v
1Read these instructions.
2Keep these instructions.
3Heed all warnings.
4Follow all instructions.
5Do not use the equipment near water.
6Clean only with a dry cloth.
7Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8Do not install near any heat sources such as radiators, heat registers, stoves, or other devices
(including amplifiers) that produce heat.
9Protect the power cord from being walked on or kinked, particularly at plugs, convenience
receptacles, and the point where they exit from the equipment.
10 Use only attachments/accessories specified by the manufacturer.
11 Unplug the equipment during lightning storms or when unused for long periods of time.
12 Refer all servicing to qualified service personnel. Servicing is required when the equipment has
been damaged in any way, such as the power supply cord or plug is damaged, liquid has been
spilled or objects have fallen into it, the equipment has been exposed to rain or moisture, the
equipment does not operate normally, or the equipment has been dropped.
13 The power plug must be readily accessible so that the equipment can be easily disconnected
from the AC power.
14 The equipment is still connected to the AC power whenever it is plugged into a live power outlet,
even if it is turned off using the remote control or front panel buttons.
15 No flame sources, such as lighted candles, should be placed on the equipment.
16 The equipment shall not be exposed to dripping or splashing, and no objects filled with liquids,
such as vases, shall be placed on it.
17 Operate the equipment using only the type of power source indicated on the marking label.
Unplug the equipment’s power cord by gripping the power plug, not the cord.
18 Do not overload wall outlets or extension cords, as this can result in a risk of fire or electrical
shock.
19 Never insert objects of any kind into the equipment through openings, as the objects may touch
dangerous voltage points. This could cause fire or electrical shock.
20 Do not locate the antenna near overhead light or power circuits, or where it can fall into power
lines or circuits. When installing the antenna, take extreme care to avoid touching power lines or
circuits, as contact with them can be fatal.
21 Unplug the equipment from the AC power outlet before cleaning.
22 Do not place the equipment in an enclosure such as a cabinet without proper ventilation.
23 Do not install the equipment in any area where the temperature can be less than 40°F or more
than 113°F. If the equipment is cold to the touch, do not plug it in immediately. Let it sit
unplugged at room temperature for at least 45 minutes before plugging it in.
24 Use an outlet that contains surge suppression or ground fault protection. For added protection
during a lightning storm, or when the equipment is left unattended and unused for long periods
of time, unplug the power cord from the wall outlet and disconnect the lines between the
equipment and the antenna. This provides some protection against damage caused by lightning
or power line surges.
Important Safety Instructions
