DMP Electronics 893A Instructions de montage

InstallatIon sheet

893A Dual Phone Line Module

Description

The 893A is a dual telephone line supervision module that allows DMP Panels to indicate a phone line failure to the

premises and central station, and switch to secondary phone line communication when the primary line is down.

Compatibility

The 893A is compatible with XR100/XR500 and XR150/XR350/XR550 Series Panels.

Phone Line Monitor

The 893A uses a phone line monitor for the main and backup phone lines. Before sending a report, the 893A veries

that the main phone line is working. If the line is bad, the module tests the backup phone line. The 893A sends the

report on the rst working phone line.

The phone line monitor has a two-minute trouble delay and a one-minute restore delay. Phone line trouble is

displayed in the keypad Status List as a System Trouble. At least one keypad on the system must be programmed to

display system troubles in the Status List.

Two Line Digital Dialer

You can congure the 893A to provide two lines of digital dialer for XR100/XR500 and XR150/XR350/XR550 Series

panels. The MAIN modular jack is used for the primary dialer. The BACKUP modular jack is used for the secondary

digital dialer line.

CAUTION - To reduce the risk of re, use only No. 26 AWG or larger telecommunication line cord, such as DMP Model

356 Series Phone Cords.

Processor Fail Buzzer

The 893A Module also monitors the panel CPU and sounds a trouble buzzer whenever the panel processor is reset

using J16 or the processor stops functioning. The 893A Module also monitors the keypad bus and sounds a trouble

buzzer whenever the keypad bus fails to operate.

Jumper Settings

There are two sets of jumpers on the 893A Module. For Digital Dialer, set both jumpers, J1 and J2, to DD. Refer to

Figure 1 for jumper locations.

Figure 1: 893A Layout

893A J4 MAIN

to Phone Block

893A J5 BACKUP

to Phone Block

893A P3 PANEL

to Panel J3 Phone Line Connector

DS1

Buzzer

PANEL

MAIN BACKUP

J4 J5

F2 F1

MPX

K4 K3

MPX

P10

893A P10

connector

to Panel J10

connector

800-641-4282

      

www.dmp.com 2500 North Partnership Boulevard



 

15025

Installation

The wires needed to connect the 893A are included.

Ground Yourself Before Handling the Panel! Touch any grounded metal, such as the enclosure, before

touching the panel to discharge static.

Remove All Power From the Panel! Remove all AC and Battery power from the panel before installing or

connecting any modules, cards, or wires to the panel.

893A Installation

The 893A Module snaps into one of the enclosure 3-hole mounting locations and connects to any compatible panel

using an 18-inch, 7-conductor harness and a 2-foot phone cord. Follow the instructions below to install the 893A:

1. Mount the plastic standoffs to the enclosure three-hole mounting locations using three Phillips head screws.

2. Insert the screws from the enclosure outside through the holes and into the plastic standoff that mounts on the

enclosure inside and tighten.

3. After securing the standoffs onto the enclosure, gently snap the 893A onto the standoffs.

4. Using the supplied 7-wire harness, connect 893A connector P10 to the panel J10 connector.

5. Using the supplied phone cord, connect the 893A modular connector labeled PANEL to the panel J3 modular

connector.

6. Connect the main and backup phone lines to the MAIN and BACKUP modular connectors on the 893A.

Figure 3: 893A with RJ and 7-wire Harness Connections

XR550 Series Panel

Use supplied phone

cord to connect

893A Dual

Phone Line

Module

DS1

Buzzer

PANEL

MAIN BACKUP

J4 J5

F2 F1

MPX

K4 K3

MPX

P10

Use supplied

7-wire harness

to connect

To Telco Line

Specications

Operating Voltage 12 VDC from the panel

Current Draw 35.5mA Normal Operation

110mA Processor Fail

Buzzer On

The maximum telephone line impedance

is 100 Ohms.

Compatible Panels

XR100/XR500 and XR150/XR350/XR550

Series Panels

Certications

FCC Part 15

FCC Part 68 Registration ID CCKUSA-18660-AL-R

California State Fire Marshal (CSFM)

New York City (FDNY COA #6167)

UL 864 Fire-Protective Signaling Systems

Table des matières

Autres manuels DMP Electronics Système de sécurité

DMP Electronics

DMP Electronics CELLCOMSL SERIES Mode d'emploi

DMP Electronics

DMP Electronics SCS-1R Manuel utilisateur

DMP Electronics

DMP Electronics 263HINT Manuel utilisateur

DMP Electronics

DMP Electronics 1135 Series Manuel utilisateur

DMP Electronics

DMP Electronics 1912XR Manuel technique

DMP Electronics

DMP Electronics XR150 series Manuel utilisateur

DMP Electronics

DMP Electronics SecurityCommand XR10 Manuel utilisateur

DMP Electronics

DMP Electronics XR500 SERIES Manuel utilisateur

DMP Electronics

DMP Electronics 1135 Manuel utilisateur

DMP Electronics

DMP Electronics 135 Series Manuel utilisateur

DMP Electronics

DMP Electronics 265HINT Manuel utilisateur

DMP Electronics

DMP Electronics Thinline 7063 Manuel utilisateur

DMP Electronics

DMP Electronics 1141 Manuel utilisateur

DMP Electronics

DMP Electronics XR500 SERIES Manuel utilisateur

DMP Electronics

DMP Electronics XR500 SERIES Manuel utilisateur

DMP Electronics

DMP Electronics iComSL Series Manuel utilisateur

DMP Electronics

DMP Electronics DUALCOM Series Manuel d'installation et d'exploitation

DMP Electronics

DMP Electronics Security Command XR20 Manuel utilisateur

DMP Electronics

DMP Electronics XR100FC Manuel utilisateur

DMP Electronics

DMP Electronics 1135DB Manuel utilisateur

DMP Electronics

DMP Electronics XTLtouch Manuel utilisateur

DMP Electronics

DMP Electronics 1136 Manuel utilisateur

DMP Electronics

DMP Electronics 1135 Series Guide d'installation

DMP Electronics

DMP Electronics 1135 Manuel utilisateur

Manuels Système de sécurité populaires d'autres marques

Inner Range

Inner Range Concept 2000 Manuel utilisateur

Climax

Climax Mobile Lite R32 Instructions de montage

CADDX

CADDX NX-6 Manuel utilisateur

FBII

FBII XL-31 Series Manuel utilisateur

Johnson Controls

Johnson Controls PENN Connected PC10 Manuel utilisateur

Aeotec

Aeotec Siren Gen5 Manuel utilisateur

Blaupunkt

Blaupunkt SA 2700 Manuel utilisateur

IDEAL

IDEAL Accenta Manuel du propriétaire

AJAX

AJAX DoubleButton Manuel utilisateur

Swann

Swann SW-P-MC2 Manuel utilisateur

Ecolink

Ecolink Siren+Chime Manuel utilisateur

Digital Monitoring Products

Digital Monitoring Products XR150 Manuel utilisateur

EDM

EDM Solution 6+6 Wireless-AE Manuel utilisateur

Highway Safety Group

Highway Safety Group EA401 Manuel utilisateur

Siren

Siren LED GSM Manuel utilisateur

Detection Systems

Detection Systems 7090i Instructions de montage

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Manuel utilisateur

Siemens

Siemens FDM273 Manuel utilisateur