Drop X Manuel utilisateur
INSTALLATION AND OPERATING INSTRUCTIONS
DROP POOLS
• Drop pool
• Winter insulation cover
• Pool chemical starter kit
CONTENTS OF THE
OUTDOOR SPA POOL
PACKAGE
The manufacturer retains the right to change the product’s assembly or structure
without separate notice and without any obligation arising from this.
These instructions contain important information on the installation,
operation, and servicing of the pool. Please read through the instructions
carefully before installing and starting up a new pool. Keep the
instructions for future reference. If you are uncertain, please contact
Drop’s customer service department.
SAFETY
Use of the pool requires compliance with the safety instructions set out in these user
instructions. Be vigilant, use your common sense and make sensible decisions in all
actions related to water.
• In order to prevent drowning and serious injury, the access of
children under the age of 5 to the pool must be restricted.
• Children may not use the pool without adult supervision.
• When using the pool with small children, check the suitability of
the water temperature.
• Diving is not allowed in the pool. Never jump into the pool. It
may lead to a serious injury or even death.
• Remove the pool’s cover fully before entering the pool.
• Do not heat up the water too much. The recommended water
temperature is 37 °C.
• It is recommended that people with heart problems keep the
water temperature below 37 °C.
• Donotusethepoolundertheinuenceofalcoholormedications
that may jeopardize safe use of the pool. Use of the pool under the
inuenceofthesubstancesmentionedaboveisattheuser’sown
risk.
• Do not bring electrical devices closer than 2.5 meters from the
pool. Neglecting to keep a safe distance increases the risk of
electric shock and may cause a serious injury or even death.
• We recommend that a continuous bathing session be no longer
than 30 minutes in length, after which you should cool down for
5–10 minutes.
• The surface of the pool may be very slippery. Be careful when
entering and exiting the pool.
• Do not remove or plug the suction drains or use the pool without
the drains or if the drains are broken.
• Keep the chemicals (e.g., water treatment or cleaning chemicals or
disinfectants) out of the reach of children.
• Keep the pool cover closed and locked when the pool is not in use.
• Do not stand, sit, lean, or place weight on the cover.
CONSIDERATIONS
BEFORE RECEIVING
THE POOL PACKAGE
Carefully familiarize yourself with the pool’s dimensions and, if necessary, ask
our customer service department for assistance with planning your pool site. The
pool’s placement must be planned well with regard to the comfort and safety of
use. The pool should be placed in an open spot if possible. Otherwise, leaves falling
from trees and other dirt may easily end up in the pool water during bathing ses-
sions. In densely populated areas, you should take your neighbors into account.
The pool must be installed and stored in such a way that it rests on its frame. Do
not lower the pool to rest on its top edge or have the pool resting against a terrace,
for example, in such a way that the top edge carries the pool’s weight. The plans are
indicative examples of installation.
Pool base and service hatch
Each site must be designed according to the situation and place. Special attention
must be paid to the realization of the pool base. The base must be level, load-bear-
ing and horizontal. The most suitable bases are made of concrete, gravel, wood
or some other hard base material. The base must be able to withstand a weight of
2,500kgwithoutsinkingordeforming.Pleasetakeintoconsiderationtheeectof
frost when designing the base.
There must be no less than 50 cm of space around the outdoor spa pool for any
required servicing measures. It must be possible to open the service hatches located
on each side of the pool without impediment. If you want to sink the pool into a
terrace, you will need to make separate service hatches in the terrace on each side of
the pool. The service hatches must allow the pool’s side panels to be opened and
provide enough room to work next to the pool if necessary. The manufacturer is
not liable for any damage caused by an incorrectly installed pool.
SERVICE HATCH
There must be no less than 50 cm of space around
the outdoor spa pool for any required maintenance measures.
Service hatches on each side of the pool should be possible to open in case of maintenance
RECEIPT OF
DELIVERY
Please check the package externally before acknowledging receipt. Any observed
external damage caused during transportation must be immediately reported
to the courier or our customer service department. All damage caused during
transportation must be reported within a maximum of seven days in writing to the
addressdrop@drop..
Iftherearefaultsordecienciesintheproductdelivered,thesellerwilleithermake
the required changes to the product or deliver a new replacement product to the
customer.Thesellermustbenotiedoftheproduct’sdeciencywithin14daysof
receipt of the product.
The pool is delivered in an upright position by a truck with a utility trailer. Remove
the plastic packaging, cardboard and any other equipment or parts delivered inside
the pool before turning the pool to its correct position. Roughly four people are
needed to turn the pool to its correct position.
INSTALLATION
AND STARTUP
Roughly four people are needed to move the pool. Special care must be taken when
moving the pool to prevent accidents. When the pool is lowered into a hole in a
terrace, for example, it is recommended that moving straps be used to ensure safe
installation. Grooves for moving straps can be found on the bottom of the pool.
Startup
PLEASE NOTE! Do not connect power to the pool until it is lled with water!
1. Turn the jets until they are open.
2. Before using the pool, check that all the threaded connections
ofthepumpsarermlysecured.Thethreadedconnectionsmay
come loose during transportation.
3. Fill the pool with water using a garden hose, for example (see page
8forhowtollthepool),insuchawaythatthewaterlevelis
approx. 10 cm below the edge of the pool.
4. Theelectricalinstallationmayonlybecarriedoutbyalicensed
electrician.Donotconnectpoweruntilthepoolislledwith
water. See Electrical installation.
5. After power is turned on, the pool display (located in the
equipment compartment) will show setup data, after which the
text RUN | PMPS | PURG | AIR | -- -- -- --
willblinkonthedisplay.Thisinitializationwilllast4–5minutes.
6. If the error message HTR | MAY | BE | DRY |
-- -- -- -- | WAIT | -- -- -- -- shows on the display within
therstfewminutes,itindicatesthatthereisairinthepump.In
this case, see the instructions for clearing an air lock.
7. Turn on the pumps and check that water is coming out of all jets.
Electrical installation
The electrical installation may only be carried out by a licensed electrician.
PLEASE NOTE! Donotturnonpowertothepooluntilitislledwithwater!
The outdoor spa pool must be connected to a 3 x 16 A, 400 V (current) or a 1 x 16 A,
230 V (3 kW Lähde & Lampi) electrical connection. The electrical connection must
be protected with a ground fault circuit interrupter. The electric supply can be drilled
through any corner of the pool’s siding or a moving strap groove in the pool base. The
side behind which the control panel is located is marked on the pool.
PLEASE NOTE! Models: Drop X, Drop Vuolle, Drop S and Lähde must be connected
toa3x16A,400V(current)electricalconnection)Models:LampiandDropLähde
3 kW must be connected to a 1 x 16 A, 230 V connection. Drop Lampi with a extra
heatermustbeconnectedtoa3x16A,400Velectricalconnection.
PLEASE NOTE! The wires must be stripped to a length of approx. 20 mm, and the
earth connection must be completed appropriately.
1. Checkthatthepoolislledwithwatertothelevelofthesurface
suction drains.
2. Open the service hatch to access the control panel.
3. Connect the power cable to the control panel.
4. Closetheservicehatch.
Electrical installation diagram
3 kW 1 x 16 A, 230 V
Electrical installation diagram
6kW3x16A,400V
Ce manuel convient aux modèles suivants
2
Table des matières
