Page 8
LAlways ensure that there is a suitable type re exnguisher available and is within easy
access.
MDO NOT leave an engine running unaended, ALWAYS STOP it before leaving the area as
thermal shock may occur if le on by-pass .
NNEVER point the high pressure spray jet at any person, animal, glass or other
Material which may shaer.
O PREVENT any over spray from injuring other people or damaging property.
PDO NOT even try to use a pressure washer on machinery or electrical equipment that is
connected in any way to the mains supply ( ALL switches in the OFF posion, pull out plugs,
if possible remove fuses). Cover or seal electric motors and ngs to prevent entry of
water. Before reconnecng electric mains supply check for water penetraon.
QDO ALL you can to keep plugs and sockets in a dry place or covered to prevent entry of
water.
RALWAYS when using this machine:-
• wear safety goggles and helmet or helmet with a visor.
•Wear waterproof clothing and gloves.
• Take parcular care with detergents and chemicals.
SNEVER aempt to disconnect any hose with pressure in it or allow the hose to be aened
or kinked.
TDO NOT use a high pressure hose from a ladder. Use a plaorm tower or proper
scaolding.
UShould the equipment fail to operate, DO NOT aempt to recfy or repair, but contact the
nearest Service Centre for advice.
V Always rinse your pump out aer using sea water.
WLeaving the pressure washer on by-pass for prolonged periods without operang the lance
will cause the water in the pump to heat up. This heat build up may damage the seals and
valves in the pump.
