Diamond Engineering X0-90 Manuel de l'opérateur
X0-90 Elevation Stage
Installation and Conguration Guide
Table of Contents
OPT-X0-90 - Introduction ...............................................................................................................5
Elevation Stage Assembly - TOP MOUNT ..................................................................................6
Elevation Stage Assembly - SIDE MOUNT .................................................................................8
AUT mounting holes...........................................................................................................................10
Software and Controller Installation.............................................................................................12
Software Conguration .....................................................................................................................13
X0-90 Specications ..........................................................................................................................14
Part Drawings - Acrylic Bracket....................................................................................................15
Troubleshooting and Support Info................................................................................................16
http://www.DiamondEng.net · [email protected]
P.O. Box 2037 Diamond Springs, CA 95619 · 530-626-3857
5
Installation & Conguration X0-90 Elevation Stage
Overview
Option X0-90 provides +/- 90 degrees of elevation tilt for the x000 series turntable, this option
replaces the legacy +/- 45 degree tilt option. The stage is compatible with any DAMS Conroller and
software releases after November 2019. This option includes provisions for both “Top Mount” and
Side Mount congurations.
Package Contents
- X0-90 Elevation Stage
- Aluminum tripod mounting bracket
- Acrylic mounting plate for DAMS Turntable
- 4 x 1/4-20 x 1.25” black nylon thumb screws
- High capacity carbon ber tripod w/ adjustable neck.
OPT-X0-90 - Introduction
6
X0-90 Elevation Stage Installation & Conguration
Mounting
1. Expand Tripod Legs
2. Loosen Mounting Clamp (g.1)
3. Thread tripod bolt into aluminum stage bracket, orient so that the mount
can swing freely (g. 2)
4. mount the acrylic mount to the rotary stage using the 4 x 22mm M-6 Screws ,
5. Mount turntable to mount sing the 4 x 1/4-20 x 1.25” nylon thumb screws
6. Connect yellow cable with 9p DSUB connector to the rotary stage.
7. Connect other yellow cable with right angle to DAMS Turntable.
Elevation Stage Assembly - TOP MOUNT
7
Installation & Conguration X0-90 Elevation Stage
Elevation Stage Assembly - TOP MOUNT - Complete
8
X0-90 Elevation Stage Installation & Conguration
Mounting
A counterweight may be needed on the tripod legs or hung from tripod hook!
1. Expand Tripod Legs
2. Loosen Mounting Clamp and spin silver hub to thread into aluminum bracket (Fig. 1)
4. Mount the acrylic mount to the rotary stage using the 4 x 22mm M-6 Screws ,
5. Mount turntable to mount sing the 4 x 1/4-20 x 1.25” nylon thumb screws
6. Connect yellow cable with 9p DSUB connector to the rotary stage.
7. Connect other yellow cable with right angle to DAMS Turntable.
Elevation Stage Assembly - SIDE MOUNT
9
Installation & Conguration X0-90 Elevation Stage
Elevation Stage Assembly - SIDE MOUNT - Complete
10
X0-90 Elevation Stage Installation & Conguration
Table des matières
