Thoroughly check the craft before every ight…
Pre-Flight Safety Checke safe and secure and not loose.
Check to see if any wires have come o
Check for loose bolts on the assembly
Check that the battery’s are secure
Check the battery voltage, and if you have more than one battery, check your spares too
Check the propellers for marks and nicks
Check the propeller nuts or bolts, make sure they are tight
Check the engine mounts and the bolts and nuts for tightness
Check the Transmitter battery voltage; never y the craft with a low voltage reading on your transmitter
(check with the manufacturer of your equipment for minimum and maximum voltage readings).
Check that the transmitter antenna is not damaged.
Check that the craft receiver module is well connected and that the antenna’s are properly positioned.
Take a good look over the craft from all sides to make sure that nothing appears unusual or out of place.
Check your ight perimeter.
Check for power-lines and overhead obstacles.
Assess the weather conditions, wind direction and speed. An anemometer (hand held wind speed meter) is a good tool
to have, otherwise use some dry grass or a tissue, throwing in the air to gauge the wind direction. Do not y in gusty
and turbulent conditions.
Set your transmitter timer to 80% of the known battery duration.
DISCLAIMER:
Droidworx NZ Limited disclaims all warranties, whether expressed or implied, including but not limited to the implied warranties of merchantability
and tness for a particular purpose. Droidworx NZ Limited does not assume any lyability, whether direct or indirect, from the use of the
Mini 4 or 6. Droidworx NZ Limited shall not be liable for any direct, indirect, special, incidental, punitive, contingent or consequential damages to persons or
property caused by the Mini craft. In no event shall Droidworx NZ Limited be liable for personal injury up to and including death.
