Dell Precision M4300 Manuel utilisateur

Dell™Precision™M4300ServiceManual

Notes, Notices, and Cautions

Information in this document is subject to change without notice.

©2007DellInc.Allrightsreserved.

Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.

Trademarks used in this text: Dell, the DELL logo, and Precision are trademarks of Dell Inc.; Bluetooth is a registered trademark owned by Bluetooth SIG, Inc. and is used by Dell

under license.

Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Dell Inc. disclaims any

proprietary interest in trademarks and trade names other than its own.

Model PP04X

June 2007 Rev. A00

Before You Begin

Internal Card with Bluetooth®Wireless Technology

Hard Drive

Memory

FCM (Flash Cache Module)

Coin-Cell Battery

Hinge Cover

Keyboard

Communications Cards

Using Cards

PC Card Reader

Display Assembly

Palm Rest

Fan

Processor Thermal-Cooling Assembly

Processor Module

System Board

Base

Modem

Battery Latch

Flashing the BIOS

Pin Assignments for I/O Connectors

NOTE: A NOTE indicates important information that helps you make better use of your computer.

NOTICE: A NOTICE indicates either potential damage to hardware or loss of data and tells you how to avoid the problem.

CAUTION: A CAUTION indicates a potential for property damage, personal injury, or death.

Back to Contents Page

Base

Dell™Precision™M4300ServiceManual



1. Follow the procedures in Before You Begin.



2. Remove the hard drive (see Hard Drive).



3. Remove the hinge cover (see Hinge Cover).



4. Remove the internal card with Bluetooth®wireless technology.



5. Remove the keyboard (see Keyboard).



6. Remove the display assembly (see Removing the Display Assembly).



7. Remove the palm rest (see Palm Rest).



8. Remove the processor thermal-cooling assembly (see Processor Thermal-Cooling Assembly).



9. Remove the processor (see Removing the Processor Module).



10. Remove the modem (see Modem).



11. Remove the fan (see Fan).



12. Remove the system board (see Removing the System Board).

Back to Contents Page



CAUTION: Before performing the following procedures, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of

the computer.

Back to Contents Page

Battery Latch

Dell™Precision™M4300ServiceManual



1. Follow the procedures in Before You Begin.



2. Remove the hard drive (see Hard Drive).



3. Remove the hinge cover (see Hinge Cover).



4. Remove the keyboard (see Keyboard).



5. Remove the display assembly (see Removing the Display Assembly).



6. Remove the palm rest (see Palm Rest).



7. Remove the processor thermal-cooling assembly (see Processor Thermal-Cooling Assembly).



8. Remove the system board (see Removing the System Board).



9. To remove the battery latch, use a plastic scribe or screwdriver to carefully dislodge the battery latch from the base, and lift the latch away.

Back to Contents Page



CAUTION: Before performing the following procedures, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of

the computer.

Back to Contents Page

Before You Begin

Dell™Precision™M4300ServiceManual

Recommended Tools

Turning Off Your Computer

Before Working Inside Your Computer

This chapter provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that the

following conditions exist:

lYou have performed the steps in Turning Off Your Computer and Before Working Inside Your Computer.

lYou have followed the safety information in the Product Information Guide.

lA component can be replaced by performing the removal procedure in reverse order.

Recommended Tools

The procedures in this document may require the following tools:

lSmall flat-blade screwdriver

lPhillips screwdriver

lSmall plastic scribe

lHex nut driver

lFlash BIOS-update program CD

Turning Off Your Computer



1. Shut down the operating system:

a. Save and close all open files and exit all open programs.

b. In the Microsoft®Windows®XP operating system, click Start®Shut Down®Shut down.

In Microsoft®WindowsVista™,click the Windows Vista Start button , click the arrow in the lower-right corner of the Start menu as shown

below, and then click Shut Down.

The computer turns off after the operating system shutdown process is complete.

Ensure that the computer and all attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut down

your operating system, press and hold the power button for about 4 seconds to turn them off.

Before Working Inside Your Computer

Use the following safety guidelines to help protect your computer from potential damage and to help ensure your own personal safety.



NOTICE: To avoid losing data, save and close any open files and exit any open programs before you turn off your computer.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

CAUTION: Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal

mounting bracket. Hold a component such as a processor by its edges, not by its pins.

NOTICE: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is not

covered by your warranty.

NOTICE: When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have a connector with locking tabs; if

you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep them evenly

aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented and aligned.

NOTICE: To avoid damaging the computer, perform the following steps before you begin working inside the computer.

1. Ensure that the work surface is flat and clean to prevent the computer cover from being scratched.



2. Turn off your computer (see Turning Off Your Computer).



3. Disconnect any telephone, network, and USB cables from the computer.



4. Disconnect your computer and all attached devices from their electrical outlets.



5. Turn over the computer.



6. Remove the battery.

a. Slide the battery-bay release latch on the bottom of the computer toward the back of the computer until the latch is engaged.

b. Grasp the battery by the battery tab and slide the battery horizontally toward the side of the computer.

c. Lift to remove the battery from the bay.



7. Press the power button to ground the system board.



8. Remove any installed ExpressCards, PC Cards, or smart cards from the computer Using Cards.

Back to Contents Page



NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.

NOTICE: To avoid damaging the system board, you must remove the main battery before you service the computer.

battery

battery-bay release latch



Back to Contents Page

Internal Card with Bluetooth®Wireless Technology

Dell™Precision™M4300ServiceManual

If you ordered an internal card with Bluetooth wireless technology with your computer, it is already installed.



1. Follow the procedures in Before You Begin.



2. Remove the hinge cover (see Hinge Cover).



3. Remove the card from its compartment in the computer.

a. Slide the card to the right.

b. Lift the card out of the computer.



4. Disconnect the card from the card cable connector.

Back to Contents Page



CAUTION: Before performing the following procedures, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of

the computer.

metal tab

card

card cable connector

NOTICE: Be careful when removing the card to avoid damaging the card, card cable, or surrounding components.

card

card connector

card cable connector

Back to Contents Page

Using Cards

Dell™Precision™M4300ServiceManual

Card Types

Card Blanks

Extended Cards

Installing a PC Card or ExpressCard

Removing a Card or Blank

Card Types

The PC Card slot has one connector that supports a single Type I or Type II card. The PC Card slot supports CardBus technology and extended PC Cards.

"Type" of card refers to its thickness, not its functionality.

The ExpressCard slot has one connector that supports 54-mm cards. The slot also supports adapters for 34-mm cards.

Card Blanks

Your computer shipped with a plastic blank installed in the card slots. Blanks protect unused slots from dust and other particles. Save the blank for use when

no PC Card is installed in the slot; blanks from other computers may not fit your computer.

To remove the blank, see Removing a Card or Blank.

Extended Cards

An extended card (for example, a wireless network adapter) is longer than a standard card and extends outside the computer. Follow these precautions when

using extended PC or ExpressCards:

lProtect the exposed end of an installed card. Striking the end of the card can damage the system board.

lAlways remove an extended card before you pack the computer in its carrying case.

Installing a PC Card or ExpressCard

You can install a PC Card or ExpressCard in the computer while the computer is running. The computer automatically detects the card.

Cards are generally marked with a symbol (such as a triangle or an arrow) to indicate which end to insert into the slot. The cards are keyed to prevent

incorrect insertion. If card orientation is not clear, see the documentation that came with the card.



PC Card



1. Hold the card with its orientation symbol pointing into the slot and the top side of the card facing up. The latch may need to be in the "in" position

before you insert the card.



2. Slide the card into the slot until the card is completely seated in its connector.

If you encounter too much resistance, do not force the card. Check the card orientation and try again.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTE: A PC Card is not a bootable device.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

The computer recognizes most cards and automatically loads the appropriate device driver. If the configuration program tells you to load the manufacturer's

drivers, use the floppy disk or CD that came with the PC Card.



ExpressCard



1. Hold the card with its orientation symbol pointing into the slot and the top side of the card facing up. The latch may need to be in the "in" position

before you insert the card.



2. Slide the card into the slot until the card is completely seated in its connector.

If you encounter too much resistance, do not force the card. Check the card orientation and try again.

The computer recognizes most cards and automatically loads the appropriate device driver. If the configuration program tells you to load the manufacturer's

drivers, use the floppy disk or CD that came with the card.

If you have an adapter, such as the one shown below, you can use 34-mm ExpressCards in the PC Card slot. For information about using the PC Card slot,

see PC Card.

Removing a Card or Blank

Press the latch and remove the card or blank. For some latches, you must press the latch twice: once to pop the latch out, and then a second time to pop the

card out.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in your Product Information Guide.

NOTICE: Click the icon (in the taskbar) to select a card and stop it from functioning before you remove it from the computer. If you do not stop the

card in the configuration utility, you could lose data. Do not attempt to eject a card by pulling its cable, if one is attached.

Back to Contents Page



Back to Contents Page

Coin-Cell Battery

Dell™Precision™M4300ServiceManual



1. Follow the procedures in Before You Begin.



2. Remove the memory module cover (see Memory).



3. Remove the coin-cell battery connector from the connector on the system board.



4. Slide the battery out of the plastic sleeve.

Back to Contents Page



CAUTION: Before performing the following procedures, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of

the computer.

plastic sleeve

coin-cell battery

coin-cell battery connector

connector on system board



Autres manuels pour Precision M4300

Table des matières

Autres manuels Dell Ordinateur portable

Dell

Dell Inspiron 11 3000 Series Manuel d'exploitation et d'entretien

Dell

Dell Latitude E6520 Manuel utilisateur

Dell

Dell Latitude 7290 Manuel utilisateur

Dell

Dell Inspiron 14 5415 Manuel d'exploitation et d'entretien

Dell

Dell Latitude D630 XFR Manuel utilisateur

Dell

Dell Vostro 3400 Manuel utilisateur

Dell

Dell XPS 15-7590 Manuel utilisateur

Dell

Dell Inspiron 1012 Manuel utilisateur

Dell

Dell G5 SE Manuel utilisateur

Dell

Dell Inspiron 14Z 5423 Manuel utilisateur

Dell

Dell Latitude 5400 Chrome Manuel utilisateur

Dell

Dell Inspiron 5409 Manuel d'exploitation et d'entretien

Dell

Dell Inspiron 17 5000 Series Manuel utilisateur

Dell

Dell Latitude 7640 Manuel utilisateur

Dell

Dell NOT22360 Manuel utilisateur

Dell

Dell Latitude 3440 Manuel du propriétaire

Dell

Dell Latitude D505 Series Manuel utilisateur

Dell

Dell Inspiron 3595 Manuel d'exploitation et d'entretien

Dell

Dell Inspiron 15 3000 Series Manuel utilisateur

Dell

Dell Inspiron 2500 Mode d’emploi

Dell

Dell Latitude X1 Manuel utilisateur

Dell

Dell Alienware x17 R1 Manuel utilisateur

Dell

Dell Precision M3800 Manuel utilisateur

Dell

Dell Latitude 4310 Manuel du propriétaire

Manuels Ordinateur portable populaires d'autres marques

HP ze2401xt - Pavilion Notebook PC Manuel utilisateur

Velocity

Velocity NoteMagix M10 Manuel utilisateur

Toshiba

Toshiba A105-S2236 Manuel utilisateur

HP ENVY 17 Manuel

Winbook

Winbook LM Manuel utilisateur

HP PROBOOK 4520S Manuel

Sony

Sony VAIO PCG-FX270 Manuel utilisateur

Sony

Sony VAIO PCG-R505JLK Manuel utilisateur

Lenovo

Lenovo THINKPAD X32 Manuel utilisateur

HP Compaq tc4200 Guide de démarrage rapide

Toshiba

Toshiba mini NB300 Manuel utilisateur

Lenovo

Lenovo ThinkPad X201 Tablet Manuel

Lenovo

Lenovo THINKPAD X31 Manuel

Sony

Sony VGN-T240P VAIO Manuel utilisateur

Compaq

Compaq Armada E700 Series Manuel utilisateur

Fujitsu

Fujitsu Lifebook A6230 Manuel utilisateur

Acer

Acer Aspire ONE 722 Manuel utilisateur

Toshiba

Toshiba L300-EZ1524 Manuel utilisateur