iv FP-775S User's Manual
■Do not press the screen's touch surface too strongly with either your finger or a hard
object, since the touch surface may be damaged.
■ Do not press on the touch panel's face with sharp objects, such as a mechanical pencil
or a screwdriver, since it can damage the panel surface.
■ When the surface of the display screen becomes dirty or smudged, clean the display
with a cloth soaked in a neutral detergent. Do not use paint thinner or organic solvent.
■ Avoidusingorstoring the FP in direct sunlight,excessivelydusty or dirty environments,
or where chemicals or their vapors are present in the air.
■ Please avoid using the FP in areas where sudden, large changes in temperature may
occur. These changes can cause condensation to form inside the unit, possibly causing
an accident.
■ Avoid restricting the FP's natural ventilation, or storing and using the FP in an
environment that will raise the FP's internal temperature above its designated limits.
■ DonotuseorstoretheFPin areas where chemicalvaporsarepresent or where chemicals
may come into contact the unit.
Notes on the FP's Liquid Crystal Display (LCD)
■ Depending on the type of information being displayed on the FP's screen, or the current
contrast setting, subtle variations in brightness may appear. This phenomenon is a
common attribute of LCD's and is not a defect.
■ There are minute grid-points on the LCD surface. These points are not defects.
■ Occasionally crosstalk (shadows appearing on extended display lines) will appear on
the display. This phenomenon is a common attribute of LCD's and is not a defect.
■ The displayed color will look different when viewed from an angle outside the speci-
fied view angle. This phenomenon is a common attribute of LCD's and is not a defect.
■ Displaying a single screen image for long periods of time can cause an afterimage to remain
onthe screen. To correct this, turntheunitOFFfor a short period(5to10minutes), then ON
again. This phenomenon is a common attribute of the LCDs, and not a defect. To prevent
the creation of an afterimage, you can change the screen display periodically to prevent the
displaying of a single image for a long period of time.
When the FP's Liquid Crystal Display (LCD) is Damaged
"If the FP's display is damaged or cracked, be sure to avoid any contact with the
display's internal liquid.
"If any part of the user's clothing or body comes in contact with the damaged/
cracked FP display's internal liquid, be sure to wash that area immediately with
detergent and water. If this liquid enter's the user's eye, be sure to flush with
water immediately and see a doctor.
"Do not inhale any of the damaged/cracked FP display's fumes.
"Dispose of the damaged/cracked FP display in accordance with your local
area's toxic material disposal regulations.
For the correct use of this unit, please follow these guidelines:
Safety Instructions
Caution
!!
!!
!
