructions for installation
and operation. The system also examines the specificity of the system.
Use the table of contents to find the information you need quickly and securely.
This operating manual is an integral part of the system and must be handed over to the new
operator when the system is sold.
Intended use
The DYNACUT-MDE minimum quantity lubrication must only be used and used
according to the instructions given in the operating instructions.
In particular, we would like to point out that hazardous substances of any kind, especially
substances classified as dangerous according to EC Directive 67/548 / EEC, Article 2, paragraph
2, as well as liquids such as chlorinated hydrocarbons, solutions with alcohol contents of more
than 30% Gasoline, nitro lacquers and nitro diluents (solvent mixtures for nitro lakes from
hydrocarbons and esters) and concentrated acids must not be filled into and distributed with
DYNACUT minimal-quantity lubrication systems and components and / or distributed with
them.
The minimum quantity lubrication system described here is intended exclusively for the
external lubrication of machining and forming processes. During external lubrication, the
lubricant is transported directly to the friction point between tool and workpiece via spray
nozzles, which are attached to the machine tool. Depending on the type of processing, one or
more spray nozzles per tool can be used.
The DYNACUT-MDE minimum quantity lubrication system can be used both for the initial
equipment of processing machines and for the retrofitting of processing machines with an
existing cooling lubricant supply.
Any other use or use beyond this is considered to be improper. Dynacut UG is not liable for
damages resulting from this.
