DINOX KBD-1000 Manuel utilisateur

User Manual KBD-1000

www.dinox.cz

Preventive and Cautionary Tips

Before connecting and operating your keyboard, please be advised of the following tips:

Ensure unit is placed in a well-ventilated, dust-free environment.

Keep all liquids away from the keyboard.

Please check the power supply to avoid the damage caused by voltage mismatch.

Please make sure the keyboard work in the allowed range of temperature and humidity.

Please keep the device horizontal and avoid the installation under severe vibration environment.

The dust board will cause a short circuit after damping. Please dedust regularly for the board, connector, and chassis fan with

brush.

User Manual KBD-1000

www.dinox.cz

Contents

Chapter 1 Product Overview . ..........................................................................................................................................................3

Chapter 2 Device Appearance .........................................................................................................................................................5

2.1 Rear Panel Description ...................................................................................................................................................5

2.2 Front Panel Description ..................................................................................................................................................6

2.3 Joystick Function. ...........................................................................................................................................................7

2.4 Typical Wiring Methods .................................................................................................................................................8

Chapter 3 Keyboard Operation. .....................................................................................................................................................13

3.1 Controlling DVR by Keyboard. ....................................................................................................................................13

Setting the Keyboard Parameters to Control DVR. ...........................................................................................................13

Operating DVR by Keyboard. ............................................................................................................................................14

3.2 Controlling Dome Cameras by Keyboard. ....................................................................................................................16

Setting the Keyboard Parameters to Control Dome Camera .............................................................................................16

Dome Camera Control Operation ......................................................................................................................................17

3.3 Controlling the VMS by Keyboard . ..............................................................................................................................18

Setting the Keyboard Parameters to Control VMS............................................................................................................18

VMS Control Operation. ....................................................................................................................................................18

3.4 Controlling the Analog Matrix by Keyboard ............................................................................................................... 20

Setting the Keyboard Parameters to Control Analog Matrix. ............................................................................................20

Analog Matrix Controlling Operation. ...............................................................................................................................20

Appendix 1：Specification. ...............................................................................................................................................................21

User Manual KBD-1000

www.dinox.cz

Chapter 1 Product Overview

KBD-1000 keyboard can be used to control the DVR, the analog dome, the video management platform and the analog matrix. The

keyboard is featured in its steady and friendly operation.

Multiple Controlling Modes

The keyboard controls the DVR, Dome Camera, VMS and Analog Matrix.

Controlling modes determine the devices controlled by the keyboard; e.g. if you choose the control mode as DVR, all the commands

and the controlling signal will be applied to the DVR. The controlling mode of the KBD-1000 keyboard can be shifted by pressing the

MODE button on the panel.

Figure 1-1 Mode Buttons

DVR controlling：The keyboard can fulfill the complete function of the front panel operation of the DVR. And there are

LED screen displays for all the operation. One keyboard can connect to 128 DVRs and the address code of the DVR ranges

from 0 to 255.

Analog Dome Controlling：The keyboard controls the PTZ function of the analog domes, the address code of the dome

ranges from 0 to 255. A maximum 128 analog domes can be connected.

VMS Controlling: The keyboard controls the video management platform, the TV wall switching and display, PTZ

parameters setting and PTZ controlling.

Analog Matrix Controlling: Control the signal input and output switch in the analog matrix.

Multiple Working Modes

The working modes are chosen by turning the key on the front panel. See the figure below.

Figure 1-2 Turning the Key to Change Working Mode

User Manual KBD-1000

www.dinox.cz

MENU: Keyboard Configuration Mode. Turn the key to the MENU. Set the keyboard parameters, such as the keyboard

address, the RS-485 parameters and the RS-232 parameters.

OPERATE: Keyboard Operation Mode. Turn the key to OPERATE. Under this mode, the keyboard can control the DVR,

PTZ of the dome camera and the matrix.

PROGRAM: Keyboard Function Settings Mode. Turn the key to PROGRAM. Under this mode, the keyboard can set the

parameters for preset, pattern and patrol.

Protocols

There are 63 protocols of the PTZ control of dome camera, and the main protocols are HIKVISION, PELCO-P, PELCO-D,

SAMSUNG, YAAN-1, SONY, SIEMENS, DRAGON, NAIJIE, KALATEL, VICON and etc..

The control protocols for the analog matrix are ZT-1.0, ZT-2.0, EXTRON, and CREATOR.

Cascade Connection

KBD-1000 provides the cascade connection, and 16 auxiliary keyboards are connectable. The address of the auxiliary keyboard

ranges from 0 to 255.

Other Features

The keyboard can set different RS485 parameters such as the protocol and the Baudrate, which enables the flexible parallel

connection to different devices.

The convenient key locking function ensures the security of operation.

The keyboard integrates multiple control functions as the controlling of DVR, analog dome cameras and matrix. It can be

used in the complex surveillance system.

 LED panel display is provided.

User Manual KBD-1000

www.dinox.cz

Chapter 2 Device Appearance

2.1 Rear Panel Description

Figure 2-1 The Rear Panel of KBD-1000 Keyboard

Notes

：

The green end with a G identifier on the rear panel is for grounding.

Number

Physical Interfaces

Description

Grounding

The pillar for grounding.

PTZ-CON

(PTZ Control Signal Output)

As main keyboard: Connect the dome camera or the RS485 of the PTZ: TA

connects to RS485+, and TB connects to RS485-.

As auxiliary keyboard: Connect the PTZ-AUX interface of the upper level

keyboard: TA connects to RA and TB connects to RB.

DVR/MATRIX-CON1

(DVR Control Signal Output)

As main keyboard: Connect the DVR KB interface; TA connects D+，TB

connects D-; When connecting the RS-485 of the VMS: TA connects to the 6th pin

and TB connects to 5th pin. When using the RS-485-to-RS-232 interface: TA

connects to 4th pin and TB connects to 3rd pin.

As auxiliary keyboard: Connect the AUX2 interface of the upper level keyboard.

TA connects to RA and TB connects to RB.

DVR/MATRIX-CON2

(Control Signal Output)

Output the RS-485 signal received by the 9th interface identified in the figure

above (AUX 1 interface).

RS232 Serial Interface

For the keyboard firmware upgrading and the control interface for the analog

matrix.

Power Supply

12VDC

Power Switch

Power on/ off

PTZ-AUX

(Auxiliary keyboard PTZ

control signal input)

Connect to the lower level PTZ-CON interface; RA connects to TA and RB

connects to TB.

DVR/MATRIX-AUX1

(Auxiliary keyboard DVR

control signal input)

Connect a RS-485 signal source to receive the RS-485 signal.

DVR/MATRIX-AUX2

(Auxiliary keyboard control

signal input)

Connect to the DVR/MATRIX-CON interface of the lower level keyboard: RA

connects to TA, RB connects to TB.

We name the keyboard directly connecting the main keyboard upper level keyboard and we call the keyboard connecting to the upper

level keyboard the lower level keyboard. For detailed information, see Chapter 2.4 for typical wiring methods.

User Manual KBD-1000

www.dinox.cz

2.2 Front Panel Description

Figure 2-2 Top View on KBD-1000 Keyboard

Note:

Buttons on the keyboard have different functions in different controlling modes. For example, the IRIS+/EDIT button realizes the

IRIS+ in PTZ control mode and in the DVR control mode, it is the EDIT button, when pressing, you can edit the combox field.

Button

Description

Lock

Switch to change the working mode of the keyboard.

Playback Buttons

Reserved

Jog Shuttle Button

Reserved

SITE

Press this button to enter the DVR No., dome camera No., analog matrix No. or the

VMS No..

AUX0

When controlling VMS, call the patrol of the dome camera.

AUX1

Reserved

AUX2

Reserved

AUX3

Reserved

AUX4/ REC/SHOT

DVR control mode: Audio on/ off and

PRESET

Set and call the preset

PATROL

Set and call the patrol

PATTERN

Set and call the pattern

ACK

Reserved

MON-G

When controlling VMS, choose the monitor group.

CAM-G/PLAY/AUTO

When controlling VMS, choose the camera group.

DVR control mode: Fast play when playing back.

WIN

When controlling VMS, press the button to choose windows.

WALL

When controlling VMS, select the TV wall after montage is done.

MULT

When controlling VMS, select the small screen which has not been montaged.

MAC

Reserved

HOLD

Stop cycling

RUN/F2/AUX

Start or Go on the cycling

User Manual KBD-1000

www.dinox.cz

Button

Description

DVR control mode: change the tab menu

The next item, can be a channel or menu setting field.

LAST

The previous item, can be a channel or menu setting field.

MON

When controlling the VMS or analog matrix, press this button to choose the monitor.

CAM

When controlling the VMS or analog matrix, press this button to choose the camera.

MODE

Press to switch the control mode of the keyboard

Numeric & characters buttons

（0-9）

Input the number or character; choose the live view or playback channel.

CLEAR

Clear the numbers input and exit.

ENTER

Enter

IRIS+/EDIT

PTZ control mode: iris+

DVR control mode: enable editing

IRIS-/PTZ

PTZ control mode: iris-

DVR control mode: show the PTZ control menu

FOCUS+/A

PTZ control mode: focus+

DVR control mode: switch the input methods

FOCUS-/PREV

PTZ control mode: focus-

DVR control mode: switch the screen display.

Z O O M +

PTZ control mode: zoom+

Z O O M -/ MAIN/SPOT

PTZ control mode: zoom-

DVR control mode: switch between main and auxiliary mode

LIGHT/F1

PTZ control mode: turn on the light

WIPER/MENU

PTZ control mode: enable wiper

DVR control mode: open the main men

2.3 Joystick Function

Graphic

Operation

Function

PTZ control mode: Move the PTZ up.

DVR control mode: Fast Play when playback, or navigate to the previous item when

operating the menu.

Down

PTZ control mode: Move the PTZ down.

DVR control mode: Slow play when playback, or navigate to the next item when

operating the menu.

Le ft

PTZ control mode: Move the PTZ to the left.

DVR control mode: Skip backward when playback, or navigate to the previous menu

when operating the menu.

Right

PTZ control mode: Move the PTZ right.

DVR control mode: Skip forward when playback, or navigate to the next menu when

operating the menu.

Left Rotate

Zoom in

Right Rotate

Zoom out

Notes

：

The joystick realizes pan and tilt movement at 8 directions.

Th e 4 -axis joystick can be used to control the zoom; and the central button used as Enter button and to realize picture capture as well.

User Manual KBD-1000

www.dinox.cz

2.4Typical Wiring Methods

Figure 2-3 Connection between the keyboards, the keyboards and the dome camera, the keyboard and the DVRs

① shows the connection of the auxiliary keyboard and the main keyboard. You can connect many auxiliary keyboards to the

main keyboard.

② shows the connection between the keyboard and the DVR/NVR.

③ shows the connection of DVRs when they are all connected and controlled by the keyboard.

④ shows the connection between DVR and dome cameras.

User Manual KBD-1000

www.dinox.cz

Figure 2-4 Connection between the main and auxiliary keyboards, and the keyboards and the dome camera

① shows the connection of the auxiliary keyboard and the main keyboard. You can connect many auxiliary keyboards to the

main keyboard.

② shows the connection between keyboard and dome camera.

③ shows the connection between dome cameras when they are all connected and controlled by the keyboard.

Table des matières

Manuels Clavier populaires d'autres marques

Vortexgear

Vortexgear POK3R Manuel utilisateur

Razer

Razer RZ03-0188 Manuel utilisateur

Logitech

Logitech RUGGED LITE Manuel utilisateur

Honeywell

Honeywell ADEMCO 5839 Instructions de montage

Hama

Hama AK-120 Manuel utilisateur

Rodgers

Rodgers RK-76 Manuel utilisateur

Logic Controls

Logic Controls KB5000 Series Manuel utilisateur

Rapoo

Rapoo E9270P Manuel utilisateur

iKey

iKey DP-88 Manuel utilisateur

Logitech

Logitech G413 TKL SE Instructions de montage

Keychron

Keychron C1 Manuel utilisateur

Dahua

Dahua NKB Manuel utilisateur

Ultimate Technology

Ultimate Technology 500 POS Manuel utilisateur

Ducky

Ducky Shine 5 Manuel utilisateur

Mace

Mace MACALLY MERGOKEY Manuel utilisateur

iKey

iKey KYB-42-KIOSK Manuel utilisateur

Akko

Akko MX108 Manuel utilisateur

Viper

Viper V770 Manuel utilisateur