Dometic RH330LD Manuel d'utilisation original
SERVICE INSTRUCTION
COOLING
3120
3130
miniBar
miniCool
Previous models
Greenline
Face-liftin
HiPro
599 5152 -85
Publication-No.:
04.02.25
EN/SE VICE/MB/KV/ S
DES
Dometic GmbH
In der Steinwiese 16
D-57074 Siegen
Tel. 0049 / 271/692-0
Fax. 0049 / 271/692-300
replaces 599 4720-12/5
599 4708-82/3
ENGLISH
2
1.0 Summery of Models 3
2.0 Electronics 3
2.1 Fuzzy Lo ic 3
2.2 Fuzzy Lo ic with 2 Sensors 3
3.0 Automatic Defrost Function 4
4.0 Coolin Unit 5
5.0 Heatin Shell 5
5.1 Resistances at Heatin Elements 5
6.0 Li htin 6
7.0 Installation 8
8.0 Securin 9
9.0 Chan in the Slidin Hin e 10
10.0 Chan in the Decorative Panel 11
11.0 Automatic Door Control (ADC) 11
11.1 Mechanical ADC 11
11.2 Automatic Door Control (electrical) 13
12.0 Mountin a miniSafe 18
13.0 Storin Goods 19
14.0 Troubleshootin 20
15.0 Ener y Savin Tips 20
16.0 Technical Data 21
17.0 Wirin Dia rams 24
17.1 Refri erators without Li htin 24
17.2 Refri erators with Li htin 25
17.3 Refri erators with 55l/56l Capacity 26
18.0 HiPro Generation 27
19.0 HiPro Electronic 27
19.1 Temperature in the HiPro 27
compartment
19.2 Self-test of the electronics 28
19.3 Automatic fault analysis 28
19.4 Automatic Defrost Function 29
19.5 Coolin unit check 29
19.6 Heatin Shell 29
20.0 Li htin 30
21.0 Automatic Door Control 30
22.0 Operation intervention 30
23.0 Installation 31
24.0 Securin 31
25.0 Chan in the Slidin Hin e 31
26.0 Ener y Savin Tips 31
27.0 Manual fault analysis 32
28.0 Technical Data 32
29.0 Wirin Dia ram/ Occupancy electronics 33
TABLE OF CONTENTS
Summery of Models
Face lifting models and Greenline models are the latest generation of
miniBars/miniCools and consumes approximately 40% less energy than its
predecessors.
H 430LD H 330LD H 236LD
H 440LD H 340LD H 237LD
H 441LD H 341LD H 238LD
H 460LD H 360LD H 252LD
H 461LD H 361LD H 255LD
H 456LD/LDE H 356LD/LDE H 300LD
H 455LD H 355LD H 226LD
H 436D H 136D -
H 447D H 137D -
- EA 330/L -
- EA 355/L -
- EAW 3220 -
Changes Face-liftin models to Greenline models:
Automatic defrost -cycle and design
Changes Greenline models to Previous models: cooling unit, the heating
cartridge, lighting, insulation and electronic controls (Fuzzy Logic).
Electronics
Fuzzy Lo ic
All Greenline models and Facelifting models maintain a con-
stant temperature level which has been set at the beginning
of operation. This temperature level is controlled by
electronic intelligence in an energy-saving way.
Unlike conventional appliances, the electronic control
component does not switch on and off but controls (clocks)
the cooling units heating power in a way which does not
require system circulation to be interrupted.
The electronic controls sensor (A) is an air sensor. This means that the
sensor can react directly to the temperature inside the cooling appliance.
Fuzzy Lo ic with 2 sensors
By means of the second sensor the electronics carries out a leak detection
test. If leaks or blockages in the cooling unit are recognised the miniBar is
shut off by the electronics. The test is done after every defrost cycle
(every 24 hours).
After a Power-On- eset, the controllers software runs a self test routine to
check the function of the sensors. The result of the test is shown with the
length of the first duty-cycle of the heating element (jumper X4).
There are four different states which are shown in the following table:
3
2.0
1.0
Face lifting Greenline Models Previous Models
A
2.1
2.2
Status Duty-Cycle
both sensors o.k. 7 sec. ON
air-sensor missing/defective 9 sec. ON
evaporator-sensor missing/defective 12 sec. ON
both sensors missing/defective 15 sec. ON
If the air-sensor fails during normal operation, the software shuts down the
cooling unit in steps to 0.
In refrigerators without evaporator-sensor or if the evaporator-sensor is
defective the leakage test is not carried out.Then the new electronics works
like the previous one without leakage detection.
Automatic Defrost Function
The electronic also regulates the automatic defrosting of the refrigerator.
When the plug has been stuck to the socket the running time of the
refrigerator up to the first defrostin is 15 hours for reenline models
and 39 hours for the new face lift models (RH4XX). For all models the
defrostin takes 2 hours.Then the refri erator works 22 hours and
afterwards defrosts 2 hours. Therfore the starting of the refrigerators
determines the time of defrosting.
For example: Starting at 7.00h = first defrosting 22.00h - 24.00h (for facelift
models 22.00h next day)
4
3.0
S
TT
TTTT
S
(39h)
X4, connection heatin element
Connections evaporator-sensor = Y3, Y4
Connections air-sensor = Y1, Y2
Do not chan e the
connections of the
evaporator-sensor and
the air-sensor !
Air-sensor
Evaporator-sensor
N
X1,X2,X3 = N
X5,X6 = L
In service case please pull sensor off
electrics and check by means of
measurement.
(ch. 15.0 Troubleshooting)
Ambient temperature°C esistance (kW)
0° 32,51 +/-2%
10° 19,86 +/-2%
15° 15,68 +/-2%
20° 12,48 +/-2%
5
Coolin Unit
The cooling unit has been optimised for the Greenline models and Face-
Lifting models. Unlike the cooling units of its predecessors, the Greenline
models and Face Lifting models cooling units can be replaced.
When replacin the coolin unit, however, the heatin element
(heatin shell) must be replaced as well.
Ammonia is used as a coolant. This is a natural compound also used in house
hold cleaning agents (1 litre of Salmiak cleaner contains up to 200g of
ammonia - about twice as much as is used in the refrigerator). For the safety of
hotel guests and personnel, it has been established by inspectors that the
coolant poses no threat to health.
Heatin Shell
The conventional heating element (previous models) is replaced by a hea-
ting shell. The heating shell is situated directly to the cooker tube. An optimal
efficiency ratio is achieved by means of a direct and enlarged contact area.
Measurin of resistances at heatin elements
4.0
In case service is required:
5.0
Attention please! The heating bowls upper
edge must be placed at the shown position
(142 mm).
Install the mounting clip at the centre of
the heating shell.
142 mm
esistances :
ch. 15.0 Troubleshooting
5.1
Connections N
and X4
Measure resistance...
...replace heating shell if required.
230V / 65 W heatin shell ~ 800WW
230V / 80 W heatin shell ~ 650WW
110V / 65 W heatin shell ~ 186WW
110V / 80 W heatin shell ~ 150WW
Li htin (except for RH 356LD/E, RH 456LD/E)
All Greenline and face lifting cooling appliances are equipped with sensor-
controlled lighting. The lightings sensor (proximity switch, A) is activated by
means of a magnet (B) which has been foam-installed into the door.
The lighting mechanism consists of two lamps for 180-250V operation
switched in series. For voltages of 100-140V, the lamps are switched in
parallel by means of a bridge.
A = Proximity switch
Take care when
replacin - pay
attention to correct
polarity
B = Magnet
Chan in bulbs:
6
6.0
AB
180-250V 100-140V
The proximity switch (A) is mark with a N
on the left side in front (correct polarity) .
If you chance the proximity switch please
eighth of the polarity.
A
1. Pull out the
mains plug.
2. emove the
reflector disk.
3. emove defective
bulb.
4. Insert new bulb. 5. Clip reflector disk
back in.
Li htin for RH 356LD/LDE and RH 456LD/LDE
The above models are equipped with
separate warm shelf and cooling section
lighting. This lighting mechanism consists
of:
- sensor - switch
- 1 light bulb for warm shelf
- 2 light bulb for cooling section
- Transformer (output voltage 6V)
Pay attention to country-specific vol-
tages for the transformer!
Chan in bulbs:
7
1. Pull out the
mains plug.
2. emove the
reflector disk.
3. emove the
defective bulb.
4. Insert new bulb. 5.Clip reflector disk back in.
90°
1.
2.
Installation
8
7.0
1. The refri erator must be level both directions
2. There sould be 20mm clearance to the wall
3. Ventilation must be provided as shown in
alternatives A,B,C or D
4. The ventilation duct must at least measure
105mm x the wtdth of the refri erator
5. Only the entire coolin unit must project into
the duct as shown
6 Air passin throu h the duct must not be
preheated by any source of heat
7. Ventilation rills, if used, must have openin s
of at least 200cm² each
Please follow the installation details below
carefully. Guarantee is valid for products
installed as described only.
IMPORTANT:
20mm20mm
20mm
20mm
200cm²
200cm²
200cm²
200cm²
200cm²
200cm²
200cm²
200cm²
Securin
RH 356LD/E, RH 456LD/E
RH136, RH137, RH330, EA330, RH340, RH341, RH360,
RH361, RH437, RH447, RH430, RH440, RH41, RH460,
RH461, EAW 3220
The miniBar must be screwed onto the cupboard using the lower hinges.
9
Recess dimensions in mm:
Model Hi ht Width Depth
H 430LD, H 330LD 526 388 432
H 436D, H 136D 526 388 432
EA 330L 526 388 432
H 440LD, H 340LD 558 405 466
H 447D, H 137D 558 405 466
H 441LD, H 341LD 558 405 469
H 456LD/E, H 356LD/E 662 454 523
H 460LD, H 360LD 567 490 494
H 461LD, H 361LD 567 490 494
EAW 3220 567 490 494
1. Tighten screw. 2. Put on cap.
8.0
1. Tighten screw. 2. Put on cap.
on level with furniture
Chan in the Slidin Hin e
10
9.0
1. 2.
3. 4.
Distance to cupboard door (A)
A
1. When closed, the cupboard door (A)
must not lie against the rest of the
surrounding cupboard area
(distance 1-2mm).
1.
2.
1. 2.
mm
mm
2. There must be a distance of
6-8mm between the cupboard
door and the miniBar.
Ce manuel convient aux modèles suivants
27
Table des matières
Autres manuels Dometic Réfrigérateur
Dometic
Dometic CRX Series Manuel utilisateur
Dometic
Dometic CFX100W Manuel utilisateur
Dometic
Dometic RH418NTEG Manuel utilisateur
Dometic
Dometic RM2351 Manuel utilisateur
Dometic
Dometic HC302 Series Manuel utilisateur
Dometic
Dometic miniCool Series Manuel utilisateur
Dometic
Dometic CFF12 Manuel utilisateur
Dometic
Dometic RMD 8501 Manuel utilisateur
Dometic
Dometic RML9430 Manuel utilisateur
Dometic
Dometic RM2193 Manuel
Dometic
Dometic HIPRO A30 Manuel utilisateur
Dometic
Dometic NDE1402 Manuel utilisateur
Dometic
Dometic RM2191 Manuel utilisateur
Dometic
Dometic DM2652 Manuel utilisateur
Dometic
Dometic RM 5380 Manuel utilisateur
Dometic
Dometic RM 4361DM Manuel utilisateur
Dometic
Dometic RUC8408X Manuel utilisateur
Dometic
Dometic RH430STE Manuel utilisateur
Dometic
Dometic A30P1 Manuel utilisateur
Dometic
Dometic CFX28 Manuel utilisateur
