RST button:
(1) Under normal running status, press RST button 3 to 6 seconds will restore default username/password, and network
mode will be changed to route mode as well. Other configurations will keep the same;
(2) Under normal running status, press RST button 6 to 12 seconds, the device will restore factory default and
reboot automatically;
(3) When the device is power off, press RST button more than 30 seconds after it power on, the device will clear all
the
configurations and restore to mini-system management;
13
More Details
This document only provides instructions for quick installation and basic configuration. For detailed configuration and
parameter explanation, please check the User Manual, or ask for online technical support.
14
Frequently Asked Questions
(1) UC200 call priority (from high to low)
a.
For the call between extensions, it is not necessary to configure any route, but to dial the extension number
directly, which has the highest priority;
b.
DID；
c.
The route rule in the "call control →routing" page (the rule with lower index has higher priority);
d.
Port registration configured in FXS extension, FXO trunk and GSM trunk.
(2) Can the call between extensions be disabled?
Yes, disable internal call between extensions under the "call control →settings" page.
(3) How many SIP extensions and concurrent calls can UC200 support?
UC200 supports 200 SIP extensions and 60 concurrent calls at max.
(4) After the port is configured to register to the remote SIP trunk, do I still need to configure outbound/inbound
call routing?
No, after the port is configured and registered, there is already a route bound to the port and its registered SIP trunk.
By default, and there is no need to configure it on the route configuration screen unless otherwise specifically requirement.
