DirekTronik Wireless Pocket USB Manuel utilisateur

DRIVER &SOFTWAREUTILITYUSER MANUAL –REV 1.0,FEB 2004

User Manual for the Wireless Pocket USB
2
FCC Information to User
FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC Guidelines for Human Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Regulatory Compliance Information
This section includes user requirements for operating this product in accordance with National laws for usage of radio
spectrum and operation of radio devices. Failure of the end-user to comply with the applicable requirements may
result in unlawful operation and adverse action against the end-user by the applicable National regulatory authority.
FCC Requirements for Operation in the United States
Radio Frequency Interference Warnings & Instructions
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residentialinstallation. This equipment uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guaranteethat interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio ortelevision reception, which can be determined by turning the equipment off andon, the user is encouraged
to try to correct the interference by one or more of the following methods:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
Modifications made to the product could void the user's right to operatethe equipment.
Europe Notify Body 0678
Marking by the above symbol indicates compliance with the Essential Requirements of the R&TTE Directive of the European
Union (1999/5/EC). This equipment meets the following conformance standards:
EN300 328, EN301 489-1/17, EN60950
This device is a 2.4 GHz low power RF device
intended for home and office use in EU and EFTA
member states. In some EU / EFTA member states
some restrictions may apply. Please contact local
spectrum management authorities for further details
before putting this device into operation.
Model: Wireless Pocket USB
FCC ID: RC6AWU-901W

User Manual for the Wireless Pocket USB
3
Requirements For Operation in the European Community
Countries of Operation and Conditions of Use in the European Community
The user should run the client utility program provided with this product to check the current channel of operation and confirm that
the device is operating in conformance with the spectrum usage rules for European Community countries as described in this
section.This device is intended to be operated in all countries of the European Community.
Operation Using 2.4 GHz Channels in France
The following radio channel usage limitations apply in France. The radio spectrum regulator in France, Autorité de regulation des
telecommunications (ART), enforces the followingrules with respect to use of 2.4GHz spectrum in various locations in France.
Please check ART's web site for latest requirements for use of the 2.4GHz band in France: http://www.art-
telecom.fr/eng/index.htm. When operating in the following metropolitan regions (départements) in France, this device may be
operated under the following conditions:Indoors using any channel in the 2.4-2.4835 GHz band (Channels 1-13) Outdoors using
channels in the 2.4-2.454 GHz band (Channels 1-7) When operating outside of the following regions (départements) in France (see
table below), this product must beoperated under the following conditions:
• Indoors using channels in the 2.4465-2.4835 GHz band (Channels 10-13).
• Outdoor operation not permitted.
Please refer to the ART web site for further details.
Metropolitan Regions with Eased Restrictions in 2.4GHz Band

User Manual for the Wireless Pocket USB
4
TABLE OF CONTENTS
TABLE OF CONTENTS……………………………………………………………………4
1 INTRODUCTION………………………………………………………………………6
1.1 Key Features.……………………………………………………………………...6
1.2 Package Contents.………………………………………………...……………..6
1.3 System Requirements.…………………………….…………...………..……...6
1.4 LED Definition.……………………...…...………………………………………..7
1.5 Connection Diagram..………………………..…………………………………..7
1.6 Observing Location and Range Guidelines………………...……………….8
2 DRIVER AND UTILITY INSTALLATION…………………………………………..9
2.1 Installing Driver and Software Utility..………………………..……………….9
2.2 Disabling the Windows XP’s Zero Configuration……………………...….14
2.3 Invoking the Utility……………………………………..…………………………16
2.3.1 Invoking via the Start Menu………….…………………………………….16
2.3.2 Invoking via the Task Bar ………………………………………………….16
3 ENVARACONFIGURATION UTILITY –DESCRIPTION… .…………………...18
3.1 Envara Configuration Utility Dialog Box Overview…………………….…18
3.1.1 Tabs Overview………………..….…………………………………………..19
3.1.2 Buttons Overview……………………………………………………………19
3.2 General Tab………………………………………………………………………20
3.2.1 Connection Section…………………………………………………...…….21
3.2.2 Radio Transmitter Section………………………………………...……….21
3.2.3 Link Status Section………………………………………………….………22
3.3 Profiles Tab………………..……………………………………………….…….22
3.3.1 Profiles Tab Buttons.………………………..………………………………23
3.4 Current Statistics Tab.………………………………..………………………..24
3.4.1 Received and Sent Sections.………………………………………………25
3.4.2 Signal Section………………………………………………………………..25
3.4.3 Activity Section………………………………………………………………25
3.4.4 Reset Button………………………………………………………………….25
3.4.5 Advanced Button…………………………………………………………….25

User Manual for the Wireless Pocket USB
5
3.5 Preferences Button / Dialog Box……………………………………………..26
3.5.1 Scanning Mode Section…………………………………………………….27
3.5.2 Auto Power Save Configuration Section / (Battery Operating Power
Save Drop-down List).………………………………………………………27
3.5.3 Defaults Button………………………………………………………………27
3.6 View Site Button………………………………………………………………...28
3.6.1 Available AP’s………………………………………………………………..28
3.6.2 Available Networks………………………………………………………….30
3.7 About Tab………………………………………………………………………...35
4TROUBLESHOOTING…………………………………..………………………….37

User Manual for the Wireless Pocket USB
Driver and Software Utility
6
1IntroductionIntroduction
The miniature Wireless Pocket USB gives you ultimate mobility in your office or
while you are traveling. It frees you from traditional Ethernet wiring and helps you
connect to anexisting wireless network for sharing your broadband cable or DSL
Internet access.It is designed for PC computers running Microsoft® Windows®
98SE, ME, 2000 and XP operating systems. It is USB 2.0 compliant and is
backwards compatible with USB 1.1.
Its auto-sensing capability allows high packet transfer at up to 54 Mbps for
maximum throughput or dynamic range shifting to lower speeds due to distance or
operating limitations in anenvironment with a lot of electromagnetic interference.
The Wireless Pocket USB complies to IEEE 802.11b/g standards and provides 54
Mbps WLAN connectivity. It can protect data integritywith enterprise-level security.
1.1 Key Features
•Operate at 2.4GHzunlicensed frequency with data transmission rate up to 54Mbps
•IEEE standards support: IEEE 802.11b, 802.11g
•Advanced securityfeatures including WEP 64-bit, 128-bit
•USB 2.0 interface compliant with USB 1.1
•Full-featured WLAN management utility
•Compatible with Windows 98SE, ME, 2000 (SP3 or above) and XP
1.2 Package Contents
•Wireless Pocket USB
•Set-up CD with User Manual & Software Utility
•Neckwear
•5 feet (1.5 meters) USB 2.0 cable or USB 2.0 cradle with 5 feet (1.5 meters)
integrated cable
1.3 System Requirements
A PC must be at least equipped with the following requirements.
•available USB 2.0 port or USB 1.1 port
•CD-ROM drive

User Manual for the Wireless Pocket USB
Driver and Software Utility
7
•Microsoft®Windows®98SE, ME, 2000 (SP3 or above) or XP operating system
•Pentium®II 450MHz or faster processor
•64 Mbytes RAM
•50 Mbytes free hard disk space
1.4 LED Definition
•Act : flash during data transmitting
•Link : lit when wireless connection established
1.5 Connection Diagram

User Manual for the Wireless Pocket USB
Driver and Software Utility
8
1.6 Observing Location and Range Guidelines
Computers can connect over wireless networks indoors at a range which vary
significantly based on the physical location of the computer with the Wireless Pocket
USB. For best results, avoid potential sources of interference, such as:
• Large metal surfaces
• Microwaves ovens
• 2.4GHz Cordless phones
In general, wireless devices can communicate through walls. However, if the walls
are constructed with concrete, or have metal, or metal mesh, the effective range will
decrease between the devices.

User Manual for the Wireless Pocket USB
Driver and Software Utility
9
2Driver and Utility Installation Driver and Utility Installation
This chapter explains how, and what, is needed to install driver and software utility.
These include:
•Installing Driver and Software Utility
•Disabling the Windows XP’s Zero Configuration
•Invoking the Driver Utility
2.1Installing Driver and Software Utility
1. Turn on your PC, log in the operating system, connect this Wireless Pocket USB
via the USB 2.0 cable or the USB 2.0 cradle or simply directly plug it into your
PC.
USB 2.0 cable USB 2.0 cable & cradle

User Manual for the Wireless Pocket USB
Driver and Software Utility
10
2. When the "Found New Hardware Wizard" window appears, selectInstall from a
list or specific location (Advanced), and click Next >.
3. Select Don't search. I will choose the driver to install and click Next >.
Table des matières
Manuels Logiciel populaires d'autres marques

PS Audio
PS Audio PowerPlay Manuel du propriétaire

Brady
Brady LOCKOUT PRO 3.0 Manuel de service

Avaya
Avaya Interaction Center Manuel utilisateur

Texas Instruments
Texas Instruments TI-83 Plus Silver Edition Manuel

Novell
Novell GROUPWISE 8 - INTERNET AGENT Manuel utilisateur

Oracle
Oracle Application 9i Manuel utilisateur

Acer
Acer RDM Manuel utilisateur

Canon
Canon Vixia HF21 Manuel utilisateur

Canon
Canon ZR950 Manuel utilisateur

Samsung
Samsung Auto Backup Manuel utilisateur

Polycom
Polycom Vortex EF2201 Instructions d'installation et d'utilisation

Brocade Communications Systems
Brocade Communications Systems Brocade 8/12c Manuel utilisateur





