Dimplex ELECTRALOG CFP3913 Manuel utilisateur
Owner’s Manual
Model
CFP3913
7209260100R04
IMPORTANT SAFETY INFORMATION: Always read this manual rst
before attempting to install or use this replace. For your safety, always
comply with all warnings and safety instructions contained in this manual
to prevent personal injury or property damage.
2 www.dimplex.com
Table of Contents
Always use a qualied technician
or service agency to repair
this replace.
!NOTE: Procedures and
techniques that are
considered important
enough to emphasize.
CAUTION: Procedures and
techniques which, if not
carefully followed, will result
in damage to the equipment.
WARNING: Procedures
and techniques which, if not
carefully followed, will expose
the user to the risk of re,
serious injury, or death.
Welcome & Congratulations . . . . . . . . . . . . . . . . .3
IMPORTANT INSTRUCTIONS ...............4
Fireplace Installation .......................7
Operation ................................8
Maintenance .............................9
Warranty ...............................11
Replacement Parts ........................14
3
Welcome & Congratulations
Thank you and congratulations for choosing to purchase an electric
replace from Dimplex, the world leader in electric replaces.
Please carefully read and save these instructions.
CAUTION: Read all instructions and warnings carefully before
starting installation. Failure to follow these instructions may result
in a possible electric shock, re hazard and will void the warranty.
Please record your model and serial numbers below for future
reference: model and serial numbers can be found on the Model and
Serial Number Label of your replace.
NO NEED TO RETURN TO THE STORE
Questions with operation or assembly? Require Parts Information?
Product Under Manufacturer’s Warranty?
Contact us at: www.dimplex.com/customer_support
For Troubleshooting and Technical Support
OR Toll-Free 1-888-DIMPLEX (1-888-346-7539)
Monday to Friday 8:00 a.m. to 4:30 p.m. EST
Please have your model number and product serial
number ready. (See above)
Model Number
Serial Number
4 www.dimplex.com
① Read all instructions before
using this appliance.
② The heater is hot when in use.
To avoid burns, do not let bare skin
touch hot surfaces. The trim around
the heater outlet becomes hot during
heater operation. Keep combustible
materials, such as furniture, pillows,
bedding, papers, clothes, and
curtains at least 3 feet (0.9 m) from
the front of the unit.
CAUTION: High temperature,
keep electrical cords, drapery, and
other furnishings at least three (3)
feet (0.9 m) from the front of the
heater and away from the side and
rear.
③ Extreme caution is necessary
when any heater is used by or near
children or invalids and whenever the
unit is left operating and unattended.
④ Always unplug the replace when
not in use.
⑤ Do not operate any unit with a
damaged cord or plug, or if the heater
has malfunctioned, or if the replace
has been dropped or damaged
in any manner. Return heater to
IMPORTANT INSTRUCTIONS
an authorized service facility for
examination, electrical or mechanical
adjustment, or repair.
⑥ Do not use outdoors.
⑦ The replace is not intended for
use in bathrooms, laundry areas and
similar indoor locations. Never locate
heater where it may fall into a bathtub
or other water container.
⑧Do not run the cord under
carpeting. Do not cover cord with
throw rugs, runners, or the like.
Arrange cord away from trafc area
and where it will not be tripped over.
⑨To disconnect the unit, turn the
controls off, then remove the plug
from the outlet.
⑩Do not insert or allow foreign
objects to enter any ventilation or
exhaust opening as this may cause
an electric shock or re, or damage to
the heater.
⑪ To prevent a possible re, do not
block air in take or exhaust in any
manner. Do not use on soft surfaces,
like a bed, where openings may
become blocked.
5
SAVE THESE INSTRUCTIONS
⑫ All electrical heaters have hot
and arching or sparking parts inside.
Do not use in areas where gasoline,
paint, or ammable liquids are used
or stored or where the unit will be
exposed to ammable vapors.
⑬Do not modify the replace. Use
it only as described in this manual.
Any other use not recommended by
the manufacturer may cause re,
electric shock or injury to persons.
⑭To reduce the risk of electric
shock, this appliance has a polarized
plug (one blade is wider than the
other). This plug will t in a polarized
outlet only one way. If the plug does
not t fully in the outlet, reverse the
plug. If it still does not t, contact
a qualied electrician to install the
proper outlet. Do not change the plug
in any way.
⑮ Avoid the use of an extension
cord. Extension cords may overheat
and cause a risk of re. If you must
use an extension cord, the cord must
be No. 14 AWG minimum size and
rated no less than 1875 Watts.
⑯ Do not burn wood or other
materials in the replace.
⑰Do not strike the clear door panel.
⑱ Always use a certied electrician
should new circuits or outlets be
required.
⑲ Always use properly grounded,
fused and polarized outlets.
⑳ Disconnect all power supply
before performing any cleaning,
maintenance or relocation of the unit.
㉑When transporting or storing the
unit and cord, keep in a dry place,
free from excessive vibration and
store so as to avoid damage.
IMPORTANT INSTRUCTIONS
6 www.dimplex.com
IMPORTANT INSTRUCTIONS
!NOTE: This equipment has
been tested and found to comply
with the limits for Class B digital
device, pursuant to part 15 of
the FCC Rules. These limits are
designed to provide reasonable
protection against harmful
interference in a residential
installation. This equipment
generates, uses and can radiate
radio frequency energy and, if not
installed and used in accordance
with the instructions, may cause
harmful interference to radio or
television reception, which can
be determined by turning the
equipment off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
Reorient or relocate the •
receiving antenna.
Increase the separation •
between the equipment and
the receiver.
Connect the equipment into •
an outlet on a circuit different
from that to which the
receiver is connected.
Consult the dealer or an•
experienced radio/TV
technician for help.
Operation is subject to the
following two conditions: (1)
this device may not cause
interference and (2) this device
must accept any interference,
including interference that may
cause undesired operation of the
device.
7
Fireplace Installation
!NOTE: A 15 Amp, 120 Volt
alternating current (VAC) circuit
is required. A dedicated circuit
is preferred but not essential in
all cases. A dedicated circuit will
be required if, after installation,
the circuit breaker trips or fuse
blows on a regular basis when the
heater is operating. Additional
appliances on the same circuit
may exceed the current rating of
the circuit breaker.
WARNING: Ensure the power
cord is not installed so that
it is pinched or against a
sharp edge and ensure that
the power cord is stored or
secured to avoid tripping or
snagging to reduce the risk of
re, electric shock or injury to
persons.
WARNING:Construction and
electrical outlet wiring must
comply with local building
codes and other applicable
regulations to reduce the risk
of re, electric shock and injury
to persons.
WARNING:Do not attempt
to wire your own new outlets
or circuits. To reduce
the risk of re, electric shock
or injury to persons, always
use a licensed electrician.
Make sure the unit’s Main 1.
ON/OFF Switch is switched
OFF (refer to operating
instruction section).
Plug the unit into a 152.
Amp/120 VAC outlet. If the
cord does not reach, you may
use an extension cord rated
for a minimum of 1875 Watts.
8 www.dimplex.com
Operation
Three switches provide a choice
of heat settings. A switch is in the
ON position when the side with
the markings on (i.e. I, II, or II) is
pushed in. (Figure 1)
Switch 1
(I) Manual mode: Controls the
electricity supply to the heater
and ame manually.
(II)Remote mode: Allows the
control of electricity supply to
the heater and ame through
the use of the supplied remote
control.
!NOTE: This switch must
be in either (I) or (II) to operate
with or without heat.
Switch 2 (I) Provides 715 Watt
heat output.
Switch 3 (II)Provides 1430 Watt
heat output with Switch 2.
Remote Operation
The replace is supplied with an
integral ON/OFF remote control.
!NOTE: Ensure that the
replace ON/OFF Switch is set to
the remote control setting (I.E.. II).
To operate: push ON button
to turn replace on; push OFF
button to turn replace off.
!NOTE: Remote control
operates main power supply.
Heat must still be controlled by
switches on replace.
Resetting The Tempera-
ture Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the
heater off and it will not come
back on without being reset. It
can be reset by switching the
Main ON/OFF Switch to OFF and
waiting ve (5) minutes before
switching the unit back on.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call customer
service at 1-888-346-7539.
Figure 1
3 2 1
9
Maintenance
WARNING: Always
disconnect from the power
supply before attempting any
maintenance.
Bulb Replacement
The bulbs are located behind the
back panel.
To gain access to the bulbs:
Remove the silver screw that 1.
secures the access panel to
the rebox as indicated in
Figure 2.
Remove and slide out panel.2.
Remove the defective lamp 3.
by unscrewing it as shown in
Figure 3.
Replace with a 60 Watt 4.
E12 clear chandelier or
candelabra. Take care not to
over-tighten the bulb.
Ret the access panel 5.
and secure with the screw
removed in step 1.
!NOTE: To remove the rebox
insert prior to repair, remove the
ve (5) black screws at the back
of the rebox as shown in Figure
2 and slide it out to the front.
Helpful Hints
It is a good idea to replace all
light bulbs at one time if they are
close to the end of their rated life.
Group replacement will reduce
the number of times you need
to open the unit to replace light
bulbs.
Cleaning
WARNING: Always
disconnect from the power
supply before cleaning the
replace.
For general cleaning use a
soft clean duster – never use
abrasive cleaners. The glass
viewing screen should be cleaned
carefully with a soft cloth. DO
NOT use glass cleaners.
To remove any accumulation
of dust or uff the soft brush
attachment of a vacuum cleaner
should occasionally be used to
clean the outlet grill of the fan
heater.
10 www.dimplex.com
Maintenance
Figure 2
Access
Panel
Screw
Firebox
Mounting
Screws (2)
Firebox
Mounting
Screws (3)
Figure 3
Bulbs
Autres manuels pour ELECTRALOG CFP3913
2
Ce manuel convient aux modèles suivants
3
Table des matières
Autres manuels Dimplex Cheminée intérieure
Dimplex
Dimplex Mini Mozart Deluxe Manuel utilisateur
Dimplex
Dimplex CAS400LNH-INT Manuel utilisateur
Dimplex
Dimplex Modini DEC20M Manuel utilisateur
Dimplex
Dimplex Figaro FGA15 Manuel utilisateur
Dimplex
Dimplex DF2426 Manuel utilisateur
Dimplex
Dimplex DIMPLEX ELECTRIC FIREPLACE Manuel utilisateur
Dimplex
Dimplex VF5452L Manuel utilisateur
Dimplex
Dimplex Romero de Luxe Manuel utilisateur
Dimplex
Dimplex SACRAMENTO SCR20 Manuel utilisateur
Dimplex
Dimplex DIMPLEX ELECTRIC FIREPLACE Manuel utilisateur
Dimplex
Dimplex Optiflame Toluca Deluxe TLC20LX Mode d’emploi
Dimplex
Dimplex Opti-Suite2Go2 Manuel utilisateur
Dimplex
Dimplex DF2624L Manuel utilisateur
Dimplex
Dimplex EWT SP16-LED Manuel utilisateur
Dimplex
Dimplex CDS6599 - Celeste Manuel utilisateur
Dimplex
Dimplex VIVALDI DE LUXE Manuel utilisateur
Dimplex
Dimplex DWF36-PG Manuel utilisateur
Dimplex
Dimplex BLF5051-AU/PRISM 50" Manuel utilisateur
Dimplex
Dimplex DCF44 Manuel utilisateur
Dimplex
Dimplex DFOP25 Manuel utilisateur
