DS18 JK-HARNESS Manuel utilisateur

JK-HARNESS

USER MANUAL

A. Pin Remover

B. #2 Philips Screwdriver

C. ¼ Drill Bit

D. 7mm Socket

E .10mm Socket

F. 18mm Socket

G. T27 Socket

H. T40 Socket

I. Impact wrench

Equipment you will need

(Not included in the kit)

• SQBASS (active subwoofer)

• 2X Candy4 (4 Ch amplifier)

• SQBASS Brackets • Amp Rack

X-4, M5x16mm

screws, and nuts X-4, 2x8mm

screws X-8, 3.5x8mm

screws, and nuts

• JK Soundbar Wiring Kit Harness

for JEEP: SERIES

Item included:

Tools required:

JK-HARNESS

ATTENTION

Installation of mobile audio and video components requires experience with a variety of

mechanical and electrical procedures. Although this manual provides general installation and

operation instructions, it does not show the exact installation methods for your vehicle. If you

do not have the required knowledge and experience to successfully complete the installation,

consult an authorized dealer about professional installation service.

ATTENTION

Disconnect the negative post (Ground) of the battery before you start the installation. This

helps avoid airbags coding and malfunctions, codes module malfunction or any electrical

issues

Under Seat Amp and SQBass Rack / Bracket

INSTALLATION

Remove the belt screw from the seat using a T40 socket, then you can remove the seat from

the Jeep and put it on this position for easy access under the seat.

Starts with removing the bolts of the Driver seat using the 18mm socket with an impact

wrench tool.

JK-HARNESS

Locate the Connector holder plate

and remove it using the clip remover

for the connector and the T27 socket

for the two screws that hold it.

Relocate this wiring under the seat to one side using the same pin spots as you can see in

the picture.

Locate the SQBASS Bracket “A” and secure it on the SQBASS using the “B” screws supplied

and tight them just enough but not too hard (Screw can break easy).

Using the ¼Drill Bit open up this two holes where the factory bolts was located, then locate

the SQBASS bracket “B” and secure it using a pair of the “A” screws but do not tight

them yet.

Locate the SQBASS under the seat and use a pair of “A” screws and secure the bracket

but do not tight them yet, then using the “B” screws secure the other side of the SQBASS

to the bracket “B” as you can see in the picture.

JK-HARNESS

Now it’s time to install the amplifiers to the Amp Rack using the supplied “C” screws, tight

them well using a 7mm socket and the #2 Philips screwdriver. Check the position of the

amp as you can see in the picture for easy wiring access, before putting this under the seat

you can go ahead and install the speaker and amplifier wiring, this is an easy way to access

the terminals

Slide in the bracket into the gap between the SQBASS bracket and the seat bracket and

tight up all the screws using a 10mm socket with the impact wrench.

Now it’s time to connect all the wires for

the SQBASS and the amplifiers then get

ready to put back the seat into the Jeep

and route the rest of the wiring: (1) Ground

and to the engine bay for battery power,

(2) for the Radio in the Dashboard, (3) to

the roof soundbar.

SOUNDBAR SPEAKER SIDE FACTORY

SOUND

LED-BTC

SOUNDBAR

AMP SIDE

AMP

RADIO

SUBWOOFER

FUSE

HOLDER

BATTERY

AMP SIDE

RADIO

SIDE

JEEP JK/JKU Sound Bar + Amp +

Under Seat SubWOOFER Wiring Harness Kit Installation

JK-HARNESS

Radio side Installation

using Factory OEM Radio (Without RCA pre-output)

A- Connect the DS18 T-Harness connector between the factory

radio unit and the radio harness.

B- Factory radio Harness

C- Factory radio unit

D- DS18 Harness (Radio Side)

1- Front Audio Input connector (white/gray)

2- Rear Audio Input connector (green/violet)

3- Subwoofer Audio Input connector (red/white)

4- Front Speaker output connector (white/gray)

5- Rear Speaker (Tweeter/driver) output connector (green/violet)

6- Remote wire to power on the amplifiers

AUDIO

OUT

AUDIO

REMOTE

FACTORY RADIO

HARNESS

DS18

T-HARNESS

RADIO

FACTORY

RADIO

DS18 HARNESS

(RADIO SIDE)

Radio side Installation

using Aftermarket Radio (With RCA pre-output)

FACTORY RADIO

HARNESS

DS18

T-HARNESS

RADIO

HARNESS

ADAPTER

(Not Included)

AFTERMARKET

RADIO

SUPPLIED RCA

CONNECTOR

FRONT REAR SUB-W

DS18

HARNESS

(RADIO SIDE)

2 1

NOT

CONNECTED

REMOTE

JK-HARNESS

Table des matières

Autres manuels DS18 Intervenants

DS18

DS18 HYDRO CF-8M Manuel utilisateur

DS18

DS18 RYDERBT Manuel utilisateur

DS18

DS18 PRO-TSQ Manuel utilisateur

DS18

DS18 10OCT500-8 Manuel utilisateur

DS18

DS18 JVOCE Manuel utilisateur

DS18

DS18 6XL600-8 Manuel utilisateur

DS18

DS18 Hydro MP4TPBT Manuel utilisateur

DS18

DS18 ZXi-112LD.RG Manuel utilisateur

DS18

DS18 G5.7Xi Manuel utilisateur

DS18

DS18 6XL650N-8 Manuel utilisateur

DS18

DS18 EXL-SQ4 Manuel utilisateur

DS18

DS18 12XL1500-8 Manuel utilisateur

DS18

DS18 12XL1500-4 Manuel utilisateur

DS18

DS18 G6.5XI Manuel utilisateur

DS18

DS18 PRO-X8.4RGBCAP Manuel utilisateur

DS18

DS18 SLC-N69X Manuel utilisateur

DS18

DS18 PRO-68XA Manuel utilisateur

DS18

DS18 SLG-HD6LD Manuel utilisateur

DS18

DS18 G4.6Xi Manuel utilisateur

DS18

DS18 12PRO1400MB-8 Manuel utilisateur

DS18

DS18 G5.25Xi Manuel utilisateur

DS18

DS18 NXL-X10TPNEO Manuel utilisateur

DS18

DS18 CF-8m Manuel utilisateur

DS18

DS18 6XL650N-4 Manuel utilisateur

Manuels Intervenants populaires d'autres marques

argon audio

argon audio IE20 Manuel utilisateur

Denon

Denon SC-N7 Manuel utilisateur

Gemline

Gemline Ace 3952 Manuel utilisateur

Focal

Focal ON WALL 300 Mode d’emploi

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manuel utilisateur

SoundLogic

SoundLogic BCCS-6/6395 Manuel utilisateur

Peavey

Peavey DTH 218 Manuel utilisateur

Avantree

Avantree Pluto Air Manuel utilisateur

Morel

Morel Integra Series INTEGRA OVATION 4 Manuel utilisateur

Oppo

Oppo SONICA Manuel utilisateur

Bose

Bose SoundLink Wireless Music System Manuel utilisateur

Rocksteady

Rocksteady Stadium Manuel utilisateur

Bowers & Wilkins

Bowers & Wilkins 4 Manuel utilisateur

Sonance

Sonance SONOS OUTDOOR Series Manuel utilisateur

Electro-Voice

Electro-Voice EVID FM4.2 Manuel utilisateur

Pioneer

Pioneer XW-HTD630 Manuel utilisateur

Onn

Onn BWA16AA002 Manuel utilisateur

HP GL313AA - USB Speakers PC Multimedia Manuel utilisateur