Operators Manual
D3655-US
3
Press [On/Off].
A brief “HELLO” message will be displayed. The scale enters the
GROSS weighing mode.
GROSS mode displays the weight change since the unit was last
ZERO/BALANCED.
ZERO BALANCE THE SCALE
Press [Gross/Net] and within three seconds, press the [Zero] key.
“0” is displayed to show completion of the step and the scale is put in
the GROSS mode.
GROSS mode displays the weight change since the unit was last
ZERO/BALANCED.
The scale is in GROSS mode if there is a flashing arrow pointing toward
the GROSS text just above the [On/Off] key.
NET mode displays the weight change after a TARE has been
performed. TARE is a temporary “zero” point. The scale is in NET
mode if there is a flashing arrow near the NET text in the lower left
corner of the display.
On EZ 400 indicators with “Print” feature, press and hold the [print/tare]
button for 3 seconds to “Tare” the scale. Press the button momentarily
for “Print”.
[Gross/Net] is an alternating-action key. If the scale is in the GROSS
mode, press [Gross/Net] to place it in the NET mode. If the scale is in
the NET mode, press [Gross/Net] to place it in the GROSS mode.
!"
The SERIAL option allows “Print “ data from the EZ 400 to be
transferred to a Data-Down-Loader (DDL). This data can then be
transferred to a PC using a data cable and Data Transfer Utilities (DTU)
software provided with your DDL. See the DDL manual (PN D3564) for
further details.
1. Connect the DDL to the SERIAL port on the bottom panel of the
EZ 400.
2. Press [Print] while the DDL is connected to the SERIAL port.
