Dixon ZTR 3361 Manuel d'instructions

TECHNICAL DATA BROCHURE

ZTR Model 3361

IMPORTANT -READ OPERATOR'S MANUAL BEFORE OPERATING OR MAKING ADJUSTMENTS

SEAT ADJUSTMENT

1. Pull or lift body retention latch P/N 3954 from

transaxle backing plate, raise and push body

and seat assembly forward.

2. Loosen four seat adjustment bolts

P/N 3227 and slide seat forward or backward

to desired position.

3. Re-tighten seat adjustment bolts P/N 3227.

NOT operate mower without seat

adjustment bolts properly tightened.

4. Close upper body and push re tention latch

P/N 3954 over transaxle backing plate.

DIXON INDUSTRIES, INC.

BLOUNT COMPANY AIRPORT

INDUSTRIAL PARK

PO BOX 1569

COFFEYVILLE KS 67337 0945

3162512000

FAX 316 251 4117

Page 1 of 8

BODY REMOVAL

1. The 3361 has a two-piece polyethylene body. The upper body can be folded forward to

expose the transaxle. In some cases, it may be necessary to remove the upper body to

service the transaxle.

2. To remove upper body, remove two bolts P/N 3093 from the front of upper body hinge

located on the brake shaft P/N 9283. Disconnect seat switch P/N 4761 at plug-in.

3. Reverse above procedure to reinstall.

ADJUSTMENT OF MOWER DECK DRIVE BELT

Belt tension is controlled and adjusted by tightening nut P/N 3205 on L -rod P/N 2841. Proper belt

tension can be measured by pushing against belt at mid-point on the left side of the mower chassis.

Belt should deflect approximately 3/4" to 1" when adjusted.

REMOVING MOWER BLADES

1. Secure mower blade P/N 1324 from turning.

2. Observe blade position when removing.

3. Remove blade bolt P/N 3268, and blade washer P/N 6260.

4. To reinstall, reverse above procedure. Tighten to 50-60 ft pounds of torque.

WARNING: Sharp edges on blade can cause injury!

Caution should be exercised when service Is required on the blade.

REMOVING MOWER DECK

1. Remove deck drive belt by loosening nylok nut P/N 3205 on L-Rod tensioner P/N 2841 until

belt

can be removed from electric clutch.

2. Remove the clevis pins P/N 3072 from L-rods at rear of deck and slide free from slots.

3. Remove the clevis pin P/N 3072 from the lift linkage at the front of deck.

4. Remove cotter pin from shaft P/N 1332 located at front of mower deck on slide plates welded

at battery box. Slide shaft free.

5. Raise front of mower chassis and roll mower free of mower deck assembly.

6. To install deck, reverse above procedure.

Page 2 of 8

MOWER BLADE OPERATION

1. To start mower blades, pull up slightly on blade drive switch handle and move it forward to

the "ON" position.

2. To stop mower blades, move switch handle to the "OFF" position

SAFETY CHECKS

IMPORTANT -PERFORM SAFETY CHECKS AFTER MAKING ANY REPAIRS OR ADJUSTMENTS

1. After reassembly, while seated on mower, attempt to start engine with mower deck

engaged. Engine should /VO7"start. If engine does start, return the mowerto an Authorized

Dixon dealer for adjustment or repair. ',\

2.Disengage mower deck and start engine. With the operator in the normal seated position,

engage mower deck and remove weight from seat. The engine should stop. If the engine

does NOT stop when operator rises from seat, return the mower to an Authorized Dixo n

dealer for adjustment or repair.

3. Engage. Then disengage mower blade in each cutting height. Insure that blade

disengages and comes to a stop within (5) seconds in each height position. If blade does

NOT disengage properly, contact your Authorized Dixon dealer.

CAUTION: DO NOT OPERATE MOWER IF ANY SAFETY FEATURE IS NOT FUNCTIONING CORRECTLY

PARKING BRAKE ADJUSTMENT

Tighten nut on brake rod P/N 2533, located in front of the transaxle on each side,just enough

to prevent brake from slipping when engaged.

CAUTION:

Over tightening may cause premature wear on the brake band P/N 5085.

Revised 7/93

P/N 8111

Page 3 of 8

3361 BODY ASSEMBLY

Page 5 of 8

3361 CHASSIS ASSEMBLY

Page 6 of 8

3361 TRANSAXLE ASSEMBLY

3361 MOWER DECK ASSEMBLY

36"

Page 7 of 8

Page 8 of 8

3361 WIRING ASSEMBLY

Table des matières

Autres manuels Dixon Tondeuse à gazon

Dixon

Dixon ZTR SPEEDZTR Manuel utilisateur

Dixon

Dixon ZTR 8000 Series Manuel utilisateur

Dixon

Dixon ZTR 966504101 Manuel utilisateur

Dixon

Dixon ZTR 8000 Series Manuel utilisateur

Dixon

Dixon ZTR 304 Manuel d'instructions

Dixon

Dixon ZTR 3000 Series Manuel utilisateur

Dixon

Dixon ZTR 2301 Manuel utilisateur

Dixon

Dixon 312 Manuel d'instructions

Dixon

Dixon ZTR 5000 Series Manuel utilisateur

Dixon

Dixon SPEEDZTR 30 Mode d’emploi

Dixon

Dixon Zeeter ZTR Manuel utilisateur

Dixon

Dixon ZTR 424 Manuel d'instructions

Dixon

Dixon ZTR 428 Manuel d'instructions

Dixon

Dixon D149P21 Manuel du propriétaire

Dixon

Dixon Ultra 52 Manuel utilisateur

Dixon

Dixon Black Bear Manuel d'installation

Dixon

Dixon ZTR 7525 Manuel utilisateur

Dixon

Dixon D2548YT Manuel utilisateur

Dixon

Dixon ZTR 3000 Series Manuel utilisateur

Dixon

Dixon RAM 48ZT Manuel utilisateur

Dixon

Dixon 1999 ZTR 4515B Manuel utilisateur

Dixon

Dixon D15KH30 Manuel utilisateur

Dixon

Dixon ZTR 5000 Series Manuel utilisateur

Dixon

Dixon D22KH42 Manuel utilisateur

Manuels Tondeuse à gazon populaires d'autres marques

RHINO

RHINO 1958 Manuel utilisateur

Wolf Garten

Wolf Garten Compact plus 40 B Manuel utilisateur

Cub Cadet

Cub Cadet LTX 1045 Manuel utilisateur

Craftsman

Craftsman 917.378461 Manuel utilisateur

GGP ITALY SPA

GGP ITALY SPA CR/CS 434 SERIES Manuel utilisateur

Challenge

Challenge CH18V2 Instructions de fonctionnement

TALEN TOOLS

TALEN TOOLS AVR HGM30 Manuel utilisateur

DEWEZE

DEWEZE ATM-725 Manuel d'utilisation

Weed Eater

Weed Eater 180083 Manuel utilisateur

Husqvarna

Husqvarna Poulan Pro PP185A42 Manuel utilisateur

Better Outdoor Products

Better Outdoor Products Quick Series Manuel utilisateur

Cub Cadet

Cub Cadet 23HP Z-Force 60 Manuel d'utilisation

MTD

MTD 795, 792, 791, 790 Manuel utilisateur

Toro

Toro Groundsmaster 3505-D Manuel utilisateur

Dennis

Dennis FT 610 Manuel utilisateur

AIRFORCE

AIRFORCE F-15 Gen 3 Manuel utilisateur

MTD

MTD 126-220-000 Manuel utilisateur

Toro

Toro 74806 Manuel utilisateur