Dynabrade 40381 Manuel utilisateur
Disassembly Instructions - 0.4 hp, Dynafile II Slow Speed
Model: 40381
Notice: Use these instructions along with tool manual. See also, Dynafile II, 0.4 hp
Motor, found under Repair Tutorials on the Dynabrade website.
Important:
Shut off air supply and depress throttle lever to deplete air.
Disconnect tool from air supply hose.
Use 3 mm hex key to loosen 95311 Screw and remove motor from belt housing.
Use a small adjustable wrench to hold 40358 Adapter stationary. By hand remove
40375 Drive Wheel. Turn counterclockwise.
Motor Disassembly:
Planetary Gear Disassembly:
1. Use 96461 Repair Collar to hold housing in a vise with 40358 Adapter pointing up.
96461 Repair Collar
2. Use 50971 Lock Ring Tool to remove 40359 Exhaust Cover.
Turn counterclockwise.
Use a 2 mm hex key to remove 50784 Set
Screw.
Remove planetary gear assembly.
3. Fasten 96346 Bearing Separator between bearing and ring gear. Face flat side of
separator toward ring gear and bevel side toward bearing.
Flat side of 96346 Separator toward ring gear.
4. Use a 5/16" flat-end drive punch as a press tool and 96232 Arbor Press to push the
planetary carrier out of the 54552 Bearing.
5/16" flat-end Drive Punch
and 96232 Arbor Press
5. Remove the ring gear.
To remove shafts and planet gears, gently tap the carrier on a hard surface.
The shafts and gears will fall out.
6. With planetary carrier pointing up, carefully fasten 40358 Adapter in vise with
aluminum or bronze jaws.
Insert a screwdriver through carrier and turn counterclockwise to remove adapter.
7. Use arbor press and 5/16" flat-end drive punch as a press tool to push the planetary
carrier out of the remaining 54552 Bearing.
Planetary gear disassembly completed.
Important: Clean and inspect parts before assembling.
Motor Disassembly:
1. Pull motor from housing.
2. Remove 02679 Shield from 02696 Bearing.
3. Fasten 96346 Bearing Separator (2") around 01476 Cylinder.
Place bearing separator and motor in 96232 Arbor Press (#2) with pinion
pointing down.
Use a Ø 3/16" or ~4 mm flat-end drive punch to push rotor out of bearing.
Remove cylinder and vanes.
Autres manuels Dynabrade Accessoires pour outils électriques
Manuels Accessoires pour outils électriques populaires d'autres marques
ADAMAS
ADAMAS B32 Manuel utilisateur
STEINEL PROFESSIONAL
STEINEL PROFESSIONAL 4007841009595 Manuel utilisateur
Echo
Echo Speed-Feed Universal 400 LH/RH Manuel utilisateur
SCHUNK
SCHUNK ROTA TB-TBS-EP Instructions d'utilisation
Schmid
Schmid RAPID Secure XL Manuel utilisateur
Drill Master
Drill Master 360X Manuel utilisateur
