De Agostini Model Space T-72 Manuel utilisateur

BUILD AND DRIVE THE RADIO-CONTROLLED MODEL

№ 8 SCALE 1:16

CONTENTS

Editorial and design by Continuo Creative, 39-41 North Road, London N7 9DP.

Published in the UK by De Agostini UK Ltd, Battersea Studios 2, 82 Silverthorne Road, London SW8 3HE.

Published in the USA by De Agostini Publishing USA, Inc.121 E. Calhoun Street, Woodstock, IL 60098

Warning: Not suitable for children under the age of 14.

is product is not a toy and is not designed or intended for use in play.

Items may vary from those shown.

STAGE PAGE

39 The gun barrel rotor 93

40 The track 95

41 The tank rear 97

42 The fuel drum brackets and idler wheels 99

43 The second external fuel drum and track 101

44 The lower front panel and track 103

T-72 TANK: STAGE

PARTS

1. Gun barrel rotor

2. Screws

For this stage, you will need the gun barrel rotor,

the turret, the gun barrel, the spring, screws and

a screwdriver.

THE GUN BARREL ROTOR

With this stage, you receive the electric rotor that will enable you to adjust the height

of the gun. It is a key component of the combat system of your T-72.

Align the holes in the side of the rotor

with the circled posts on the underside

of the turret.

Lower the rotor into place. Insert the three screws received with this

stage into the three holes in the rotor.

Tighten the screw at the rear into place.

Insert the tab at the rear of the recoil

mechanism into the hole in the front of

the rotor.

Then tighten the other two screws into place.

The spring will hold the recoil mechanism

away from the turret until it is fitted to

the base. Here, you can see where the

two posts on the side of the mechanism

(arrowed) engage with the turret.

Place the spring over the raised circular

projection in the centre of the turret.

This stage is now complete.

2 3 4

5 6

108

T-72 TANK: STAGE

PARTS

For this stage, you will need the new treads and pins, the track that you’ve

already assembled, and a wooden board and hammer.

Push a pin into the aligned holes of

both treads.

Combine two treads.

1. Cable K

2. Cable L

3. Cable S

4. Cable F

5. Treads (5 pcs)

6. Pins (5 pcs)

THE TRACK

In this stage, you receive four cables for the electronic system of your T-72, and

more pins and treads. The wires are used in a later stage. In this stage, you will be

assembling more track treads.

Place the track on its side on the wooden

board, and hammer the pin into place.

Engage the next tread with the assembled

pieces, and pass a pin through the holes.

Place the track on its side, and hammer the

pin into place.

Always remember to test that the pins are

unobstructed in the tread holes. Fit the

remaining pins and treads together.

Engage the new section with the existing

longer section.

Hammer the pins into the treads.

Hammer a pin through the aligned holes.

Place the assembled sections together and

join with a pin.

This stage is now complete.

4 5 6

7 8

1210

T-72 TANK: STAGE

PARTS

Place the two spare treads onto the outside

of the rear panel.

For this stage, you will need the lower hull,

the rear panel, the log, spare treads, screws

and a screwdriver.

1. Rear panel

2. Spare treads (2 pcs)

3. Screws

4. Pins (5 pcs)

5. Treads (5 pcs)

6. Log

THE TANK REAR

With this stage, you receive the rear tank panel, the log that would have been used

to get the tank out of mud, plus some screws, pins and treads. The panel and the log

will ﬁt to the lower hull, which you will receive with Stage 60, so keep these parts to

one side for the moment, and refer back to this stage when you ﬁt them.

Tighten a screw into the circled hole. Tighten the second screw into the other

hole (circled).

Insert the two posts on the panel into the

arrowed holes in the rear of the lower hull.

Push the posts into the holes.

Insert the two posts on the log into the

holes in the rear panel.

Insert a screw into each of the circled holes.

Tighten a screw into each of the two

circled holes.

Tighten the two screws into place.

This stage is now complete.

3 4 5

6 7

119

T-72 TANK: STAGE

PARTS

Fit the two green brackets into the right of

the lower hull.

For this stage, you will need a screwdriver,

the brackets, the idler wheels and parts, and

the lower hull.

Take the two yellow brackets and fit

them to the left of the rear of the lower

hull, as shown.

1. Brackets (4 pcs)

2. Pins (5 pcs)

3. Treads (5 pcs)

THE FUEL DRUM BRACKETS AND

IDLER WHEELS

With this stage, you receive four brackets for mounting the external fuel drums at the

rear of the tank, as well as more treads and pins. You will ﬁt the brackets and the two

idler wheels (Stages 5 and 27) to the lower hull.

100

Place the bearing from one of the idler

wheels onto the axle at the front of the hull.

Insert the bolt into the centre of the

idler wheel.

Test-fit the washer on the bolt.

Pass the bolt through the bearing, and

place the washer onto the end of it.

Holding the nut with one hand, tighten the

bolt with a screwdriver.

Then place the split washer onto the end of

the bolt.

Place the hub cap into the hole in the wheel.

Tighten the nut, by hand, onto the end of

the bolt.

Repeat Steps 4-11 on the other side of the

lower hull. This stage is now complete.

4 5 6

7 8

1210

Autres manuels pour Model Space T-72

Table des matières

Autres manuels De Agostini Jouet

De Agostini

De Agostini Model Space T-72 Manuel utilisateur

De Agostini

De Agostini MODEL SPACE Soleil Royal Manuel utilisateur

De Agostini

De Agostini Model Space MiG-29 Manuel utilisateur

De Agostini

De Agostini Model Space T-72 Manuel utilisateur

De Agostini

De Agostini MODEL SPACE Honda CB750 FOUR Manuel utilisateur

De Agostini

De Agostini Model Space MiG-29 Manuel utilisateur

De Agostini

De Agostini Model Space T-72 Manuel utilisateur

De Agostini

De Agostini Millennium Falcon 3 Series Manuel utilisateur

De Agostini

De Agostini MODEL SPACE SUZUKI GSX 1300R HAYABUSA Manuel utilisateur

De Agostini

De Agostini MODEL SPACE Honda CB750 FOUR Manuel utilisateur

De Agostini

De Agostini Model Space D51 200 Manuel utilisateur

De Agostini

De Agostini MODEL SPACE Honda CB750 FOUR Manuel utilisateur

De Agostini

De Agostini Model Space SANTISIMA TRINIDAD Manuel utilisateur

De Agostini

De Agostini Model Space Harley-Davidson FLSTF Fat Boy Manuel utilisateur

De Agostini

De Agostini Model Space T-72 Manuel utilisateur

De Agostini

De Agostini Model Space MiG-29 Manuel utilisateur

De Agostini

De Agostini Model Space C57 Manuel utilisateur

De Agostini

De Agostini Model Space H.M.S. Bounty Admiralty Manuel utilisateur

De Agostini

De Agostini MODEL SPACE Honda CB750 FOUR Manuel utilisateur

De Agostini

De Agostini Model Space MiG-29 Manuel utilisateur

De Agostini

De Agostini Model Space IJN Akagi Manuel utilisateur

De Agostini

De Agostini Model Space T-72 Manuel utilisateur

De Agostini

De Agostini Model Space MiG-29 Manuel utilisateur

De Agostini

De Agostini Model Space C57 Manuel utilisateur

Manuels Jouet populaires d'autres marques

marklin

marklin 37321 Manuel utilisateur

Canon

Canon PAPER CRAFT Manuel utilisateur

GREAT PLANES

GREAT PLANES Pitts M-12S Manuel utilisateur

NOCH

NOCH 14261 Manuel utilisateur

Hausler

Hausler 450 SE V2 Manuel utilisateur

Dynaflite

Dynaflite Daydream Manuel utilisateur

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Manuel

Kenner

Kenner Batman 63651 Manuel utilisateur

LEGO

LEGO 8527 Manuel utilisateur

iKarus

iKarus ECO 8 Manuel utilisateur

Multiplex

Multiplex EasyStar II Mode d’emploi

Walkera

Walkera 38 Mode d’emploi

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Manuel utilisateur

MD MXION SWD Manuel utilisateur

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Manuel utilisateur

marklin

marklin 39671 Manuel utilisateur

Meccano

Meccano 15103 Manuel utilisateur

LEGO

LEGO TECHNIC 8735 Manuel utilisateur