Dinstar C81 Manuel utilisateur
C81 SIP Door phone User
Manual
Contents
C81 SIP Door phone User Manual 1
1 Overview 4
1.1 Introduction 4
1.2 Features 4
1.3 Hardware Introduction 5
Chapter 2 Installation 8
2.1 Check the contents of the package 8
Contents 9
2.2 Installation steps 9
Chapter 3 Feature 10
3.1 Dial 10
3.3 Enter the password to open the door(Note:Only C88 has this function) 11
Chapter 4 Web configuration 12
4.1 Status->Basic 12
4.2 Account->Basic 13
4.3 Account-Advanced 15
4.4 Network-Basic 17
4.5 Network-Advanced 18
4.6 Door Phone-Door Phone 20
4.7 Call Feature 27
4.8 Door Phone-Time/Lang 28
1 Overview
1.1 Introduction
C81 is a one-key SIP access control phone with advanced audio system with echo
cancellation. you can talk to visitors at any time through the access control camera.
C81 provides users with keyless control and convenient, supports a variety of ways to
open the door without keys. As long as it is an electronic door lock, it can be opened
remotely. It can ideally control communication and security through the network, and
can be well applied in areas such as commerce, institutions and residences.
1.2 Features
❖Access control
▪One SIP line, two SIP servers
▪SIP Door phone function：
▪Full two-way
▪Auto answer by default
▪Remote control via URL / URI
▪Speed dial
❖ Management Function
▪Automatic configuration: FTP / TFTP / HTTP / HTTPS / PNP
▪ Configuration via HTTP / HTTPS web
▪SNMP/TR069
▪Time synchronization service / Daylight saving time
▪Network upgrade firmware
▪System log
▪ Configuration backup / restore
❖Audio Function
▪HD audio
C81 SIP Door phone User Manual
▪Two-way audio streaming
▪Wideband codec: G.722
▪Narrowband codec :PCMA, PCMU，G.729, G723_53, G723_63, G726_32
▪Echo cancellation of G.168
▪Voice Activity Detection (VAD)
▪Comfort noise generator (CNG)
▪Built-in micro speaker
▪Acoustic echo cancellation audio output
❖Protocol and network
▪SIP v1 (RFC2543), v2 (RFC3261)
▪SIP based on TLS, SRTP
▪RTSP
▪TCP/IPv4/UDP
▪RTP/RTCP, RFC2198, 1889
▪HTTP/HTTPS/FTP/TFTP
▪ARP/RARP/ICMP/NTP
▪DNS SRV/ A Query/NATPR Query
▪Primary and secondary DNS
▪Private network penetration protocol, session timer
▪802.1p/q, DSCP
▪DHCP/Static/PPPoE
▪DTMF MODE: In-Band, RFC2833 and SIP INFO
1.3 Hardware Introduction
❖ Front view and description
camera：1080p HD camera
❖Rear view and panel description
C81 SIP Door phone User Manual
Appellation
Description
(DC 12V/1A)
DC 12V/1A power adapter connector
Internet
LAN port for network connection, 10 /
100M, RJ45 interface
VCC+(IN)
VCC- (IN)
The interface connected to the engineering
terminal block needs to provide 12V / 1A
power supply
N.O1--N.C1
Connect a certain logic control circuit, and
then control the action or operation of the
controlled object through the output device
Door
Generally used for input of opening and
closing doors
C81 SIP Door phone User Manual
Chapter 2 Installation
2.1 Check the contents of the package
Please refer to the packing list below to check the integrity of the packing.
2.2 Installation steps
Step 1 – Power on
Connect the supplied power adapter to the power port, and then plug the adapter into
an available power outlet.
Step 2 – Connect Network
Connect one end of the Ethernet cable to the Internet port on the back of the
communication C81, and the other end to the wall network jack.
Step 3 – Connect to computer
Connect one end of the Ethernet cable to the port on the back of the communication
C81, and the other end to the Ethernet port on the computer.
Step 4 – Configure the device
Start a web browser on the computer and enter the phone's IP address into the
address bar. If the address is correct, a login screen will appear, enter the user name
and password to log in to the web console to log in to the phone webpage.
Notice: Each phone has one certain IP address; You can short-circuit the external electrical
interface pin 7 and pin 11 to hear the IP address prompted by the device in voice mode.
Contents
Amount
C81 SIP Door Phone
1
Power Adapter
1
Ethernet cable
1
Chapter 3 Feature
3.1 Dial
You can use the following three methods to make calls：
1. One-touch dial：
Click "Door Phone-Door Phone" in the left navigation bar to enter the phone phone
configuration page;
In the Call Button configuration item, you can set 4 commonly used indoor unit
numbers, of which Call Button Day 1 ~ 3 is the outgoing number during the day, Call
Button Night is the outgoing number at night, the number is a one-touch dial button
The dialed number (C81 phone can directly press the "Dial" button to dial the number);
Round Robin Time Out is the time-out period of the carousel. If a number times out
and does not answer, the access control will automatically dial the next number (Call
Button Night number at night);
In Day Night Setting, you can configure the day and night start time to determine
the number dialed at the current time;
Click on Submit Button.
2. Speed Dial：
Click "Door Phone-Door Phone" in the left navigation bar to enter the phone
Table des matières
Autres manuels Dinstar Système d'interphone
