5
Step 6
Apply the supporting pad.
Position and apply the adhesive
supporting pad (5).
LCD Display
• Height Adjustment:
• 1. Press the “ “ button, the desk will rise, press and hold and the
desk will continue to rise, the screen will show “top” when the
desktop is at it’s highest setting.
• 2. Press the “ “ button, the desk will descend, press and hold and
the desk will continue to descend, the screen will show “bot” when
the desktop is at it’s lowest setting.
• Memory Presets:
• 1. When the desktop is stationary at your rst desired height, press
and hold the preset button “1” for 3 seconds, the desk will sound
and the display will show “S-1”, this shows you have saved your 1st
position preset height. Press the “1” preset button at any time to
return to this height setting.
• 2. Repeat this process for presets “2”, “3” and “4” as explained in
point 1 to your preferred height settings.
• Reset Operation:
• 1. When the height of the device is incorrect on the display or an
error code appears, the device needs to be reset and corrected.
Press and hold button “3” and button “4” simultaneously for 3
seconds to enter the reset function.
• 2. The display will show “RST”, long press the “ “ button to reset
the control unit. When the desk descends to it’s lowest height the
desk will bounce upwards slightly and run until the display shows
“bot” the reset will now be complete.
Adjust anti-collision sensitivity
• 1. Long press the “ “ and “ “ buttons simultaneously for the 3
seconds to change the sensitivity settings. There are 4 possible
settings A-0, A-1, A-2 and A-3.
• 2. When the displays shows A-0 the desk anti collision setting is
OFF, A-3 is High sensitivity, A-2 Medium sensitivity and A-1 for Low
sensitivity. (factory default setting is A-2).
• 3. When the desk rises and descends it will rebound immediately
when it encounters an obstacle.
• Troubleshooting
• RESET: When the LED displays “RST” press the down button until
the desk reaches its lowest height and rebounds to stop. The reset
has completed.
• When the desk does not work and the LED shows “E01” or “E02”,
wait 18 minutes before trying to operate again.
• If the down button does not work, check the cable connections and
then turn the power off for at least 10 seconds. Turn on the power
and press the down button to start the RESET process when the
LED displays “RST”.
• If none of the above processes work please contact Dellonda
Customer Service.
Operation
