DKS DKGL-S6-1 Manuel utilisateur
600 Lb. Magnetic Gate Lock DoorKing Part Number
DKGL-S6-1
It is essential that the surfaces of the armature and the magnetic lock seat perfectly to one another when the gate is in the closed
position. This allows the lock to achieve its maximum holding strength. It is critical the armature is securely fastened to the gate
frame or door, but able to move with the rubber spacer to correctly align with the magnetic lock.
Mount the armature directly to
the gate frame or door. Secure
sexnut through the gate frame
or door into the armature bolt.
120 Glasgow Avenue
Inglewood, California 90301 U.S.A.
Maglock
Armature Bolt
Hexolt
Anti-Tamper
Plug
Optional
Spacer
Washers
Mount to a
stationary
fence post
or door jamb.
Mount to a
stationary
fence post
or door jamb.
Installation
Moving
Gate Frame
or Door
Stationary Fence Post
or Door Jamb
Armature
Maglock
Sexnut
Armature
Insert
Roll Pin
Sexnut
Note: Use spacer
washer(s) to shorten
the length of hexbolt
if necessary.
Indoor
12 or 24 VDC Wire Run
16 AWG - 200 Ft
18 AWG - 100 Ft
Polarity Matters!
Use
Only
Indoor
Use
Only
DKGL-S6-1-064-D-3-12 Copyright 2012 DoorKing, Inc. All rights reserved.
Diode Note: Install the supplied
diode across the positive and
negative lines AFTER the relay to
protect the magnetic lock from
transient voltage spikes.
DoorKing Part Number
DKGL-S6-1
Relay
120 Glasgow Avenue
Inglewood, California 90301 U.S.A.
Wire for 24 VDC or 12 VDC ONLY
24 VDC Transformer
(Model 1812-035)
24 VDC
12 VDC
12 VDC Transformer
(Model 1812-037)
Blue - Normally Closed
Brown - Common
Yellow - Normally Open
Blue - Normally Closed
Brown - Common
Yellow - Normally Open
Black
Green
Red Positive Positive
Negative
Negative
Orange
LED Lock Status Sensor
Relay Contacts
Rated 1 amp @ 30 Volt max.
LED Lock Status Sensor
Relay Contacts
Rated 1 amp @ 30 Volt max.
Access Control Device
or Gate Operator
(Normally Closed)
Access Control Device
or Gate Operator
(Normally Closed)
Relay
Red
Black
Orange
Green
Diode
Diode
Autres manuels DKS Verrouillage
