15
14
16
18
20
17
19
21
What’s Included Charging
Pairing with multiple bluetooth devices
Controller Buttons
Music Commands Additional Information
Phone Commands
DinoTwin T2 Hydro Bluetooth Headphones
DinoTwin Carrying Case
3 Pairs of Ear Gels (S,M,& L)
1 Pair of Universal Ear Stabilizers
USB Charging Cable
Instruction Manual
Charge for approximately 2 hours for
8 hours of continuous usage. Should
the Red LED start to blink, this
indicates low battery and approxi-
mately 15 minutes left of usage. If
using with an iPhone, you will see an
icon with the amount of battery
power left in the headset.
The multi-pair function is factory disabled; you must enable this feature
prior to pairing with more than one device. While the device is in
Standby Mode (Bluetooth is powered on, just not connected to any
device), press and hold the and buttons until you hear four
ascending tones.
Simply have the Bluetooth paired to at least one device already, now
power down the Bluetooth headset, turn back on the Bluetooth entering
back into pairing mode (if needed see page 6), pair with the second
device.
There are only 3 buttons on the controller, familiarizing them and their
functionality is important.
Here are some additional tips that may answer some questions. When
using the headset, though you may have increased the volume to the
max from the phone/music device, there may be some extra volume by
also increasing the volume from the headset itself, and vice verse when
decreasing volume. Also, in some cases when finding the right fit, using
a mirror, twist the buds into your ear with the stabilizer on to make
sure the stabilizer is where it should be, it can make all the difference.
For other frequently asked questions, please visit our website at
www.dinotwin.com/support.
When listening to music, to increase the volume, tap the button, and
to lower the volume tap the button. To skip to the next track, short
press the button, to skip to the previous track, short press the
button, to pause, press the button once, and to play press the
button again.
Press the button to answer a call while listening to music (you will
hear personalized ring tone from the headset), then short press the
button to end the call and it will automaicatlly resume to playing your
music.
* Not all mobile phones support all the functions listed above. Please refer to your cell phone’s user manual.
Answering a phone call, short press the button. While on the call,
press the button to increase the volume, or press the button to
decrease the volume, and short press the button to end the call.
To mute the conversation, press the button for 2 seconds, to take
the call off mute, simply press the button again for 2 seconds.
To Voice Dial, simply short press the and button, and to redial the
last number double click the button.
The three buttons are:
Up/Volume +/Previous Track, etc
Down/Volume -/Forward Track, etc
Answer/End/Pair/Pause, etc
This process can be continued for up to 8 devices. Once the
phone/music device is paired, there will be no need to pair again; all that
is needed is that you select the headset from your phone or music
device.
To turn this feature this off, which is recommended if only using with
one Bluetooth device, press and hold the and buttons while in
standby mode until you hear four descending tones.
USER MANUAL
